Search: Posts Made By: Stumped1
Showing results 1 to 25 of 200
Search took 0.04 seconds.
Replies: 5
Views: 409
Posted By Stumped1

Parts ordered. Can I make the connection in the...

Parts ordered. Can I make the connection in the area where the sockets are wired or do I need to pull the fixture and connect in the ceiling?
Replies: 5
Views: 409
Posted By Stumped1

This is what it looks like inside. Looks like...

This is what it looks like inside. Looks like all 3 sockets are wired together?
Replies: 5
Views: 409
Posted By Stumped1

Can ceiling light socket be replaced?

Can this socket be replaced or repaired?
Replies: 1
Views: 338
Posted By Stumped1

Nevermind they are reversible!

Removed handle and reversed the valve stem plate
Replies: 1
Views: 338
Posted By Stumped1

Right Kitchen faucet cartridge different than left?

Had a leaky kitchen faucet. Figured I might as well change out both sides. Leak is gone but right handle now opens by turning handle right instead of left. Bought two of same cartridge thinking...
Replies: 7
Views: 866
Posted By Stumped1

So the rough idle has returned. Thinking I will...

So the rough idle has returned. Thinking I will try the battery disconnect ECU reset. Also read that it could be exhaust leak. Tried listening for leak but can't tell if there's anything, at least...
Replies: 7
Views: 866
Posted By Stumped1

I thought of that. According to the owners manual...

I thought of that. According to the owners manual that is the right fuse. Anyway running fine now.
Replies: 7
Views: 866
Posted By Stumped1

Operator error! When I put the fuse back I put...

Operator error! When I put the fuse back I put it back in the wrong slot.
Replies: 7
Views: 866
Posted By Stumped1

Seems everything in dash area including heater,...

Seems everything in dash area including heater, power windows as well.. 2003 Ford explorer 6 cylinder 4.0 Eddie Bauer. Will check to see if I disturbed other fuses

Started right up this morning...
Replies: 7
Views: 866
Posted By Stumped1

Problems after pulling pcu/ECU fuse

Pulled pcm fuse to reset after replacing msf sensor. Now radio interior lights and gauges don't work.
Replies: 1
Views: 2,859
Posted By Stumped1

Rain water getting inside bathroom exhaust vent pipe - no sign of roof leak

during heavy rainstorm last night water came dripping into bathroom through exhaust fan. Checked in attic and found no signs of water coming in through roof but found about an inch of water inside...
Replies: 12
Views: 575
Posted By Stumped1

No offense here. I appreciate the feedback. ...

No offense here. I appreciate the feedback. Tightening down the strut tower nuts solved the clanging problem. The car has a nice ride even though only the front struts are new. I asked the shop...
Replies: 12
Views: 575
Posted By Stumped1

taking it to the shop tomorrow. I was able...

taking it to the shop tomorrow.

I was able to use a drill bit to socket adapter and my compact drill driver to snug the strut mount to a point where I am comfortable that I can drive it downtown...
Replies: 12
Views: 575
Posted By Stumped1

Angry did a little research and found that the clanging...

did a little research and found that the clanging noise could be a loose upper strut mount Had a hard time getting these really tight because I don't have a ratcheting wrench. Going to buy one...
Replies: 12
Views: 575
Posted By Stumped1

Got both new struts on to the front except that...

Got both new struts on to the front except that the right pinch bolt would only go in about 80 percent. I stopped before I stripped it out. I went for a short test drive for a few blocks and there...
Replies: 12
Views: 575
Posted By Stumped1

looks like I put the passenger side spring on the...

looks like I put the passenger side spring on the driver side. This might be causing the problem.
Replies: 12
Views: 575
Posted By Stumped1

That is the video I watched. Suspension is the...

That is the video I watched. Suspension is the same. But when I attach the fork to the lca it sits higher so i am having to step on it.
I only have one side on jack stand. Going to jack up...
Replies: 12
Views: 575
Posted By Stumped1

1996 Acura Integra: front suspension problems

1996 Acura Integra LS 4 door automatic:


Removed old strut from front driver side and installed new one onto shock spring. Trying to put the unit back onto car but the suspension won't go far...
Replies: 2
Views: 2,788
Posted By Stumped1

I left it out in the rain for a few days. The...

I left it out in the rain for a few days. The charger in the photo is an upgraded newer version, the original was not very well made.

I will buy a new charger and see if that works.
Replies: 2
Views: 2,788
Posted By Stumped1

Black & Decker CMM1200 - charger or battery problem?

Charger got wet. Let it dry out before trying to charge the mower. Now the mower will not charge. bought the mower used so trying to determine if charger is bad or battery needs to be replaced.
...
Replies: 7
Views: 580
Posted By Stumped1

round peg in an oval hole

did a little investigating and the rear left speaker is going out. Connection is solid.

I have 2 new round 6.5 coaxial speakers. Going to try to mount them in place of the stock speakers.
Replies: 7
Views: 580
Posted By Stumped1

I will double check the speaker connections. I...

I will double check the speaker connections. I remember now that the two front speakers were replaced with new speakers a couple years ago.

Would purchasing new speakers solve the problem? If so,...
Replies: 7
Views: 580
Posted By Stumped1

1996 Acura Integra: blown speakers or loose wire?

recently replaced stock stereo in a 1996 integra with a Pioneer MVH-X380BT. Now getting static, sometimes thumpy static sound from the speakers.

The speakers are stock speakers from 1996. ...
Replies: 9
Views: 646
Posted By Stumped1

It is a blue rubber socket with a bunch of pin...

It is a blue rubber socket with a bunch of pin connections.
Showing results 1 to 25 of 200
 


 
Forum Jump