Search: Posts Made By: jeweler
Showing results 1 to 25 of 200
Search took 0.02 seconds.
10-27-22, 07:42 AM
Replies: 10
Views: 351
Posted By jeweler

When we had bird feeders I found several caches...

When we had bird feeders I found several caches of seed in our crawl space.
10-19-22, 07:17 AM
Replies: 5
Views: 178
Posted By jeweler

If you are comfortable driving a stick shift that...

If you are comfortable driving a stick shift that is likely the better choice. I know nothing about which has a better resale value. Those old VWs had small engines. I would not further burden it...
Replies: 3
Views: 96
Posted By jeweler

That’s what I needed to know. Thanks

That’s what I needed to know. Thanks
Replies: 3
Views: 96
Posted By jeweler

Medium duty garage shelving

I want to install 12” deep by 8’ long shelves in my garage. Have heavy duty brackets mounted to wall studs every 16”. Will 3/4” plywood be sufficient? I just want to be able to rip a 4x8’sheet into...
Replies: 5
Views: 149
Posted By jeweler

Just replaced the blower wheel for same reason....

Just replaced the blower wheel for same reason. Simple job. Cost less than $10.
Replies: 5
Views: 252
Posted By jeweler

It could be the valve solenoid sends water but...

It could be the valve solenoid sends water but there is a leak before it reaches the dispenser. Roll the fridge forward watching you don’t move it beyond the length of the supply line. Then watch...
09-20-22, 07:16 AM
Replies: 6
Views: 191
Posted By jeweler

You could apply electric heat tape to the water...

You could apply electric heat tape to the water pipes you are concerned about. Get tape that turns on at a set temp. Go about your insulation project, the tape is cheap insurance in the event your...
Replies: 15
Views: 250
Posted By jeweler

That valve is located inside the frig behind a...

That valve is located inside the frig behind a panel. On the back of the frig at the bottom is a single valve. I saw it and tested it. Look on the parts list at partselect.com. The exploded view...
Replies: 15
Views: 250
Posted By jeweler

Yes, I suspect a valve leak. Just not sure when...

Yes, I suspect a valve leak. Just not sure when it leaks. Currently all is good. Ice level bail is properly attached. I am assuming the leak was a result of water and ice maker being shut for a...
Replies: 15
Views: 250
Posted By jeweler

Working fine finally

I shortened fill time adjusting a half turn at a time. After 3 full turns it was still creating an ice blob in the bin. Less than before but no sign of stopping. Removed ice maker and found the fill...
Replies: 15
Views: 250
Posted By jeweler

Pjmax you are my hero. Worth much more than we...

Pjmax you are my hero. Worth much more than we are paying you. I had looked on the original ice maker (I kept it for parts) no adjustment screw. Then, after your post I took the cover off the unit...
Replies: 15
Views: 250
Posted By jeweler

The front panel on the frig has a read out that...

The front panel on the frig has a read out that allows turning off the icemaker. I do that before leaving town along with emptying the bin and shutting off the home water supply. Had a melt down of...
Replies: 15
Views: 250
Posted By jeweler

I wish mine had that adjustment. It is the type...

I wish mine had that adjustment. It is the type with several holes with Letters identifying them. They are test points, but no adjustment wheel. Looking at the cubes, they are a bit larger than...
Replies: 15
Views: 250
Posted By jeweler

On city water. Have a water pressure monitor and...

On city water. Have a water pressure monitor and it hovers in low to mid 50s. Spoke to the ice maker parts supplier. They are sending a replacement. Said it was likely the problem. Didn’t think water...
Replies: 15
Views: 250
Posted By jeweler

water overfilling ice tray

Whirlpool GZ25FSRXYY2 refrigerator ice maker was turned off for two weeks then upon turning back on it is making and harvesting ice cubes but the ice storage bin has a new accumulation of solid ice. ...
08-24-22, 04:43 PM
Replies: 8
Views: 200
Posted By jeweler

Do you know what is directly behind the Hardy...

Do you know what is directly behind the Hardy board? I would suspect a leak around a window. If they left off the wrap then I wonder what they did to seal the windows.
Replies: 2
Views: 209
Posted By jeweler

There may be a shear pin or similar that connects...

There may be a shear pin or similar that connects the motor drive to the chain. It may have broken, which is the clicking sound. Did you disconnect the door from the drive and try opening it...
Replies: 1
Views: 124
Posted By jeweler

Maytag fridge ice cubes melting

Friend’s Maytag model MFI2067AEQ makes ice cubes fine, but they melt in the storage compartment. Does this mean it is a cooling distribution issue and not and ice cube make issue? What do you...
08-03-22, 07:35 AM
Replies: 3
Views: 270
Posted By jeweler

We installed Flo by Moen three years ago. It...

We installed Flo by Moen three years ago. It watches and measures all water use in the home. It sends an email weekly with prior weeks usage. It will shut off water if it detects a leak. Will also...
Replies: 10
Views: 348
Posted By jeweler

https://backyardables.com/top-3-ways-to-set-a-post...

https://backyardables.com/top-3-ways-to-set-a-post-without-concrete/
...
07-18-22, 09:25 AM
Replies: 8
Views: 318
Posted By jeweler

Beware of the Carrier brand. We had one installed...

Beware of the Carrier brand. We had one installed 4 years ago. Had questions about how it was not keeping a continuous temperature in the room. The installer blew us off. We contacted Carrier and...
Replies: 3
Views: 180
Posted By jeweler

First the disclaimer, I am not a roofer nor a...

First the disclaimer, I am not a roofer nor a builder, just a DIY. This roof pitch appears too shallow for that style of metal roofing. I would guess even the unseated cabin retains enough solar gain...
Replies: 12
Views: 305
Posted By jeweler

There should be notches at the back of the drawer...

There should be notches at the back of the drawer for one of the rods you show in front. Then you select one of the remaining notches in the front depending on the size of Pendaflex style file...
06-22-22, 06:32 AM
Replies: 8
Views: 368
Posted By jeweler

Are these pans required by code? I use those...

Are these pans required by code? I use those electronic leak sensors that turn off the laundry faucets. Never had a leak so don’t know that they really work. I’ve tested with dropping the sensor...
Replies: 5
Views: 226
Posted By jeweler

Another option to consider is Swanstone. It is a...

Another option to consider is Swanstone. It is a manufactured solid surface wall system similar to Corian. I did both a shower and a bathtub shower as DIY projects. It is more costly than the modular...
Showing results 1 to 25 of 200
 


 
Forum Jump