Search: Posts Made By: h15gus
Showing results 1 to 25 of 40
Search took 0.01 seconds.
Replies: 2
Views: 365
Posted By h15gus

Thank you. I will go with the new jbox in the...

Thank you. I will go with the new jbox in the attic, and get the book
Replies: 2
Views: 365
Posted By h15gus

Moving Vanity Light Box

I'd like to raise this thread again, as I have reverse situation. I'd like to remove my vanity light and add a new LED mirror, requiring me to abandon the existing wall box and extend down to a new...
03-19-17, 06:05 AM
Replies: 6
Views: 903
Posted By h15gus

Thanks, I just checked and the WeMo switch...

Thanks, I just checked and the WeMo switch requires a neutral, so I think i am good go.

Thanks everyone for your help.
03-18-17, 08:43 PM
Replies: 6
Views: 903
Posted By h15gus

Thanks, I dont understood how the builder passed...

Thanks, I dont understood how the builder passed inspection without GFCI receptacles in 2 of our three bathrooms. Easy to fix.

It will be great to learn if I can use a smart switch on the circuit,...
03-18-17, 08:22 PM
Replies: 6
Views: 903
Posted By h15gus

Thanks, The only outlets on the 20A breaker...

Thanks,

The only outlets on the 20A breaker are the three (one in each bathroom).

Unless I am missing something the manufacturers install instructions just say a grounded outlet...
03-18-17, 08:12 PM
Replies: 6
Views: 903
Posted By h15gus

Adding towel warmer to bathroom

I plan to install a hard-wired towel warmer to our en-suite wired to Belkin WeMo light switch. The rating for the warmer is 150W, 1.3A (Amba Radiant Curved from Home Depot).

My question is which...
Replies: 6
Views: 567
Posted By h15gus

Thanks, any reason why last season it was not an...

Thanks, any reason why last season it was not an issue, but this season is. I' know I am tilting the engine a fair amount, and once I've had the smoke, it seems to happen again at lower angles. It...
Replies: 6
Views: 567
Posted By h15gus

I haven't tried filling it to full recently, but...

I haven't tried filling it to full recently, but I think yes it is/was the last tie I had it at the full mark.
Replies: 6
Views: 567
Posted By h15gus

Husqvarna / Kohnler SV735 white smoke when crossing hill

I have an 08 Husq GTH26K54 that has run just fine for 6 years - I do annual oil change, filters etc. All been fine.

Just recently when I mow across my hill - and only when my right side is on the...
Replies: 7
Views: 766
Posted By h15gus

Thanks for the help, I'll wait until our temps go...

Thanks for the help, I'll wait until our temps go above zero in case I screw things up and am left with no heat, then give it a go
Replies: 7
Views: 766
Posted By h15gus

I have a shut off (feed side), bf preventer,...

I have a shut off (feed side), bf preventer, pressure reducer, shut off (system side) - so I may also have get an air lock issue - did you open and close the feed side shut off, or cycle the pressure...
Replies: 7
Views: 766
Posted By h15gus

1/2" 9D-M3 Backflow preventer replacement

I am going to be replacing my 9D also, and I have a question about the procedure.

Is there anything I need to do to avoid getting air into the system - once I isolate the 9D, remove and replace do...
Replies: 17
Views: 9,886
Posted By h15gus

Got it..

I used two C clamps with a steel bar across the shaft to gently push it through the bearing. Seemed much gentler than hitting with a mallet, and it broke free from the bearing just fine. I had a...
Replies: 17
Views: 9,886
Posted By h15gus

Bearing question

I'm in a similar situation with my blower, l need to repair impeller on a TroyBilt 42012. I have it all apart, and housing separate from the tractor. Pulley is off, woodruff key is out, bearing...
04-07-09, 08:50 AM
Replies: 3
Views: 3,069
Posted By h15gus

Thanks

Thanks for the info. I thought the injector was a wear item, and as I have high iron the white injector nozzle and throat certainly do get dirty and discolored (black and red). can I just clean...
04-04-09, 08:13 PM
Replies: 3
Views: 3,069
Posted By h15gus

Fleck 5600se maintenance

A few questions regarding a 5600se.

I just did my first attempt at yearly maintenance n a 2 year old softener, the installer did the first year free.

I purchased all the necessary O-rings,...
01-12-09, 08:44 AM
Replies: 5
Views: 1,054
Posted By h15gus

good question - I'm not sure, but the marks are...

good question - I'm not sure, but the marks are so widespread that its more like wherever the water has splashed rather than where the soap is. There is no concentration of the marks at low level vs...
01-12-09, 07:16 AM
Replies: 5
Views: 1,054
Posted By h15gus

A big no - doesn't wipe off easily at all. It...

A big no - doesn't wipe off easily at all. It seems to be water spots, but almost like etching as I cant remove them with any typical houshold cleaners. I also notice it on the chrome fixtures, and...
01-11-09, 07:04 PM
Replies: 5
Views: 1,054
Posted By h15gus

Water Softener and Nuetralizer question

I have a Calcite/Corosex neutralizer followed by a fleck metered Potassium Chloride softener that have been operating for just over 2 years now. System was installed due to medium hard water,...
04-06-08, 07:43 AM
Replies: 1
Views: 1,037
Posted By h15gus

How to change softener salt type

Can someone advise me if I can just change from Potassium Chloride salts to Sodium Chloride salt at any time, or do I have to empty the salt tank and then switch to NaCL salts.

I'm having no...
05-24-07, 09:48 AM
Replies: 5
Views: 2,562
Posted By h15gus

Ok - I have more information that I hope someone...

Ok - I have more information that I hope someone can help me with. I was concerned that the conditioning system was not working right and that also maybe the water quality had changed since last...
03-12-07, 11:15 AM
Replies: 5
Views: 2,562
Posted By h15gus

The smell definitely comes from Hot and Cold...

The smell definitely comes from Hot and Cold water. We smell it in the shower and when we use the garden hose. We only drink the water from our fridge door which has an internal carbon filter and...
Replies: 7
Views: 4,260
Posted By h15gus

The installer finally came over and said he could...

The installer finally came over and said he could see nothing wrong with the unit, and the flame looks good. He said the gasket looked OK but has ordered another and will replace it next week.
...
Replies: 7
Views: 4,260
Posted By h15gus

Thanks, I'll get them in this week to take a look...

Thanks, I'll get them in this week to take a look at it.
Replies: 7
Views: 4,260
Posted By h15gus

Question Smoke/flue gas smell in basement

I have a 6 month old house and have just started to notice a sort of flue gas smell in the basement - not so much smoke - but it smells like products of combustion. It is not too strong, but...
Showing results 1 to 25 of 40
 


 
Forum Jump