Search: Posts Made By: gt5oh
Showing results 1 to 25 of 103
Search took 0.01 seconds.
11-21-22, 05:44 PM
Replies: 7
Views: 151
Posted By gt5oh

I have a mix of yellow romex and white romex...

I have a mix of yellow romex and white romex downstream from the breaker, would that cause it?
11-21-22, 07:49 AM
Replies: 7
Views: 151
Posted By gt5oh

Ok. I will double check again and verify.

Ok. I will double check again and verify.
11-20-22, 10:46 PM
Replies: 7
Views: 151
Posted By gt5oh

New dual AFCI/GFCI 20 amp breaker sparked

I have a subpanel in my garage and wanted to replace a regular 20 amp Siemens breaker with a dual function AFCI/GFCI 20 amp Siemens breaker.
I took the old one out, and put the new one in. I ran the...
Replies: 13
Views: 433
Posted By gt5oh

Thanks everyone I will try to answer all. ...

Thanks everyone I will try to answer all.

Its a fairly new build home, major city water. All pex piping in the house. DHW side in the heat exchanger recently flushed. The Navien has a built in...
Replies: 13
Views: 433
Posted By gt5oh

rbeck, if it was broken wouldn't there be an...

rbeck, if it was broken wouldn't there be an error on the navien screen? I am not getting any codes.

I think the reason the icon was not going away while the DHW faucet was open was because the...
Replies: 13
Views: 433
Posted By gt5oh

Yes was working at 1.2 GPM. Cant figure out why...

Yes was working at 1.2 GPM. Cant figure out why my faucets are pulling in such low GPM when they are rated for much higher. I took out the aerator in one of the faucets and tested the flow at the...
Replies: 13
Views: 433
Posted By gt5oh

Yes on the Navien unit the flow is coming in at...

Yes on the Navien unit the flow is coming in at 0.6 GPM for one of the faucets, even though the faucet is rated for 1.2 GPM. The issue is the Navien unit only heats up is flow is 0.6 GPM or more so...
Replies: 13
Views: 433
Posted By gt5oh

Plumbers seem to think its a flow issue. Faucet...

Plumbers seem to think its a flow issue. Faucet is hitting 0.6 GPM. Navien unit minimum flow is between 0.5-0.6 GPM. If the flow is too low the boiler won't kick on to heat.
Replies: 13
Views: 433
Posted By gt5oh

Exclamation Navien NCB-240E Combi-boiler ignite issue

I have a Navien NCB 240E combi-boiler set up for hydro space heating and domestic hot water (installed 2019) I am having an ongoing issue and can't figure it out. My domestic hot water side is set to...
Replies: 4
Views: 406
Posted By gt5oh

That might be a good idea. I was thinking of...

That might be a good idea. I was thinking of taking the toe kick off and filling it with foam or some sort of insulation.

I really think the issue is where the drywall meets the tile floors. I...
Replies: 4
Views: 406
Posted By gt5oh

Question How to get behind finished kitchen cabinets to seal air leak??

Hello all. I noticed I have a bad air leak somewhere behind my lower kitchen cabinets. My guess is where the tile floor meets the drywall wasn't properly air sealed and the cold air is coming in and...
Replies: 1
Views: 432
Posted By gt5oh

Is the pex cold line in the line that feeds the...

Is the pex cold line in the line that feeds the closed loop space heating side of the boiler? If so, is the system smart enough to auto-fill that loop as needed or is that line always open?
Replies: 1
Views: 432
Posted By gt5oh

Navien Combi boiler flush question

Hello, I am preparing to do a flush of my Navien NCB-240E combi boiler. I have it connected to a hydro air handler on the space heating closed loop side but for now I am only going to flush the...
03-11-21, 08:52 PM
Replies: 12
Views: 1,427
Posted By gt5oh

I sealed most of that already, but one of the...

I sealed most of that already, but one of the conduits leads to a sub panel in a unattached garage, its goes underground then comes up and goes into my basement. the LB conduit brings it into the...
03-10-21, 10:07 PM
Replies: 12
Views: 1,427
Posted By gt5oh

Thank you, and can I use Duct Seal inside a Type...

Thank you, and can I use Duct Seal inside a Type LB conduit like this? https://www.garvinindustries.com/media/catalog/product/cache/e3071c46933876f069e6f41909777634/l/b/lb100_inuse2.jpg

Would I...
03-10-21, 04:20 PM
Replies: 12
Views: 1,427
Posted By gt5oh

Can you spray foam around orange romex cable? I...

Can you spray foam around orange romex cable? I have a orange romex coming through a hole in the wall for a generator plug and was wondering what to fill the hole with.

Is great stuff spray foam...
03-09-21, 05:02 PM
Replies: 12
Views: 1,427
Posted By gt5oh

thanks guys, appreciate the feedback

thanks guys, appreciate the feedback
03-09-21, 12:53 PM
Replies: 12
Views: 1,427
Posted By gt5oh

joed - Can I shove duct seal into the area where...

joed - Can I shove duct seal into the area where the wires come into the house and then split off into the electrical panel. Its like a rubber coating conduit with all the wires inside and thats...
03-09-21, 08:13 AM
Replies: 12
Views: 1,427
Posted By gt5oh

Question Cold air coming in from electric meter to electrical panel

We have above ground electric service wires and the service wire feeds into the weatherhead, then into the service mast, then into the electric meter and finally down into the basement to the...
11-10-20, 08:35 PM
Replies: 6
Views: 1,658
Posted By gt5oh

Thanks Hey Casualjoe, he can't recall. Wired...

Thanks

Hey Casualjoe, he can't recall. Wired the house about 7 months ago pre covid and has done a lot of jobs since then. I have been using a battery powered doorbell cam since then but now want...
11-09-20, 07:43 PM
Replies: 6
Views: 1,658
Posted By gt5oh

Question Possible to detect low voltage wire through vinyl siding?

My contractor can't recall if the electrician ran a low voltage wire near the front door and we think the siding guys may have installed the siding and covered it up without pulling the wire through....
10-25-20, 04:23 PM
Replies: 9
Views: 2,313
Posted By gt5oh

Thanks Steve - agree, but we just finished...

Thanks

Steve - agree, but we just finished everything down there, paint, moved in all the furniture, its all done and finished. just sucks that we might have to start cutting holes and poking...
10-24-20, 03:56 PM
Replies: 9
Views: 2,313
Posted By gt5oh

Marq1 - We finished the basement during the reno...

Marq1 - We finished the basement during the reno and I am really reluctant to start cutting up the ceiling to get under the drain.

Pilot Dane - What is the difference between a tub drain and a...
10-23-20, 08:41 PM
Replies: 9
Views: 2,313
Posted By gt5oh

Question Did plumber install this upside down?

We had a major renovation done and the plumber installed a new first floor bathroom with stand up shower. The shower has a center floor drain. Shortly after moving in we started getting a sewer gas...
Replies: 26
Views: 1,814
Posted By gt5oh

Thanks, whats your thoughts on the mismatched...

Thanks, whats your thoughts on the mismatched condenser and air handler?

How do I know if the York condenser Model # YCD30B22S and the ADP B Series Hydronic Air Handler Model # BCRMA3624S3N3 are...
Showing results 1 to 25 of 103
 


 
Forum Jump