Search: Posts Made By: Furd
Showing results 1 to 5 of 5
Search took 0.00 seconds.
06-24-11, 06:38 PM
Replies: 133
Views: 187,072
Posted By Furd

Hi, Teresa. Most of what I know about these...

Hi, Teresa.

Most of what I know about these motors I learned from this thread. I have this type of motor on my furnace that was installed in April of 2006 and it's still going just fine. (It'll...
06-24-11, 05:45 PM
Replies: 133
Views: 187,072
Posted By Furd

If they are going to replace the motor, control...

If they are going to replace the motor, control module and control board then there is nothing that you can do that will make it any worse.

I would suggest that you thoroughly read this entire...
12-14-10, 10:31 PM
Replies: 133
Views: 187,072
Posted By Furd

Too many unknowns about your particular system to...

Too many unknowns about your particular system to give a detailed answer. What you need to do is to have a switch that will disconnect the thermostat from the Y terminal on the furnace board and...
01-31-10, 12:22 AM
Replies: 133
Views: 187,072
Posted By Furd

Check the inlet air filters. Under some...

Check the inlet air filters. Under some conditions a choked air filter may cause the airflow to do what you describe.
10-18-08, 03:04 PM
Replies: 133
Views: 187,072
Posted By Furd

A thermistor is a resistor that changes its...

A thermistor is a resistor that changes its resistance as a result of heat. This may be internally generated heat or it could be heat from an external source.

Thermistors are made in a huge range...
Showing results 1 to 5 of 5


 
Forum Jump