Search: Posts Made By: PJmax
Showing results 1 to 25 of 200
Search took 0.03 seconds.
Replies: 4
Views: 296
Posted By PJmax

You can jump the switch to test the dryer...

You can jump the switch to test the dryer operation.
Today, 02:13 PM
Replies: 1
Views: 27
Posted By PJmax

Looking at the manual..... it states to remove...

Looking at the manual..... it states to remove two screws and pull out the burner assembly.
The manual is in the link below. Pictures of your unit are helpful too....... How-to-insert-pictures....
Today, 02:02 PM
Replies: 8
Views: 129
Posted By PJmax

Ok.... I labeled the screw terminals in Joed's...

Ok.... I labeled the screw terminals in Joed's diagram but that is what you need to follow.
The location of the screws on the switch is unimportant as long as the black screw is observed.

Based...
Today, 01:55 PM
Replies: 8
Views: 128
Posted By PJmax

It's good you have GFI protection. With a...

It's good you have GFI protection. With a GFI..... you may feel a slight tingle before it trips..... and it may not even trip. The GFI's are designed to trip at a shock level that would be considered...
Replies: 1
Views: 23
Posted By PJmax

You can use any diode you can find. You may find...

You can use any diode you can find. You may find one in an old piece of electronic equipment you can pull apart. If you want to purchase one..... get them from eBay or even amazon. 1N4001 diode.
...
Replies: 2
Views: 40
Posted By PJmax

Welcome to the forums. I labeled your...

Welcome to the forums.

I labeled your pictures. I know the red wire is definitely a T (traveler) and I'm fairly sure I have the other two black wires labeled correctly. If it doesn't work...
Today, 11:33 AM
Replies: 1
Views: 97
Posted By PJmax

Welcome to the forums from the UK. This is...

Welcome to the forums from the UK.

This is predominantly a North American based site so our wiring and codes are different than yours.

Here an extension cord is only rated for temporary use so...
Today, 11:22 AM
Replies: 8
Views: 118
Posted By PJmax

In heat mode..... the thermostat has no control...

In heat mode..... the thermostat has no control over the blower. When the heat is called for..... it starts a timer in that board and that timer activates a relay to start the blower in heat mode....
Today, 11:05 AM
Replies: 2
Views: 64
Posted By PJmax

Based on your measurements it looks like #4...

Based on your measurements it looks like #4 copper (85A). Unfortunately you don't know if that cable carries a waterproof ID. Typically it would be THWN and have a clear shiny coating over the black...
Replies: 2
Views: 62
Posted By PJmax

Your model number is KGYE900SWH1. Your tech...

Your model number is KGYE900SWH1.
Your tech sheet is LIT3387420.

I could not find a copy of the tech sheet anywhere. You will need to locate the wiring diagram in your machine. Typically it's on...
Today, 09:13 AM
Replies: 4
Views: 105
Posted By PJmax

It doesn't really make a difference how you...

It doesn't really make a difference how you connect the common wires as long as they are all connected together.
Today, 09:11 AM
Replies: 8
Views: 129
Posted By PJmax

We still need the wire color on the dark screw of...

We still need the wire color on the dark screw of the second switch.
Today, 09:09 AM
Replies: 2
Views: 62
Posted By PJmax

Duct work is typically made on demand. Look for a...

Duct work is typically made on demand. Look for a duct supply "tin knocker" in your areas. They can make any size duct needed.

A platform and a curb are two different things. Curbs are built in...
Today, 09:03 AM
Replies: 8
Views: 128
Posted By PJmax

You should make sure there is GFI protection on...

You should make sure there is GFI protection on garage and outside receptacles.
If it is modern..... they should have protection.

If the cleaner has a three prong plug...... it has an internal...
Today, 08:58 AM
Replies: 1
Views: 64
Posted By PJmax

Welcome to the forums. Thread moved to the...

Welcome to the forums.

Thread moved to the outdoor landscaping forum.

From what you are describing...... it sounds like an "assignment to group" problem.
Try programming the B program with all...
Replies: 4
Views: 109
Posted By PJmax

We don't know your actual plumbing but based on...

We don't know your actual plumbing but based on what I've seen in other installations..... it is not usually an easy job. The plumbing is tight and in a restricted area. It would be ideal if you can...
Today, 08:47 AM
Replies: 8
Views: 148
Posted By PJmax

Electronic air cleaners are very effective BUT...

Electronic air cleaners are very effective BUT they must be cleaned religiously......and by that I'm talking about once a month at a bare minimum based on season and run time.

I've had one for...
Today, 08:37 AM
Replies: 8
Views: 118
Posted By PJmax

Welcome to the forums. All the pictures and...

Welcome to the forums.

All the pictures and diagrams you originally posted are only for the outside condenser.
I will remove the ones that aren't needed for this thread.

You have a three speed...
Today, 08:25 AM
Replies: 1
Views: 50
Posted By PJmax

Welcome to the forums. Not running the...

Welcome to the forums.


Not running the big heat pump will technically save you money.


The window heat pump will not have enough heating capability to heat that house.
Today, 08:20 AM
Replies: 8
Views: 129
Posted By PJmax

You have three cables there. One is the supply...

You have three cables there. One is the supply and is hot. One is the light. The other is the three way switch. The wiring is very easy but you need to pull out the other three way switch and see...
06-13-19, 09:12 PM
Replies: 8
Views: 168
Posted By PJmax

Good job. :thumbup: Thanks for letting us know...

Good job. :thumbup: Thanks for letting us know how you made out.
06-13-19, 09:06 PM
Replies: 2
Views: 128
Posted By PJmax

Welcome to the forums from the UK. How does...

Welcome to the forums from the UK.

How does USB sockets figure in here ?
USB sockets are 5vDC.
06-13-19, 09:00 PM
Replies: 1
Views: 89
Posted By PJmax

You haven't told us anything about your wiring...

You haven't told us anything about your wiring but the old unit has the button connected to terminals 4 and 5. The new unit would have the button connected to A1 and A2.

For more detailed...
Replies: 3
Views: 112
Posted By PJmax

If you are looking for a quality product........

If you are looking for a quality product..... look to Kichler.
(not sure why it says 2017. It's the latest shown).
Kichler: Landscape Lighting 2017...
06-13-19, 08:35 PM
Replies: 1
Views: 134
Posted By PJmax

Welcome to the forums. A clear and concise...

Welcome to the forums.

A clear and concise post is important. Your title was fragmented so I changed it.
You've given us absolutely nothing to work with.

You have a 20 year old furnace. You...
Showing results 1 to 25 of 200
 


 
Forum Jump