Search: Posts Made By: Stevo2
Showing results 1 to 25 of 200
Search took 0.03 seconds.
Replies: 2
Views: 943
Posted By Stevo2

Could be alot of things, your IAC valve is what...

Could be alot of things, your IAC valve is what gives the engine more air during deceleration and idle. Have you checked for error codes on the computer? Also read this Service Bulletin......
Replies: 7
Views: 1,409
Posted By Stevo2

Alldatadiy.com is good...I have a bunch of...

Alldatadiy.com is good...I have a bunch of subscriptions there. Just in case you need something else, go here...
www.nissan-techinfo.com/nissan
Replies: 6
Views: 1,659
Posted By Stevo2

The Factory Service Manual is always the best...

The Factory Service Manual is always the best thing to start with but you might also try this link.
www.therangerstation.com
www.rangerpowersports.com
Replies: 2
Views: 1,224
Posted By Stevo2

Need to scan the computer for error codes. Run a...

Need to scan the computer for error codes. Run a can of Seafoam through the gas tank and see if that helps your injector problem. Can get it at NAPA/CarQuest. If you truely have a leaky injector than...
Replies: 1
Views: 717
Posted By Stevo2

Try your local library for a service manual. ...

Try your local library for a service manual.
www.helminc.com
www.motorcraft.com (Technical Resources)
www.alldatadiy.com
Replies: 1
Views: 708
Posted By Stevo2

If it's fuel injected, there's nothing you can do...

If it's fuel injected, there's nothing you can do to turn down the idle. You need to have the error codes scanned and the fuel injection system fixed by a pro. About all you can do is check for a...
Replies: 1
Views: 2,500
Posted By Stevo2

I've never done one but here's some info. :) ...

I've never done one but here's some info. :)

Sliding Door
When removing the sliding door as an assembly it is not necessary to loosen bolts that would alter the alignment.
1. Remove sliding...
Replies: 4
Views: 2,271
Posted By Stevo2

Are your battery cables in good shape and both...

Are your battery cables in good shape and both ends of them squeeky clean and tight?
Replies: 3
Views: 784
Posted By Stevo2

If you go to this link you can get some info. ...

If you go to this link you can get some info.
Repair Info (http://autozone.com/servlet/UiBroker?ForwardPage=/az/cds/en_us/0900823d/80/1b/ca/9b/0900823d801bca9b.jsp)
Replies: 3
Views: 784
Posted By Stevo2

Could be a bad Idle Air Control Valve, EGR valve...

Could be a bad Idle Air Control Valve, EGR valve sticking...remote possibilty of a dirty MAF sensor. Have someone pull the error codes off the computer and see if they show anything....
Replies: 12
Views: 2,086
Posted By Stevo2

I have quite a few subscriptions at...

I have quite a few subscriptions at www.alldatadiy.com and for the later model vehicles they are real good. Wiring, vacuumn diagrams, step by step diagnostics, recalls and service bulletins and so...
Replies: 3
Views: 802
Posted By Stevo2

Try giving the starter a gentle rap with a hammer...

Try giving the starter a gentle rap with a hammer handle. Could be the starter is bad.
Replies: 14
Views: 1,134
Posted By Stevo2

Smile Look for a wire at the steering column support...

Look for a wire at the steering column support bracket. This is the bracket that holds the steering column up against the bottom of the dash. That is where your ground is supposed to be attached. If...
Replies: 4
Views: 1,298
Posted By Stevo2

Yep, main relay has bad solder joints that are...

Yep, main relay has bad solder joints that are affected by heat as from the sun.
Replies: 7
Views: 2,531
Posted By Stevo2

Bad solder joints in the main relay. ...

Bad solder joints in the main relay.
http://autorepair.about.com/cs/troubleshooting/l/aa010301a.htm
Replies: 6
Views: 1,938
Posted By Stevo2

You might also try a local library, I know mine...

You might also try a local library, I know mine here in town has a number of professional wiring and vacuum diagram manuals available.
Replies: 3
Views: 874
Posted By Stevo2

the wiring kit should come with instructions... ...

the wiring kit should come with instructions...
www.trailerwiring.com/inst/41245.pdf

http://hitches4less.com/19chevtractr.html
Replies: 2
Views: 932
Posted By Stevo2

Might try www.shermanparts.com www.car-part.com

Might try www.shermanparts.com
www.car-part.com
Replies: 3
Views: 3,030
Posted By Stevo2

For #1 you might try running a can of SeaFoam...

For #1 you might try running a can of SeaFoam through the gas tank and see what happens. You can get it at NAPA or CarQuest and others. There could be other problems also but always start with the...
Replies: 8
Views: 1,155
Posted By Stevo2

Sounds like you may have a bad ground on that...

Sounds like you may have a bad ground on that lamp asm.
Replies: 1
Views: 922
Posted By Stevo2

I'm not sure if a radiator shop might clean/flush...

I'm not sure if a radiator shop might clean/flush the old tank but you might call around. Also try www.car-part.com for a used one. Most places will not ship one because they are hazardous so look...
Replies: 2
Views: 847
Posted By Stevo2

Maybe this will help? ...

Maybe this will help?

http://autozone.com/servlet/UiBroker?ForwardPage=/az/cds/en_us/0900823d/80/16/be/cf/0900823d8016becf.jsp
Replies: 6
Views: 2,081
Posted By Stevo2

I have used both Pertronix and Mallory Unilite...

I have used both Pertronix and Mallory Unilite conversions and had no problems.
Replies: 2
Views: 2,167
Posted By Stevo2

You might try doing a search for a used visor at...

You might try doing a search for a used visor at www.car-part.com and look under "Interior Panels/Misc" and there are some visors listed throughout the multiple pages. :)
Replies: 3
Views: 1,096
Posted By Stevo2

This is a common problem. You get mildew on the...

This is a common problem. You get mildew on the evaporator and it stinks for a few minutes. You can get a disinfectant kit from most big auto parts stores or from Chrysler. Also, I don't know if...
Showing results 1 to 25 of 200
 


 
Forum Jump