Search: Posts Made By: johnboy123
Showing results 1 to 9 of 9
Search took 0.01 seconds.
Replies: 3
Views: 1,334
Posted By johnboy123

If this will help, I bypassed the lid switch, so...

If this will help, I bypassed the lid switch, so I could run it with the lid open. Here's what happened during the Spin cycle:
The basket didn't spin, but did have a barely perceptible jerky...
Replies: 3
Views: 1,334
Posted By johnboy123

Still need help

After scooting the washer around so I could get the cabinet off and check the coupler (it was good but I had a new one, so I put it on), the washer started working fine. So, after a few runs I...
Replies: 3
Views: 1,334
Posted By johnboy123

Whirlpool washer LSQ9010LG3 won't spin

I had a problem several months back, with clothes washer not draining all the way. The timer wouldn't finish, and the clothes would still be wet. It was most likely an overloading problem, as some of...
Replies: 4
Views: 1,344
Posted By johnboy123

Overloaded ?

Last night my wife informed me that the washer left the clothes dripping wet again. No water left in the machine, just a bunch of soaked clothes.
So I go to the washer and it appears that it didn't...
Replies: 4
Views: 1,344
Posted By johnboy123

Whirlpool washer LSQ9010LG3 won't drain when wife uses it

Works OK for me, but when wife uses it, it sometimes leaves clothes dripping wet. I don't know if it's not spinning, not pumping, or what. I've just done four complete cycles and all is fine for me....
Replies: 2
Views: 4,071
Posted By johnboy123

Craftsman LT1000 Mower Deck Problem

LT1000 w/ 17hp B&S with a 42" two-bladed deck.

When mowing with this lawn tractor, I can look behind me and see single stalks of grass that haven't been touched right in the middle of the path...
Replies: 23
Views: 110,400
Posted By johnboy123

I'm gonna try the WD-40 , etc. If that works, my...

I'm gonna try the WD-40 , etc. If that works, my wife will be baking you some cookies.....................................
Thanks for the tips,
John
Replies: 23
Views: 110,400
Posted By johnboy123

My Admiral Mega 22Plus Vibratin' Washer is Model...

My Admiral Mega 22Plus Vibratin' Washer is Model # AW20N2V and is Rev 17.
Yes, I was used to the older washing machine tubs "springing back to center" when physically pushed to one side. I'm not...
Replies: 23
Views: 110,400
Posted By johnboy123

Seems that I've had the same problem as...

Seems that I've had the same problem as Donnie....for months now, our washer JUST WON'T SPIN without trying to walk the floor, and we can hear the tub banging against the inside of the cabinet. I've...
Showing results 1 to 9 of 9


 
Forum Jump