Search: Posts Made By: Jarredsdad
Showing results 1 to 25 of 200
Search took 0.03 seconds.
Replies: 3
Views: 701
Posted By Jarredsdad

Slowly checking done the line. Did replace the...

Slowly checking done the line. Did replace the blower relay and pigtail due to a broken connection. Checked the resisters in the hot/cold deck. Checked the speed switch, seemed OK. Finally...
08-14-14, 08:05 PM
Replies: 12
Views: 3,113
Posted By Jarredsdad

First off, you asked questions. 1.) Is the...

First off, you asked questions.

1.) Is the thermostat too close to the Oven? No

2.) I know it's best practice to put the thermostat close to return air, but is it necessary? Yes!

3.) How...
08-14-14, 06:20 PM
Replies: 5
Views: 676
Posted By Jarredsdad

You need to find and fix a leak. If you are not...

You need to find and fix a leak. If you are not EPA 608 certified you maybe breaking the law putting gauges on your system. But as Geo said check the filter. With those pressures alone, I'd say...
Replies: 3
Views: 701
Posted By Jarredsdad

RV blower motor.

94 Holiday Rambler. Blower has 2 leads. Resistors in the circuit. Voltage to the motor is 11.6 (engine off) and blower doesn't run. Ohm out the motor windings and I get 156K. Seems cooked to me....
11-17-11, 08:28 PM
Replies: 2
Views: 6,503
Posted By Jarredsdad

Drain pan part number is AE-59193-06. ...

Drain pan part number is AE-59193-06.

Furnace rating should be inside of the furnace. You will have to tke the door off to see it. Or post the model and serial numbers and can look up.
11-17-11, 08:19 PM
Replies: 1
Views: 1,583
Posted By Jarredsdad

You need to post the full model and serial...

You need to post the full model and serial numbers.
11-14-11, 03:05 PM
Replies: 19
Views: 6,009
Posted By Jarredsdad

One thing to remember. When you do the system...

One thing to remember. When you do the system check at the control board, the board is enegizeing the outpouts to the equipment independent of the tstat.

So, if everything works ok during that...
11-13-11, 07:37 AM
Replies: 6
Views: 1,357
Posted By Jarredsdad

All I can find is a 3 phase packaged unit and...

All I can find is a 3 phase packaged unit and electric heat accesory with no circuit board at all.
11-13-11, 07:22 AM
Replies: 2
Views: 4,375
Posted By Jarredsdad

First that model number you gave isn't a model...

First that model number you gave isn't a model number. It should have something like "OHB" in it.

Second, the motor turning slowly and then a "click" means to me that the motor is shot. The...
11-13-11, 07:07 AM
Replies: 19
Views: 6,009
Posted By Jarredsdad

It's all coming back to me now - including DIY...

It's all coming back to me now - including DIY website issues!.

Total is the older board with a switch on the upper right side to put it in E-Heat.
...
11-12-11, 06:27 PM
Replies: 9
Views: 2,208
Posted By Jarredsdad

Surprised me, just cleaned it up. And,...

Surprised me, just cleaned it up. And, unfriended me on FB? I will not be at the wedding!
11-12-11, 06:23 PM
Replies: 19
Views: 6,009
Posted By Jarredsdad

As I remember it's a couple (or even one) button...

As I remember it's a couple (or even one) button presses. It was last Jan, I put in 2 15 ton heat pumps and ran them in E heat until the outdoor was finished. Look at the manual again. Double...
Replies: 11
Views: 8,866
Posted By Jarredsdad

Whoa! If you change the boiler an leave a bad...

Whoa! If you change the boiler an leave a bad circulator then you'll have a new boiler and a bad circulator!

Fixing the problem is cheaper!
11-11-11, 05:43 PM
Replies: 9
Views: 2,208
Posted By Jarredsdad

Hello - remember Me? First if you are having...

Hello - remember Me?

First if you are having condensate issues and are using a washable filter your evaporator is probably all kinds of clogged up. With whatever fine dust crap, your drin line is...
11-11-11, 04:50 PM
Replies: 19
Views: 6,009
Posted By Jarredsdad

It's been 11 months since I put in a truezone...

It's been 11 months since I put in a truezone system. But, the first thing that comes to mind it that the zone board is "IN" emergency heat. With no tstat's calling is the emerg heat light on on...
11-11-11, 04:27 PM
Replies: 10
Views: 10,356
Posted By Jarredsdad

If the unit is running in heat mode the condenser...

If the unit is running in heat mode the condenser would now be the indoor coil. Check the indoor blower, and filter. There may be a check valve around an indoor txv that is stuck closed, or a...
02-27-11, 06:50 AM
Replies: 5
Views: 983
Posted By Jarredsdad

Could be the PE. But are you looking at the...

Could be the PE. But are you looking at the correct PE? Try this again and bypass the PE with a coupling and see if the A/C comes on. If you have a lot of pneaumatics at your place it's good to...
02-27-11, 06:44 AM
Replies: 7
Views: 2,859
Posted By Jarredsdad

As AirMan said around here a permit is not...

As AirMan said around here a permit is not normally pulled. When changing a 3 ton heatpump system with a new 3 ton heatpump system a permit is not needed.

However, as I found in 2007, if I...
02-27-11, 05:48 AM
Replies: 8
Views: 16,255
Posted By Jarredsdad

New System

Sinse this syaytem is new I would imagine you still have all the original paper work and books that came with it.

Look through the installation manual for the outdoor unit. You should find what...
Replies: 3
Views: 2,020
Posted By Jarredsdad

Tried that wrench, now the thing, I guess,...

Tried that wrench, now the thing, I guess, doesn't know it is a CD player. Load button does nothing.

Just one more reason to get rid of the whole vehicle.
Replies: 3
Views: 2,020
Posted By Jarredsdad

2005 Durango CD player

My daughter has 6 CD's in the factory CD changer. The CD's won't eject. Any thoughts? Is the a manual eject thing as we have on computer CD/DVD drives?
01-28-11, 09:30 PM
Replies: 4
Views: 993
Posted By Jarredsdad

Lennox sells a lot of differnt IAQ products. ...

Lennox sells a lot of differnt IAQ products. Exactly what do you have? There must be some sort of sticker with a model number on it.
01-17-11, 03:39 PM
Replies: 36
Views: 12,162
Posted By Jarredsdad

Glad it all worked out for you.

Glad it all worked out for you.
01-04-11, 02:48 PM
Replies: 7
Views: 5,328
Posted By Jarredsdad

Welcome to this old thread papher51. We finished...

Welcome to this old thread papher51. We finished it 5 monthes ago and you are late.

The Spp7E is closest to the trane kit. They are different because of the compressor HP range they will work...
01-01-11, 06:14 AM
Replies: 2
Views: 1,151
Posted By Jarredsdad

Moved your post to it's own thread. Not a good...

Moved your post to it's own thread. Not a good idea to jump onto the end of an 11 month old thread with a new problem!!!!

Emergency Heat problem may be caused by the tstat, indoor unit, wiring,...
Showing results 1 to 25 of 200
 


 
Forum Jump