Search: Posts Made By: geissap
Showing results 1 to 10 of 10
Search took 0.01 seconds.
Replies: 21
Views: 747
Posted By geissap

Hmm I might consider going that way then because...

Hmm I might consider going that way then because than I have a couple different widths that can work out at the end. May save me some time in ripping. Do you advise using some sort of pattern or just...
Replies: 21
Views: 747
Posted By geissap

I'm gonna go by the model again this weekend and...

I'm gonna go by the model again this weekend and check it out.

Another question slightly off topic for you guys. My wife pointed out some random width wood floor that we really liked. It had 3.5"...
Replies: 21
Views: 747
Posted By geissap

Mark - Understood. I'm trying to be hopeful. I'm...

Mark - Understood. I'm trying to be hopeful. I'm hoping I don't have to do any crazy tapers and stuff as a first timer.

Jim - Here ya go, but I can tell you I've seen floors laid in this same...
Replies: 21
Views: 747
Posted By geissap

Jim - Thank goodness you asked this cause I...

Jim - Thank goodness you asked this cause I thought i had this pretty much figured out and I was awfully confused at this point. The floor joists run from front to back NOT left to right. The front...
Replies: 21
Views: 747
Posted By geissap

Yes the diagram is all the first floor. The hall...

Yes the diagram is all the first floor. The hall down and foyer are basically all part of the dining room. It's an open floor plan so that's all one level. There's a support pillar you can see on the...
Replies: 21
Views: 747
Posted By geissap

Is there any point to doing the angled transition...

Is there any point to doing the angled transition piece under the door other than look? Or is to "reset" the point you made in the first paragraph. So you can kind of figure out the room and cut the...
Replies: 21
Views: 747
Posted By geissap

The joists run from front to back here. So I'll...

The joists run from front to back here. So I'll be laying the wood from left to right based on the floor plan if that makes sense?

We're going to buy 3/4" pre finished hardwood of some variety. 5"...
Replies: 21
Views: 747
Posted By geissap

1st Timer - flooring planning stage

Hello,

My wife and I are building a house that should be done in about 9 weeks. After 2 hours of youtube and lots of reading we are thinking about battling solid hardwood floors ourselves (nailed...
07-08-09, 07:54 AM
Replies: 4
Views: 4,784
Posted By geissap

Who sells honeywell? Do you know of the...

Who sells honeywell? Do you know of the particuliar model that will work with my stuff? If i pull those weird plugs that are by the actual units does that cut ALL power? There like T shaped plugs?
07-08-09, 06:27 AM
Replies: 4
Views: 4,784
Posted By geissap

Replacing Mercury Thermostat with Digital (Heat Pump System)

We just bought a house. We have two zone heating and cooling (1st floor and 2nd floor). We have a newer Carrier system Model #213rna024 controlling the bottom floor and then a very old Trane System...
Showing results 1 to 10 of 10


 
Forum Jump