Search: Posts Made By: tulihk
Showing results 1 to 25 of 96
Search took 0.02 seconds.
Replies: 2
Views: 559
Posted By tulihk

Amanna Dryer ALE866SAW Drum Glide replace

I have a Amanna Electric Dryer. Need to know how to remove top of the unit to get to drum glides. Model # ALE866SA and Serial # S0103216202.
Replies: 7
Views: 1,001
Posted By tulihk

Looked further and did not see the agitator...

Looked further and did not see the agitator spinning during the spin cycle. What could be wrong?
Replies: 7
Views: 1,001
Posted By tulihk

belt appears to be little loose. Is there a way...

belt appears to be little loose. Is there a way to tighten it?
Replies: 7
Views: 1,001
Posted By tulihk

Model # LNC6757A77, Rev 11

Model # LNC6757A77, Rev 11
Replies: 7
Views: 1,001
Posted By tulihk

Admiral Washer, cloths still drenched after cycle completion

My Admiral washer goes through th whole cycle, When pull clothes out they are still drenched. Water dripping from clothes. All of the water from tub gets drained out.

Is this a timer issue?
Replies: 14
Views: 1,407
Posted By tulihk

I had placed the order earlier and had cancelled...

I had placed the order earlier and had cancelled it once I started to read the responses here. Then I looked back in 2005, similar thing had happened to same washer. Back then I ha replaced the timer...
Replies: 9
Views: 986
Posted By tulihk

I tried installing as a slave drive on another...

I tried installing as a slave drive on another computer. The computer does not recognize it. It only showed one of the drives.

The problem with this drives is that it was 10GB drive. Windows and...
Replies: 3
Views: 1,256
Posted By tulihk

It was the timer after all. I installed a new...

It was the timer after all. I installed a new timer and it started working again.

:thumbup:
Replies: 14
Views: 1,407
Posted By tulihk

I broke down and purchase a new timer. The timer...

I broke down and purchase a new timer. The timer was delivered today and I installed immediately. That has fixed the problem and water drained and spin cycle is working again.

Not sure why the old...
Replies: 14
Views: 1,407
Posted By tulihk

I scanned the schematic as a JPG file but don't...

I scanned the schematic as a JPG file but don't know how to upload here. Anyone knows how?
Replies: 14
Views: 1,407
Posted By tulihk

I saw the wiring diagram but realy could not...

I saw the wiring diagram but realy could not follow it. The lid switch, as I stated inmy response, has always been bent a little bit. It only prevented the lid from closing. You had to straightened...
Replies: 3
Views: 1,256
Posted By tulihk

No noise at all. The timer moves though. I...

No noise at all. The timer moves though. I believe it drains and then spins. The lid switch has been bent little bit for a very long time though continued to work. Sometimes when you close the lid it...
Replies: 14
Views: 1,407
Posted By tulihk

Which Lid switch are you referring to? The one...

Which Lid switch are you referring to? The one that is on the door? The plastic piece of that switch has always been bent a bit, but the washer has continued to work.

Exact same thing happened...
Replies: 3
Views: 1,256
Posted By tulihk

Admiral Wahser not draining

My admiral washer model# LNC6757A77 does not drain. Water stays in the tub. Timer seems to be working through the cycles.
What should I check causing the problem?
Replies: 14
Views: 1,407
Posted By tulihk

I have just cancelled the order for replacement...

I have just cancelled the order for replacement timer. Since the timer cycles through, I believe it is not a timer issue.

Now I need to find out what is causing water sitting in the tub.
Replies: 9
Views: 986
Posted By tulihk

I have a similar problem with one of my...

I have a similar problem with one of my computers. It has WinXP Pro and since the primary hard drive is full it keeps on restarting itself. Can't get to safe mode.

I have WinXP disk. It is not a...
Replies: 14
Views: 1,407
Posted By tulihk

Water does not drain from the tub. Same story on...

Water does not drain from the tub. Same story on all three cycles. The spin cycle does not come on. I therefore assumed it was the timer bad and placed an order for a new one. I just remember after...
Replies: 14
Views: 1,407
Posted By tulihk

This is definitively an unusual noise only for...

This is definitively an unusual noise only for may be 10 seconds or less. It sounds like metal grinding noise. It is not a noise that was their before 3-4 weeks ago. I tilted the washer back to...
Replies: 14
Views: 1,407
Posted By tulihk

Admiral Washer noise when cycle completes

My Admiral Washer Model# LNC6757A77 makes a scratchy noise at the end of the cycle. Sound like some part need to be oiled. Does the motor or other parts at the bottom of the washer need to be oiled...
Replies: 2
Views: 1,997
Posted By tulihk

By the way it is a 1995 model and not a 1994. ...

By the way it is a 1995 model and not a 1994.

Is there any trick to taking the panel off? Any hidden screws or covers? Is there a picture on any website that would help me understand it?

I have...
Replies: 2
Views: 1,997
Posted By tulihk

1994 Nissan Altima door lock problem

I have a 1994 Nissan Altima with a small problem. The driver side door does not open with the key. The key works on the passenger side without any problem. All of the power locks work fine. In fact...
Replies: 2
Views: 2,417
Posted By tulihk

Thanks for your reply. I did figure out and...

Thanks for your reply.

I did figure out and was able to replace the belt.
Replies: 101
Views: 36,346
Posted By tulihk

Thanks JONESQ. I did mis-understood the...

Thanks JONESQ.

I did mis-understood the question. I did notice this morning since I have been up, the ref has turned off at least once an hour and started the cycle back again.

Hardish
Replies: 101
Views: 36,346
Posted By tulihk

No the ref is not running all the time. It cycles...

No the ref is not running all the time. It cycles every 8 hour. The new timer I installed is 8 hr timer. Old one was a 10 hr. I have placed a mark on the timer and have noticed that it is moving. The...
Replies: 101
Views: 36,346
Posted By tulihk

Well, It has been over a week and after...

Well,

It has been over a week and after replacing the Defrost timer and thermostat, the refrigerator appears to be working. Temp in both Freezer and Ref is about 10 Deg higher that it was...
Showing results 1 to 25 of 96
 


 
Forum Jump