Search: Posts Made By: martah
Showing results 1 to 15 of 15
Search took 0.01 seconds.
04-08-07, 05:38 PM
Replies: 2
Views: 1,100
Posted By martah

ceiling fan

yes, also remember that most remotes have codes that need to be set the same as the receiver that goes in the fan.
03-23-07, 06:50 PM
Replies: 12
Views: 5,740
Posted By martah

bulbs?

does the door slam when being closed?.............and if so,,is it close to the light fixture?
12-26-06, 04:32 PM
Replies: 7
Views: 1,171
Posted By martah

pool pump circuit

howdy, can uf wire be ran underground and out to an above ground pool pump? thought i seen something in code book that says it can not. then what do ya do? ...all thwn wire in pvc conduit..? ...
12-22-06, 08:46 AM
Replies: 21
Views: 1,733
Posted By martah

under-the-cabinet low voltage buck lighting

what are some of the ways to wire these kind of lights? location for transformer???? what special type wire to run inside walls? better to run from transformer to each light...or...from light to...
12-22-06, 08:24 AM
Replies: 4
Views: 1,145
Posted By martah

3 way switches

howdy, i am so used to our area codes. we can not use 14 gauge wire for any thing. must be 12 gauge or bigger, hope you got it solved. marty
12-21-06, 02:54 PM
Replies: 13
Views: 2,860
Posted By martah

200 amp panel

thnaks for the reply. the 400 amp service will have the dual lug kits installed and the one 200 amp panel installed below meter in basement and the other panel will be fed from a 200 amp disconnect...
12-21-06, 02:49 PM
Replies: 4
Views: 1,145
Posted By martah

3 way

you can't. there are four ways to wire a three way switch. hot to one switch and then 12-3 to other switch and then 12-2 from there to load. or. hot to switch and then 12-3 to light and then...
12-21-06, 01:31 PM
Replies: 3
Views: 1,470
Posted By martah

subpanel

check local codes if you can even use aluminum wiring. we can not use anything but copper, regardless of where/how it is ran... marty
12-21-06, 01:17 PM
Replies: 13
Views: 2,860
Posted By martah

200 amp service

howdy, thanks for the reply.... the load would be just a guess. it is like a new service for a new house....but for this house, it is just half the house...the other half will have another 200...
12-21-06, 12:45 PM
Replies: 7
Views: 1,628
Posted By martah

distance of 20 amp circuit

howdy...was wondering what most of the pros use when running new circuits to a kitchen that is 65-75 feet feet from service panel....microwave oven? dishwaher? kitchen counter circuits? do you...
12-21-06, 12:32 PM
Replies: 8
Views: 1,302
Posted By martah

must run new range four wire if it is three...

must run new range four wire if it is three wire....attic okay as long as you can get to it....make garbage dispoasl 15 amp #14 gauge wire if local code allows 14....put microwave,,,regardless of...
12-21-06, 12:10 PM
Replies: 8
Views: 1,731
Posted By martah

howdy....gfci protection is required in all...

howdy....gfci protection is required in all receptacles in unfinished basemnts....the breaker will work...but you must put the gfci protected labels on the protected outlets....they stick on and...
12-21-06, 12:00 PM
Replies: 13
Views: 2,860
Posted By martah

200 amp service 80 feet inside new home

howdy. installing 400 amp service with two 200 amp panels. one panel below meter in basement...and the other to run from 200 amp disconnect below meter by other panel,,, about 80 feet into the...
12-21-06, 11:56 AM
Replies: 5
Views: 5,641
Posted By martah

howdy, use a 30 a breaker 2-pole breaker at main...

howdy, use a 30 a breaker 2-pole breaker at main panel.and at sub panel...back feed breaker will do.....,,,,,limit outlets total amp take, at sub panel...,,,,add ground rod at garage....float...
12-19-06, 04:32 PM
Replies: 3
Views: 1,463
Posted By martah

closet light

closet lights must be totaly protected from the bulb getting broke. get light fixture that how a globe that goes around the bulbs, glass, plastic..etc. if the light is mounted on ceiling and at...
Showing results 1 to 15 of 15


 
Forum Jump