Search: Posts Made By: mowerdude
Showing results 1 to 25 of 200
Search took 0.03 seconds.
Replies: 9
Views: 637
Posted By mowerdude

Deck number is E0920, serial number 018016m....

Deck number is E0920, serial number 018016m. Nowhere to be found in JD site. YIPPIE!!! Back to the old rope method!!
Replies: 9
Views: 637
Posted By mowerdude

It shows parts but not belt for deck drive belt,...

It shows parts but not belt for deck drive belt, may have to use deck model number. O BOY!!
Replies: 9
Views: 637
Posted By mowerdude

Yep,,,, thank you.:thumbup:

Yep,,,, thank you.:thumbup:
Replies: 9
Views: 637
Posted By mowerdude

Oh boy Mailer Demon on e-mail sent. May have to...

Oh boy Mailer Demon on e-mail sent. May have to measure this out old school way. :help:
Replies: 9
Views: 637
Posted By mowerdude

Thank You Chandler, I sent them a message. Even...

Thank You Chandler, I sent them a message. Even if I had a belt number I could cross it but I have just the machine. Time for more internet work.
Replies: 4
Views: 1,564
Posted By mowerdude

The metering diaphragm may be hard and is holding...

The metering diaphragm may be hard and is holding the needle open to allow fuel to flow into engine.
Replies: 9
Views: 637
Posted By mowerdude

1966 John Deere 60

I have been working on this old restored John Deere 60 for some time now. Down to getting deck drive belt, from engine to deck. Does anyone have dimensions of belt used ??

Thanks
Replies: 5
Views: 905
Posted By mowerdude

New belt in place and customer happy.

New belt in place and customer happy.
Replies: 5
Views: 905
Posted By mowerdude

Did not have to remove to take belt off but am I...

Did not have to remove to take belt off but am I the only one that has worked on the mower?? Thank You Cheese I think you are right.
Replies: 5
Views: 905
Posted By mowerdude

I checked it and nope that isn't it. A 2009. The...

I checked it and nope that isn't it. A 2009. The belt was stretched a bit.
Replies: 5
Views: 905
Posted By mowerdude

Cub Cadet LTX 1040 13RX90AR056

This is a variable speed type drive, forward reverse push the pedal to go. Putting new belt on because it will not go fast or pull its self up a hill. Took old belt off no problem but isn't the...
Replies: 5
Views: 1,123
Posted By mowerdude

I think you are right. :p

I think you are right. :p
Replies: 5
Views: 1,123
Posted By mowerdude

Looked at the flywheel again today and sure...

Looked at the flywheel again today and sure enough it is broken. Just a thought, if I take if off which I have to, if it can be welded and then heated up to be put back on. I wonder if it would hold...
Replies: 5
Views: 1,123
Posted By mowerdude

Thank You. I'll see if I have time to get it off...

Thank You. I'll see if I have time to get it off today. I have replaced the ring gears before on Car flywheels but never a mower. :wave:
Replies: 5
Views: 1,123
Posted By mowerdude

Kohler Command SV740 27 HP

Hi everyone. Glad to be back but I have one question. I am working on a 27 HP Kohler SV740-0010 which is in a Cub Cadet. Well to get to the point the ring gear on the flywheel has come OFF. I haven't...
Replies: 7
Views: 1,383
Posted By mowerdude

I agree Cheese,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,

I agree Cheese,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
Replies: 2
Views: 967
Posted By mowerdude

Try e-bay,,sometimes they have some of these on...

Try e-bay,,sometimes they have some of these on there and they are in good shape and low dollar. I have 2 but I'm not allowed to sell on here :cool:
Replies: 25
Views: 38,638
Posted By mowerdude

Do what Geo says,,,,,,,,,,,,,the back side of the...

Do what Geo says,,,,,,,,,,,,,the back side of the diapragm is more than likely leaking causing it to run rich and uneven. It's not rocket science here.
Replies: 7
Views: 1,383
Posted By mowerdude

They start from the underneath. Like I said...

They start from the underneath. Like I said earlier, if there are already 3 in the motor a fourth is not needed. If this is a Self propelled unit it may be covered with a belt guard.
Replies: 25
Views: 38,638
Posted By mowerdude

Change the diaphragm and be done with it! It may...

Change the diaphragm and be done with it! It may look good but in certain area it probably isn't.
Replies: 8
Views: 2,087
Posted By mowerdude

Sounds to me like the flywheel key has sheared...

Sounds to me like the flywheel key has sheared off. Sounds like it is out of time. Pull off the cover that covers the flywheel bolt and take out the flywheel bolt and inspect.
Replies: 7
Views: 1,383
Posted By mowerdude

You are very welcome.,,,,,,,,,,,,,,,,,,,,,,,

You are very welcome.,,,,,,,,,,,,,,,,,,,,,,,
Replies: 32
Views: 9,847
Posted By mowerdude

I have no Idea what the washers are made of,,the...

I have no Idea what the washers are made of,,the regulator would be a small gray or chrome box on the side of the dip stick. Where are you measuring for voltage?? If at battery that would be good and...
Replies: 32
Views: 9,847
Posted By mowerdude

Here is link showing the parts involved of your...

Here is link showing the parts involved of your charging system. Tri circuit will have a diode and a Daul circuit will have a regulator. Parts and Diagrams for Briggs and Stratton 284707-0147-01...
Showing results 1 to 25 of 200
 


 
Forum Jump