Search: Posts Made By: newtofta
Showing results 1 to 25 of 200
Search took 0.03 seconds.
Replies: 11
Views: 555
Posted By newtofta

THIS Diesel has injectors that are electronically...

THIS Diesel has injectors that are electronically triggered/fired/pulsed.
NOT like an old purely mechanically injected Diesel
Replies: 5
Views: 389
Posted By newtofta

Yes, that's what I think, also. I was hoping to...

Yes, that's what I think, also.
I was hoping to find someone else, that had this problem, & Did they FIND the culprit
Replies: 5
Views: 389
Posted By newtofta

Electrical Problem, 2009 GM PU

Looking for anyone with suggestions for problem, intermittent, power door locks, actuate up&down, while driving, voltage meter guage jumps back & forth,lites flicker. I have replaced, Battery Cable...
Replies: 6
Views: 755
Posted By newtofta

I worked as a tech at Ford dealerships, for 30+...

I worked as a tech at Ford dealerships, for 30+ years.
I know, from experience, what the marks are.
At some point in time, Someone replaced the pinion seal.
& did not get the pinion NUT...
Replies: 2
Views: 398
Posted By newtofta

I think you are right. I was hoping someone...

I think you are right.
I was hoping someone would say, SURE, just swap xxxxx & it wil work.
Replies: 2
Views: 398
Posted By newtofta

Question washing machine motor-swap

I have a older (mayme 15 years)Kenmore/Whirlpool washing machine with a bad motor.
the motor is a direct-drive, 2 speed motor, capacitor start, with what looks to me to be heavy winding.
i had...
Replies: 4
Views: 641
Posted By newtofta

Thanks, & Yes I have the cannon print app...

Thanks,
& Yes I have the cannon print app installed.
it just doesn't work.
As I stated the phone sees the printer, but can't comunicate with it?
Replies: 4
Views: 641
Posted By newtofta

Question Samsung S4 phone / No printer?

This may be out if place, or not a part of the forum,
But I'll ask any way.

I have a Cannon MG 3520 wireless printer.
It will print from the desktop by way of a usb cable.
& a ASUS...
Replies: 14
Views: 1,000
Posted By newtofta

Thumbs up Well, GOOD News for ME. & much thanks to all...

Well, GOOD News for ME.
& much thanks to all that replied.
I relpaced the CMOS battery, & found a very small guage wire bundle pinched between power supply
& outer desk top case. pulled power...
Replies: 14
Views: 1,000
Posted By newtofta

thanks again, for the input. i'm a retired...

thanks again, for the input.
i'm a retired auto mechanic, i have several multimeters/volt-meters, i could use to test the "voltage" output of the P/S, but not the actual Amperage/load it will...
Replies: 14
Views: 1,000
Posted By newtofta

Thanks, for the input. I had concidered the...

Thanks, for the input.
I had concidered the little battery, I also thought that if the battery died, I would just have the clock not reading correctly? But it is worth a try.
As to the other...
Replies: 4
Views: 736
Posted By newtofta

I'm no diesel tech, But, do you know if the...

I'm no diesel tech,
But, do you know if the Tachometer(in the dash, if it has one) wiggles when cranking with the starter?
Replies: 14
Views: 1,000
Posted By newtofta

Question blue screen, then no start?

H/P desk top, about 6-7 years old.
wireless mouse cursor was not responding with hand/ mouse movement.
did a reboot. got a blue screen, with a message stating that there was an error with windows,...
Replies: 12
Views: 888
Posted By newtofta

Just Curious, Does yours have the pressure switch...

Just Curious, Does yours have the pressure switch on the top/front of the master cylinder?
IF so, is it DRY/NOT leaking?
There was/Is a recall on MANY of these trucks, WITH this switch.
Replies: 4
Views: 2,152
Posted By newtofta

the ratings must have been on the Vendor, Not the...

the ratings must have been on the Vendor, Not the machine.
I have used one since about 1997, when the Ford Thunderbird was re-introduced.
after multiple purchases, looking for Something that would...
Replies: 3
Views: 621
Posted By newtofta

yes, there is a metal tag rivited to the housing....

yes, there is a metal tag rivited to the housing.
But, as long as it is power steering.
I have replaced hundreds of these tie-rods
( I worked at the local Ford dealer, when thes vehicles were...
Replies: 3
Views: 594
Posted By newtofta

Thanks for the replys. This should make my...

Thanks for the replys.
This should make my buddy happy about his "Find"
Replies: 3
Views: 594
Posted By newtofta

Question What Year

anyone Know what year GM started using the Nylon covered upper timing gear in their engines?
vehicle in question is 1966 Olds Toronado

a friend of mine is looking to buy one, that is Supposedly...
Replies: 2
Views: 849
Posted By newtofta

As Marksr stated, the first time I used it I...

As Marksr stated,
the first time I used it I got all these bubbles- because I Shook the can.
Since i quit doing that I have had Excelent results
Replies: 5
Views: 661
Posted By newtofta

Ok, Thanks for the input

Ok,
Thanks for the input
Replies: 5
Views: 661
Posted By newtofta

Chandler, do you think/know if I will have a...

Chandler, do you think/know if I will have a problem of the recessed grout lines pattern transferring up through the laminate?
Would some the liquid type floor leveling compounds adhere to the...
Replies: 5
Views: 661
Posted By newtofta

Well, I felt sure I would get some opinions. As...

Well, I felt sure I would get some opinions.
As to whether this is a comon practice,
or
A definate no-no
etc?
Replies: 5
Views: 661
Posted By newtofta

Question laminate over tile

I am looking for advice/opinions on
installing laminate flooring ( about 850 sq ft)
on top of 13 x 13 ceramic tile
concrete slab house/ 1999/ Houston Texas area

thanks
Mike
Showing results 1 to 25 of 200
 


 
Forum Jump