Search: Posts Made By: beelzebob
Showing results 1 to 25 of 200
Search took 0.03 seconds.
Replies: 8
Views: 108
Posted By beelzebob

Is this a JD part for the tractor or a universal...

Is this a JD part for the tractor or a universal type? A picture of the solenoid woud help.
Replies: 9
Views: 197
Posted By beelzebob

You work with the springs with the door in the up...

You work with the springs with the door in the up position. There should be no tension on the springs. Working with a 2x12 17 feet long is not a 1 person task. Your posts indicate a lack of...
Replies: 2
Views: 115
Posted By beelzebob

3 way switches will only work controlling 1 load....

3 way switches will only work controlling 1 load. You have 2 loads to control. You still have many "what if " conditions to be decided. With 2 switches, each having on/off positions, there are 4...
07-17-19, 04:27 AM
Replies: 7
Views: 208
Posted By beelzebob

Best way to establish the cost is to get multiple...

Best way to establish the cost is to get multiple quotes. Have them quote both backflow devices and a main water shutoff in the house. Here in Connecticut the sprinkler backflow device must be tested...
07-16-19, 06:51 PM
Replies: 13
Views: 241
Posted By beelzebob

If the glass panes in the window slide in tracks,...

If the glass panes in the window slide in tracks, is the bottom track configured to drain rain water toward the sill?
07-16-19, 04:29 AM
Replies: 13
Views: 241
Posted By beelzebob

I would start by having a carpenter install a...

I would start by having a carpenter install a wooden frame from the inside for the window in question. Next thing is to determine the window is properly flashed and anchored to the frame. This could...
07-16-19, 04:10 AM
Replies: 4
Views: 208
Posted By beelzebob

How about 2-3 junction boxes and using wire nuts?

How about 2-3 junction boxes and using wire nuts?
Replies: 35
Views: 657
Posted By beelzebob

Condition of sheet metal on header has no impact...

Condition of sheet metal on header has no impact on the operation of the door opener unless that is all the U bracket was attached to initially.
07-14-19, 09:48 AM
Replies: 13
Views: 241
Posted By beelzebob

The window shown in post #4 does not contain a...

The window shown in post #4 does not contain a bottom horizontal window frame member. It should be resting on top of the 2x4 shown. It appears the area is filled with plaster or cement. Am I...
Replies: 5
Views: 185
Posted By beelzebob

The cost of a custom adapter (1 time) use should...

The cost of a custom adapter (1 time) use should be compared to the cost of a standard shaft motor that meets your need. Good luck.
Replies: 8
Views: 223
Posted By beelzebob

If you have a thermostat in the engine, the...

If you have a thermostat in the engine, the thermostat must heat up to open allowing coolant to flow. I follow this procedure after I drain the coolant from the engine. I fill the coolant system to...
Replies: 35
Views: 657
Posted By beelzebob

The only anchor to prevent horizontal motion of...

The only anchor to prevent horizontal motion of the door opener is the 2 bolts through the U bracket at the end of the track. Assuming they were correct size per installation instructions, I still...
Replies: 35
Views: 657
Posted By beelzebob

As mentioned earlier, loosening the bolts, top...

As mentioned earlier, loosening the bolts, top and bottom of the vertical angles supporting the opener motor should give the opener assembly sufficient freedom to move the track back into place....
Replies: 16
Views: 379
Posted By beelzebob

I have Gutterbrush installed for over 5 years...

I have Gutterbrush installed for over 5 years here in New England. I get leaves from maple, oak. locust and pine needles on my roof. Only the pine needles get stuck in the brush, but never enough to...
Replies: 8
Views: 265
Posted By beelzebob

As someone posted earlier, torque the flywheel to...

As someone posted earlier, torque the flywheel to manufacturers specification. Over torquing the aluminum flywheel can crack the flywheel at the bore. Use an accurate torque wrench. Once cracked,...
07-10-19, 03:38 AM
Replies: 2
Views: 232
Posted By beelzebob

No doubt the skylights created additional paths...

No doubt the skylights created additional paths for sunlight to heat the inside of the house. Temperatures in October are cooler than temperatures in July so the load on the A/C is greater in July....
07-09-19, 04:25 AM
Replies: 6
Views: 309
Posted By beelzebob

OP, can you expand on this quote from an earlier...

OP, can you expand on this quote from an earlier post. "No switches on the panel are broken and I tested them."
Replies: 4
Views: 222
Posted By beelzebob

You need a shutoff valve in the refrig water line...

You need a shutoff valve in the refrig water line to do the following.Shut off water line valve. Disconnect water line going into refrig and place in bucket. Turn shut off valve on. If flow is good,...
Replies: 8
Views: 1,117
Posted By beelzebob

Nothing beats having diagrams and manuals for...

Nothing beats having diagrams and manuals for your machines.
Replies: 16
Views: 661
Posted By beelzebob

Photo in post 8 shows toilet discharge path has 4...

Photo in post 8 shows toilet discharge path has 4 changes in direction. Seems impossible to get any cleanout device around all the changes in direction going from the bowl to the exit. Still like the...
06-29-19, 05:09 AM
Replies: 12
Views: 439
Posted By beelzebob

A GFCI plug would not have helped the problem...

A GFCI plug would not have helped the problem here as the AC unit plug contacts (problem area) would be upstream of the GFCI. Better approach in my opinion is to make the outlet a GFCI type and plug...
Replies: 9
Views: 438
Posted By beelzebob

Assuming it still is under warranty, take it to a...

Assuming it still is under warranty, take it to a dealer. Don't use cruise control until it is fixed.
Replies: 6
Views: 392
Posted By beelzebob

If the magnetic switches have both a NO (normally...

If the magnetic switches have both a NO (normally open) and NC (normally closed) terminal, move the wire from one terminal to the other on the door with the incorrect position indication.
06-28-19, 05:55 AM
Replies: 6
Views: 376
Posted By beelzebob

If removing the column is a high priority,...

If removing the column is a high priority, getting a licensed structural engineers approval/disapproval before taking action should be a higher priority. Finding out down the road you have created...
06-28-19, 05:26 AM
Replies: 6
Views: 339
Posted By beelzebob

Just a clarification. The 4-wire cable should go...

Just a clarification. The 4-wire cable should go between the 2 junction boxes containing the 3-way switches. The diagram in post 4 shows the 2 wires between the switches don't go through the...
Showing results 1 to 25 of 200
 


 
Forum Jump