Search: Posts Made By: visoredge
Showing results 1 to 11 of 11
Search took 0.01 seconds.
Replies: 18
Views: 43,073
Posted By visoredge

Guess I'll make a few phone calls before going...

Guess I'll make a few phone calls before going shopping!
Thanks for all your help!
Replies: 18
Views: 43,073
Posted By visoredge

I did try turning off the breaker (even left it...

I did try turning off the breaker (even left it off for a day) but that didn't do anything.

I am just about ready to go shopping for a new dishwasher.

I think it'll be $70 for a repair guy to...
Replies: 18
Views: 43,073
Posted By visoredge

You can see pics on flickr ...

You can see pics on flickr
http://www.flickr.com/photos/kenfused/

the start button is "good" when using my ohmmeter on the ribbon connector per the wiring diagram, but the control board doesn't...
Replies: 3
Views: 4,217
Posted By visoredge

If you have a lot of water (like it sounds you...

If you have a lot of water (like it sounds you do)
it WILL kick on say every 20 minutes. since it takes time for water to seep through the ground to fill the sump pit.

If they installed it right,...
Replies: 3
Views: 4,217
Posted By visoredge

I feel your pain. I had the same problem 2 years...

I feel your pain. I had the same problem 2 years ago.

Your sump pump should be getting water from holes in the circular pipe drilled into it. Water will slowly seep in and fill the pipe then get...
Replies: 18
Views: 43,073
Posted By visoredge

THanks for the continued help. I don't have...

THanks for the continued help.
I don't have true "buttons" (if you go to partselect.com and search MDBF550AWW as a model # you'll see what I mean)

I have those "membrane switch" buttons, little...
Replies: 18
Views: 43,073
Posted By visoredge

Oh, BTW I was using a digital multimeter, not...

Oh, BTW I was using a digital multimeter, not analog...

After further testing, I was doing it wrong...

Appears that both door switches are good (the latch has one switch on each side.)

What...
Replies: 18
Views: 43,073
Posted By visoredge

There's no dial, all push buttons on the front....

There's no dial,
all push buttons on the front.

On the left to right

HEAVY NORMAL RINSE then the Start/Cancel button, then on the right options for extra rinse, sanitize, drying

I was...
Replies: 18
Views: 43,073
Posted By visoredge

Thanks! Found the wiring diagram.. I checked...

Thanks!
Found the wiring diagram..
I checked the incoming voltage, reads 110

WIth circuit breaker OFF, and meter set to Ohms, I get "1" as the reading between the door switch metal. SO this...
Replies: 18
Views: 43,073
Posted By visoredge

Thanks for the post, no it does not run in heavy...

Thanks for the post, no it does not run in heavy cycle.
I'll have to unscrew the toe plate. Is that the standard location for a wiring diagram?

I do have a voltmeter, how do I test the door...
Replies: 18
Views: 43,073
Posted By visoredge

MayTag Dishwasher Control Panel doesnt work

We use our dishwasher only about once every 2 weeks.
Yesterday, it refused to work.
The HEAVY CYCLE button would light, but not the NORMAL, LIGHT, or RINSE buttons.

Pressing the START button and...
Showing results 1 to 11 of 11


 
Forum Jump