Search: Posts Made By: nyounaki
Showing results 1 to 11 of 11
Search took 0.01 seconds.
Replies: 3
Views: 362
Posted By nyounaki

How can I distinguish between fireplace and fireplace inserts

Hi There ,
I have a Gas Fireplace ,I am unsure if I have Fireplace or FirePlace Insert , so how to know which one is my FirePlace ? and if I need to replace with the Electric one , is possible DIY...
Replies: 3
Views: 404
Posted By nyounaki

Gas Fireplace 's flame doesn't spread all areas

Hi
The flame of Gas Fireplace doesn't spread all areas , in spite the lit persists
even after move the knob to on , please advice : below are the steps I have done and the picture explain what...
07-27-18, 08:14 PM
Replies: 4
Views: 310
Posted By nyounaki

Any reply Please ? is replacing 1/2" with 1/4 "...

Any reply Please ? is replacing 1/2" with 1/4 " is OK for the washroom ?
07-27-18, 07:42 PM
Replies: 4
Views: 310
Posted By nyounaki

as a solution I am thinking , any issue if I...

as a solution I am thinking , any issue if I replace the 1/2" cement board wall with 1/4" cement board?
07-27-18, 06:56 PM
Replies: 4
Views: 310
Posted By nyounaki

My apologize , can you please clarify ? do you...

My apologize , can you please clarify ? do you mean moving the tub from the wall 1/4 inch (for me I have to remove the drain kit which disaster as it is fixed ? my wall (the cement board ) is...
07-27-18, 06:13 PM
Replies: 4
Views: 310
Posted By nyounaki

Tiling overlap on the new installed bathtub any solution ?

HI
I've just installed the Bathtub by my self following the recommendation on you tube :
I've put it the bathtub site stuck on the wall as shown below then install cement board 1/2 Inch , then...
07-22-18, 06:24 AM
Replies: 8
Views: 356
Posted By nyounaki

unfortunately , I have no experience on solder ...

unfortunately , I have no experience on solder , and didn't want to have a risk on doing those behind the wall as the first time!
07-22-18, 05:33 AM
Replies: 8
Views: 356
Posted By nyounaki

replying to Norm201 :, I am using SharkBite...

replying to Norm201 :, I am using SharkBite behind the wall , and unfortunately I have already set it up before seeing your reply , and not sure if I have really to undo my work and start again...
07-22-18, 05:29 AM
Replies: 8
Views: 356
Posted By nyounaki

Thanks , I have just tried , and squeezed as much...

Thanks , I have just tried , and squeezed as much as I can using Teflon tape, and works perfectly!
07-21-18, 10:18 AM
Replies: 8
Views: 356
Posted By nyounaki

Bathtub faucet: fittings don't fit fully - is that normal ?

HI ,

I have Moen shower Tube valve I am trying to connect the valve port with the cold and hot water pipe , the question the connection between the valve port and connector is not go inside fully...
Replies: 1
Views: 277
Posted By nyounaki

Concrete footings not levelled properly

I poured a couple of concrete footings (12inch diameter for 6by 6 post) for an outdoor deck, that go about 4 feet deep. I ve tried to levelled as much as possible but unfortunately the the top of...
Showing results 1 to 11 of 11


 
Forum Jump