Search: Posts Made By: pjasutis
Showing results 1 to 25 of 25
Search took 0.01 seconds.
Forum: Water Heaters
08-13-11, 06:58 PM
Replies: 3
Views: 637
Posted By pjasutis

sorry I meant 25 years old

sorry I meant 25 years old
Forum: Water Heaters
08-13-11, 01:10 PM
Replies: 3
Views: 637
Posted By pjasutis

Water heater problems

We had a crew working on a gas line out by our house, when they shut off the gas our hot water heater went out. When the turned the gas back on the pilot would not ignite. I installed a new...
Replies: 2
Views: 846
Posted By pjasutis

That part I understand, I'm trying to figure why...

That part I understand, I'm trying to figure why I have replaced 2 starters in a short amount of time. and both times It had a clunking sound before it started and that will be the last time it...
Replies: 2
Views: 846
Posted By pjasutis

1993 Infiniti J30 Automatic

How can you tell if the fly wheel is bad. and would it cause the starter on to engage?

Thanks
Replies: 2
Views: 571
Posted By pjasutis

I wish it was that easy. thanks for the try,

I wish it was that easy. thanks for the try,
Replies: 2
Views: 571
Posted By pjasutis

1993 Infinti J30 Won't Start

Can sombody give me some direction? I installed a new starter on this car, After it was done the car started ok but after the third time I started the car their was a clunk before it started the car...
Replies: 7
Views: 565
Posted By pjasutis

Thanks, thats what I thought. know of any where...

Thanks, thats what I thought. know of any where to get instructions on how to replace?
Replies: 7
Views: 565
Posted By pjasutis

over heating problem

2000 ford explorer 4.0 SOHC

I'm having a overheating issue, after driving the car the temp. needle will go to hot and come back to normal or a little above this happens after the car has sat long...
Replies: 6
Views: 685
Posted By pjasutis

The Engine will crank it just won't start.

The Engine will crank it just won't start.
Replies: 6
Views: 685
Posted By pjasutis

I was wrong in the last post. When they turned...

I was wrong in the last post. When they turned the key the key would not bounce back after you Tried to start the car. thats why they replaced the switch. Sorry I got bad information.
Replies: 6
Views: 685
Posted By pjasutis

The truck would not start and there was no power...

The truck would not start and there was no power going to the swith when we checked it.
Replies: 6
Views: 685
Posted By pjasutis

1991 ford E-150

I just replaced the Ignition switch in the Van and now it won't start. it will crank but won't turn over.
Replies: 3
Views: 925
Posted By pjasutis

It has a plain vacuum booster with no ABS. The...

It has a plain vacuum booster with no ABS. The booster that was replaced was the same as the old. We did bench bleed the M/C.
The brake lines all had pressure as we were bleeding them. But when...
Replies: 3
Views: 925
Posted By pjasutis

Brakes 1987 Dodge Caravan

We Just completed replacing a brake boster on this car. The problem is that after bleeding the brakes twice. the brake peddle is still going to the floor. there is no air in the lines. and no leaks...
Replies: 4
Views: 747
Posted By pjasutis

I had the battery checked and its still good. I...

I had the battery checked and its still good. I even went as far as taking the starter out and having it replaced. after we were done putting the Battery & Strater back in the car started fine and...
Replies: 4
Views: 747
Posted By pjasutis

It sounds like it coming from the fan area. We...

It sounds like it coming from the fan area. We just installed a new starter and the noise was gone the rest of the day and the next morning it was back. We have not had the battery checked yet. It...
Replies: 4
Views: 747
Posted By pjasutis

1993 Inifiniti J30

This may sound weird. In the morning when I go to start the car I hear a clunking sound and the car won't start. After about 7 cranks it will start and run fine and and if I run to the bank or store...
Replies: 2
Views: 784
Posted By pjasutis

2002 Chevy Tahoe 4X4 5.7 Liter

2002 Chevy Tahoe vibrates at speeds of 40 to 80miles per hour. Any Ideas what can be causing this? At speeds of 40mph or lower it seems to ride fine. also it seems to stop when you go over 80mph. the...
Replies: 1
Views: 624
Posted By pjasutis

1993 Infinity j30 6 Cylinder Valve Job

Does anyone know where I can get a parts list to compare with what the Mechanic is giving me. Also What is a fare price for this job I was quoted $2500.00.

Thanks
Replies: 2
Views: 685
Posted By pjasutis

1993 Infinity J30 antenna replacement

I need to replace the power antena on this car. How do I take the part on the rear quarter? do I need A special tool?
Replies: 1
Views: 672
Posted By pjasutis

Question Timing Belt Settings for 1993 Dodge Sprit 3.0 engin

Does anyone know if the timing belt brakes how can you tell if the timing is correct and if not how do you reset the timing.
Replies: 2
Views: 734
Posted By pjasutis

Thank you for your help I'll try both.

Thank you for your help I'll try both.
Replies: 2
Views: 661
Posted By pjasutis

Thank you

Thank you I've been looking for this for a few days.
Replies: 2
Views: 734
Posted By pjasutis

1993 Infinity J30

Does anyone know why this car will not start with out giving it gas, we've had the fuel injectors replaced that didn't help.
Replies: 2
Views: 661
Posted By pjasutis

timing Belt 1993 Dodge Sprit

Does any one have Directions on how to replace a timing belt on a 1993 Dodge Sprit.
Showing results 1 to 25 of 25


 
Forum Jump