Search: Posts Made By: michaelshortt
Showing results 1 to 25 of 200
Search took 0.03 seconds.
01-19-19, 09:15 AM
Replies: 7
Views: 323
Posted By michaelshortt

Could you use Wifi bulbs? I have a couple of them...

Could you use Wifi bulbs? I have a couple of them and they work great.
09-09-18, 08:22 PM
Replies: 5
Views: 477
Posted By michaelshortt

I pour vinegar in the drain for a couple of days.

I pour vinegar in the drain for a couple of days.
Replies: 5
Views: 558
Posted By michaelshortt

Looking at the chimney in the attic the water is...

Looking at the chimney in the attic the water is probably coming from the crown. I say repair crown and put a cap o it.
02-05-18, 04:28 PM
Replies: 5
Views: 799
Posted By michaelshortt

I am not a pro with HVAC but I am thinking it...

I am not a pro with HVAC but I am thinking it might be a cracked heat exchanger and the heater is past its normal life. I would call another HVAC guy and replace the heater. Hope the pros will be...
Replies: 4
Views: 808
Posted By michaelshortt

So I looked at taking the option of unbolting,...

So I looked at taking the option of unbolting, lowering the lower arm and jacking them up. They were tough to install so I didn't fell comfortable with that. I Lowered the right side all the way...
Replies: 4
Views: 808
Posted By michaelshortt

Hmmmmmm, hadn't thought about that. I do need a...

Hmmmmmm, hadn't thought about that. I do need a better jack so I will think about. They are in there but not rotated like it should be. Maybe I will call a shop and have it done. Thanks for the info...
Replies: 4
Views: 808
Posted By michaelshortt

88 Chev 1500 pickup coil springs

I am rebuilding the front suspension on my 1988 Chev 1500 pickup. Getting the coil springs installed has been quite a challenge. I have them installed but the bottom end spring end is about 2 inches...
Replies: 8
Views: 414
Posted By michaelshortt

I would check the fuel pressure. Might be a bad...

I would check the fuel pressure. Might be a bad fuel pump.
Replies: 4
Views: 321
Posted By michaelshortt

The wax seal for the toilet is leaking. You will...

The wax seal for the toilet is leaking. You will see it when you remove the toilet to replace the floor. Feel free to ask us for more help when you start your project.
Replies: 9
Views: 431
Posted By michaelshortt

Had a set of Rigid batteries go bad. Lifetime...

Had a set of Rigid batteries go bad. Lifetime warrantee replaced the batteries with Lithium-Ion and a new charger. Old charger would not work.
Replies: 11
Views: 555
Posted By michaelshortt

Checking the grounds is cheap to do and may be...

Checking the grounds is cheap to do and may be the problem.
Replies: 10
Views: 1,083
Posted By michaelshortt

I have a 2003 Escape with 120,000. I changed all...

I have a 2003 Escape with 120,000. I changed all coils and plugs. Not that big of job. Also replaced the lower intake gaskets. They were pretty fried and easy to replace. It runs like a new car.
02-01-17, 04:25 PM
Replies: 9
Views: 847
Posted By michaelshortt

Oh you are correct Handyone.

Oh you are correct Handyone.
02-01-17, 02:31 PM
Replies: 9
Views: 847
Posted By michaelshortt

Never used one of those and a little pricey. I...

Never used one of those and a little pricey. I would try it out, can't see any reason not to.
Forum: Water Heaters
08-30-16, 10:26 AM
Replies: 17
Views: 14,216
Posted By michaelshortt

Find the end of the TP valve piping and look for...

Find the end of the TP valve piping and look for leakage. It could be any of the pipes at the top of the heater leaking down the tank and hitting the burner. Take a look at that.
Replies: 2
Views: 405
Posted By michaelshortt

Got it fixed. When I was checking all the fuses I...

Got it fixed. When I was checking all the fuses I left the Heco fuse out. Fuse installed, drove it for a while no check engine light and no codes.:wall::thumbup:
Replies: 2
Views: 405
Posted By michaelshortt

2003 ford escape codes

Have an after market radio that always lost power and would sometimes not come on. I installed it per the instructions and used a wire that always has power in the old radio wires. So I removed the...
Replies: 8
Views: 1,219
Posted By michaelshortt

I am thinking the joists are close to their life...

I am thinking the joists are close to their life expectancy. Of course I live in Washington and if the decking is in rough shape the joists will be soft and rotted. They will hold moisture for quite...
Replies: 14
Views: 2,528
Posted By michaelshortt

I had the same problem with my 8hp Craftsmen...

I had the same problem with my 8hp Craftsmen Generator. Same engine I'm thinking. I think the surface where the seat was seated into the carb had corroded after replacing the seat several times. I...
Replies: 9
Views: 718
Posted By michaelshortt

Tow Guy, that was funny. I owe you one.

Tow Guy, that was funny. I owe you one.
Replies: 9
Views: 718
Posted By michaelshortt

Didn't know that Gunguy. Doing a tune up with new...

Didn't know that Gunguy. Doing a tune up with new plugs, coil packs, PCV valve intake gaskets and while I am there valve cover gaskets. It only has 120,00 miles on it. Been a great car. Maybe EGR...
Replies: 9
Views: 718
Posted By michaelshortt

No, reved to 4000 during trouble shooting.

No, reved to 4000 during trouble shooting.
Replies: 9
Views: 718
Posted By michaelshortt

2003 Ford Escape high speed miss

2003 Ford Escape V6 dies a couple times for my wife, now has a miss at about 4000 RPM's. No codes. Idles good and runs good until it hits that 4000 RPM. Any ideas where I should start. I was getting...
Showing results 1 to 25 of 200
 


 
Forum Jump