Search: Posts Made By: hdtvluvr
Showing results 1 to 25 of 104
Search took 0.02 seconds.
Replies: 26
Views: 10,187
Posted By hdtvluvr

Was this correct? If not, what is the procedure? ...

Was this correct? If not, what is the procedure?

Thanks!
Replies: 26
Views: 10,187
Posted By hdtvluvr

yes, it was left. The linkage arm that has...

yes, it was left.

The linkage arm that has a wire and spring to the carb stands straight up. I moved this counterclockwise until full throttle, rotated the governor shaft clockwise until it...
Replies: 26
Views: 10,187
Posted By hdtvluvr

Please let me know if the round side or the flat...

Please let me know if the round side or the flat side of the seal goes toward the needle point. Also, did I set the governor up right?

Thanks
Replies: 26
Views: 10,187
Posted By hdtvluvr

That was how I cleaned the carb. However, I...

That was how I cleaned the carb. However, I didn't notice the seat. The green seal in the kit is flat on one side and rounded on the other. Are you saying the rounded side should be on top when the...
Replies: 26
Views: 10,187
Posted By hdtvluvr

The original was all metal. I didn't notice a...

The original was all metal. I didn't notice a seat in the carb. The original also had a spring which according to the instructions was not to be used since the engine had a fuel pump. Perhaps someone...
Replies: 26
Views: 10,187
Posted By hdtvluvr

I got a rebuild kit for the carb on my 252707. It...

I got a rebuild kit for the carb on my 252707. It has a small green "seal". Is this the seal that goes under the needle valve? I have the parts manual and it doesn't show a seal under the needle...
Replies: 7
Views: 5,094
Posted By hdtvluvr

Any ideas as to how this opener could get so far...

Any ideas as to how this opener could get so far out of adjustment that it ripped the door connector out? The stops on the chain are secure.

Please let me know what you think. I do not want to...
Replies: 7
Views: 5,094
Posted By hdtvluvr

It's me (I'm using a different login). I got home...

It's me (I'm using a different login). I got home and was able to look at the situation better - i.e. not in a rush as I was this morning. Here's the situation:

The screws are stripped out of the...
02-04-07, 12:22 PM
Replies: 27
Views: 3,338
Posted By hdtvluvr

You might want to run 3 rg6 cables to each...

You might want to run 3 rg6 cables to each location. 2 for the Sat receiver and 1 for over the air (OTA) signals. If you are looking at getting D*, you can not combine (diplex) an OTA antenna with...
Replies: 2
Views: 1,024
Posted By hdtvluvr

Got it fixed yesterday. Thanks

Got it fixed yesterday. Thanks
Replies: 2
Views: 1,024
Posted By hdtvluvr

Bad Sensor??

I have a MVP opener by AllStar. The red LED on the door sensor isn't lit. The door will only close by pressing and holding the 'down' button on the wired wall keypad.

I'm going to work on it...
12-31-06, 04:20 PM
Replies: 5
Views: 3,212
Posted By hdtvluvr

Try zip 38018 I'd print the page and go to...

Try zip 38018

I'd print the page and go to your local store.
12-31-06, 03:55 PM
Replies: 7
Views: 2,180
Posted By hdtvluvr

Thanks to both of you for the information. ...

Thanks to both of you for the information.

>>But the contacts are what they call "dry". This meaning YOU must provide the power to be switched.<<

I've never installed a timer with "dry"...
12-31-06, 03:48 PM
Replies: 5
Views: 3,212
Posted By hdtvluvr

Old Work Switch Box For a picture go to the...

Old Work Switch Box

For a picture go to the Lowes website and search for:
metal
Item #: 74219

Or plastic
Item # 37117
12-31-06, 03:35 PM
Replies: 7
Views: 2,180
Posted By hdtvluvr

Thanks for the further clarification. I did have...

Thanks for the further clarification. I did have a typo in my last post, I meant NO terminals but typed NC.

This timer was very expensive and I didn't want to mess it up.


>>If you are...
12-31-06, 03:15 PM
Replies: 7
Views: 2,180
Posted By hdtvluvr

Thanks for that information. However, I need to...

Thanks for that information. However, I need to know where to connect the wires. I have 2 wires for the 240v. I currently have one at the N terminal for the Timer Supply and the other at the 240v...
12-31-06, 02:44 PM
Replies: 7
Views: 2,180
Posted By hdtvluvr

220v Electronic Timer

I have a Tork Model 1104 wired for 240v. It is a mechanical timer with 4 connections. It works.
I decided that I wanted to be able to vary the on/off schedule and contacted Tork to determine which...
Replies: 8
Views: 6,623
Posted By hdtvluvr

There is another set of fuses under the hood....

There is another set of fuses under the hood. This box contains a 5A & 20A std. blade fuse, some larger fuses about 1/2 inch square, and some relays (headlights, etc.). The 5 amp was blown. According...
Replies: 8
Views: 6,623
Posted By hdtvluvr

Well, I checked all of the fuses in the fuse...

Well, I checked all of the fuses in the fuse block earlier today. All were OK.

Out of curiosity, I just went outside to see if the lighter works and it does.

I'll check for voltage tomorrow.
Replies: 8
Views: 6,623
Posted By hdtvluvr

I haven't tried replacing the bulbs. There are 2...

I haven't tried replacing the bulbs. There are 2 lights - one overhead by the temp gauge and one near the kick panel of the passenger door. Neither work. According to my daughter, the lights and...
Replies: 8
Views: 6,623
Posted By hdtvluvr

How many relays would there be? Would they all be...

How many relays would there be? Would they all be close (or on) the fuse block?

How would a relay only affect the interior dome light, radio display light and radio? The radio at least is on a...
Replies: 8
Views: 6,623
Posted By hdtvluvr

Interior light & radio 95 Dodge Dakota

The radio (display light and the radio itself) and the interior lights do not work. Everything was working fine and then both just stopped working. I've checked all of the fuses and they are good....
Replies: 5
Views: 1,098
Posted By hdtvluvr

If you use it to water your yard, have it checked...

If you use it to water your yard, have it checked for iron. If it contains iron it will stain everything red. This isn't a problem for grass but if it gets on your house, concrete, etc. it will be...
05-28-06, 04:52 AM
Replies: 6
Views: 949
Posted By hdtvluvr

Trench is filled in and everything is covered...

Trench is filled in and everything is covered with sod.:(
05-27-06, 08:59 PM
Replies: 6
Views: 949
Posted By hdtvluvr

I just checked the left over wire. It has 2 large...

I just checked the left over wire. It has 2 large conductors (8) and a smaller one. I guess the smaller one is a ground?

So, I should have gotten the electrician to run an extra wire in case I...
Showing results 1 to 25 of 104
 


 
Forum Jump