Search: Posts Made By: edge10
Showing results 1 to 25 of 200
Search took 0.02 seconds.
Replies: 1
Views: 120
Posted By edge10

Adding Porch After House New Roof Replacement

This season I wanted to have a new roof installed the existing house and a new entry porch built (Portico 10 ft w x 8 ft deep) at the same time. With all the past labor and material problems it is...
Replies: 0
Views: 123
Posted By edge10

Homelite/Ryobi HP3127S( Ryobi 8003) Pressure Washer Pump Seal Replacement

I have a Homelite PW HP3127S(Ryobi 80030A)with a Subaru Ex21engine and what l believe is a FIAP pump 985660001. The pump needs the end seal (called the flange seal in IPD) replaced due to an oil...
Replies: 3
Views: 198
Posted By edge10

The cap will also keep animals out. Before we had...

The cap will also keep animals out. Before we had the cap installed a fairly large woodpecker went down the chimney flue and ended up in the furnace. Lucky this was during the warm weather, so the...
Replies: 6
Views: 251
Posted By edge10

I started looking contractors last Feb 2021 and I...

I started looking contractors last Feb 2021 and I have had bad interactions except for one. I'll save the details for another thread , that's for a whole other topic. I am sure there are two sides to...
04-18-22, 08:31 AM
Replies: 7
Views: 233
Posted By edge10

Any experience with the chair swivel feature for...

Any experience with the chair swivel feature for the top of the stairs, especially between manual and motorized ? Would seem to be a necessity, at least for my application.
Replies: 6
Views: 251
Posted By edge10

Do It All Now or Wait Next Year and Do Repairs Now

I need a new roof, new gutters, 2 fascia board replacements along with some other exterior repairs and wanted to combine this job will a small entry porch. This would probably be considered a medium...
04-14-22, 12:38 PM
Replies: 7
Views: 233
Posted By edge10

Thanks for the link. I'll check it out.

Thanks for the link. I'll check it out.
04-14-22, 11:22 AM
Replies: 7
Views: 233
Posted By edge10

Any problems getting replacements parts for DIY...

Any problems getting replacements parts for DIY installed units ? I know batteries are usually standard sizes, so that should not be an issue. I have carpeted stairs. Do the install instructions give...
04-14-22, 10:12 AM
Replies: 7
Views: 233
Posted By edge10

Stairlift DIY Installation

I would like to get input stairlift DIY installation and a recommendation of brand that you have had experience. I'll understand some members don't like to mention brands, but any info on specs or...
Forum: Water Heaters
02-21-22, 10:38 AM
Replies: 1
Views: 296
Posted By edge10

Anode Replacement Kenmore/State/AO Smith 12yr Model 153.572400

I have a 6 1/2 yo Kenmore heater that I maintain regularly, with drain/flush and anode checks. It's 40 gal with two anode primary and secondary anode (hot port). There is about 3 inches of exposed...
Replies: 7
Views: 411
Posted By edge10

Gutter Estimates and Deposit

I am getting estimates to replace a section of fascia, aluminum wrap and new gutters. No special order materials and no materials pre-delivered. One company has a very detailed quote and was fast to...
Replies: 3
Views: 364
Posted By edge10

Yes, I meant 3x 4. 2x3 is on the one's now. Some...

Yes, I meant 3x 4. 2x3 is on the one's now. Some installations will use 3x4 on the 5 inch.
Replies: 3
Views: 364
Posted By edge10

New 5 or 6 inch Gutters

I would like to get some input whether to install 5 or 6 inch gutters on a two story colonial with total 2200 square ft floor space and located inland central NJ . The fascia board is double 1x...
10-02-21, 01:55 PM
Replies: 7
Views: 726
Posted By edge10

Fixed! I was checking the loop you showed...

Fixed! I was checking the loop you showed including the fusible link and looked like a loose connector. Voltage at the PS tested good at each point. No sooner that this was fixed, there is a Flame...
10-02-21, 12:05 PM
Replies: 7
Views: 726
Posted By edge10

No problem, glad the diagram is of help. I'll...

No problem, glad the diagram is of help. I'll check it out circuit and post back.
10-02-21, 10:59 AM
Replies: 7
Views: 726
Posted By edge10

Yes, I have problem with the high limits twice....

Yes, I have problem with the high limits twice. It was a combined problem with a worn blower motor that was causing low air flow and would cause the high limit to trip when going up to temp. That...
10-02-21, 10:45 AM
Replies: 7
Views: 726
Posted By edge10

The one I tested is the bimetal limit switch in...

The one I tested is the bimetal limit switch in the plenum above the heat exchanger. It looks like there is Fusable Link (Flame Roll-out Device )wired in series the with this that should be checked.
10-02-21, 10:17 AM
Replies: 7
Views: 726
Posted By edge10

Trane xl80 furnace: no heat - high limit open

I have a Trane xl80 TUD120R960A1 with a high limit open (4 flashes). The blower is running continuously , Continuity on limit switch is OK, but there is no voltage (24v). It also looks like the...
Replies: 1
Views: 363
Posted By edge10

Chimney Crown Repair

I have a brick chimney with a clay flue liner where the chimney crown needs repair. The crown has a single crack which was caulked a few years ago, but I like some info on the best way to have a...
01-02-21, 02:03 PM
Replies: 2
Views: 466
Posted By edge10

Is it best to replace this module by removing the...

Is it best to replace this module by removing the burner box bottom cover or remove the cooktop (glass). The sheet metal bottom cover fits on the box very tight .
Replies: 6
Views: 480
Posted By edge10

Yes, I do realize that the fascia and soffit...

Yes, I do realize that the fascia and soffit needs to be fixed before hanging the gutter. The concern the attic is exposed the elements and entry of squirrels, which I have had in the past.
Replies: 6
Views: 480
Posted By edge10

What about the damaged gutter that is pulled off...

What about the damaged gutter that is pulled off the fascia and hanging down? Some of the attic area is exposed.
Replies: 6
Views: 480
Posted By edge10

Replace one gutter or all before new roof

I need to have one gutter replaced that separated from the rotted fascia and fell from the second story of a colonial during this last snow storm. I was planning to have a new roof done ( tear-off)...
Replies: 5
Views: 716
Posted By edge10

Thanks for the info. I think I picture what you...

Thanks for the info. I think I picture what you are describing, Is there a link to a diagram or pic of the gutter, hanger, drip edge, apron?

Some of the quotes, just state the use of a hidden...
12-22-20, 07:43 AM
Replies: 2
Views: 466
Posted By edge10

Kitchenaid range kgct305tbl: doesn't spark

This stove is almost 30 yrs old, but still in pretty good shape except for the spark ignition. The sparking gradually stopped over a period of about 2 weeks and now there is no spark at all. I have...
Showing results 1 to 25 of 200
 


 
Forum Jump