Search: Posts Made By: Digger140
Showing results 1 to 25 of 25
Search took 0.01 seconds.
12-19-13, 06:09 PM
Replies: 3
Views: 977
Posted By Digger140

Thanks for your response, I removed all three...

Thanks for your response, I removed all three caps and the only spark i get is the center burner. bright blue spark lift the center burner up a half inch and the right burner works perfect and...
12-18-13, 03:32 PM
Replies: 3
Views: 977
Posted By Digger140

Angry no spark

I have a Frigidaire Stove Model FPGF3081KFK. The front right Power Plus Boil Burner has no spark unless I remove the center oval 5th burner, then it works. When I replace the oval 5th burner, there...
Replies: 3
Views: 687
Posted By Digger140

we were on a camping trip went to make coffee in...

we were on a camping trip went to make coffee in the morning and that was it. the cables are clean and power windows do work
Replies: 3
Views: 687
Posted By Digger140

Unhappy 2007 chevy avalanch won't start

Hi I pluged in a coffee pot into a power inverter and blew something. I have no power to the dash, no fuel pump noise and no starter(will not even click) all fuses are good; any ideas please help....
Replies: 2
Views: 775
Posted By Digger140

Transmission Replacement

I have a 95 GMC jimmy 4.3 W 4/4 with a bad tranny,I looking to find out which years fit. Thanks
Replies: 3
Views: 1,067
Posted By Digger140

Smile bad idle

Replaced the cpi fuel return lines (leaking) runs good now. Good for another 200k miles
Thanks for the help BOB.
Herbie
Replies: 3
Views: 1,067
Posted By Digger140

GMC jimmy engine problem

HI. I just bought a 1995 GMC jimmy 4.3 with 200k miles for a work truck. Runs fine with good power, the problem is if it idles for five or ten minutes it loads up (black smoke) and idle is bad. If...
Replies: 6
Views: 805
Posted By Digger140

I own this truck a few years I only drive 4...

I own this truck a few years I only drive 4 blocks (city) to work and back and sometimes 20 miles to another work location which is highway. i never checked mileage close before but i always got...
Replies: 6
Views: 805
Posted By Digger140

Angry bad fuel mileage

Hi I have a 1998 GMC sonoma 4.3 truck runs good but i only get around 150 miles on a tank of gas. Tune up was done a few months ago, no codes and no check engine light. any help will be appreciated...
02-15-07, 02:35 PM
Replies: 4
Views: 6,335
Posted By Digger140

Pentagon window blinds or shade

Hi All I have a 6ft x 3ft pentagon window over my sliding doors, looks nice but the sun & light kills the tv .computer with the glare. I had the window tinted. Helped the heat but not the glare. Is...
Replies: 6
Views: 1,498
Posted By Digger140

Smile fuel pressure

Hi guys I opened the relief on the fuel guage and cycled with key on. only got about a shot glass of fuel. I changed the pump. starts fine now. Thanks for all the help.

I Dont no why a $...
Replies: 6
Views: 1,498
Posted By Digger140

The fuel pressure running is 50lbs i have the...

The fuel pressure running is 50lbs i have the 4.3 with the cpi (spider injector) under the plenom where do i check with the noid light? Also with key on the pressure is 60 dropsto 40 within a...
Replies: 6
Views: 1,498
Posted By Digger140

Angry fuel pressure

Hi I have a 1995 GMC jimmy 4.3 W engine. Wont Start. Fuel pressure is 60lb with key on but drops to 54 when cranking,hit it with a shot of carb cleaner and it starts and runs fine at all speeds...
Replies: 3
Views: 1,363
Posted By Digger140

pressures

Thanks guys The gauge goes from 180 deg down to 130 and back up to 180-195 when boiler cycles, after it shuts off the temp goes up to 220 deg and the highest it was 235 deg. (the boiler was running...
Replies: 3
Views: 1,363
Posted By Digger140

boiler pressures

Hi I have a Weil Mclain HEll boiler with baseboard hot water the gauge on the side of the boiler, after heat cycle is 235 psi and the bottom pressure is 35 psi Is this normal? I have a prv...
Replies: 2
Views: 1,000
Posted By Digger140

I picked up A new cap from the GM dealer today ...

I picked up A new cap from the GM dealer today The vaccume hose from the back of the intake to the thing mounted on the underside of the hood. (plastic ball) I will see if the cap helps Thank you.
Replies: 2
Views: 1,000
Posted By Digger140

GM engine code

I have A 95 blazer 4.3 w with a po441 code Had a vaccume hose replaced and light turned off the next day the light is back on.Can anyone help me?

Thanks
Replies: 6
Views: 965
Posted By Digger140

Smile On the road again Just like willie

:) All fixed I replaced both bearings. rotors and pads
Thanks for the help.
Replies: 6
Views: 965
Posted By Digger140

Honda Accord front rotor r/r

I have a 92 Honda accord and i am trying to replace the front rotors I removed the caliper. pads. caliper mounting bracket. axle nut. lower ball joint from spindle. removed the four bolts from the...
Replies: 2
Views: 936
Posted By Digger140

covering header

I made two small rooms into one big room, we installed a header. I want to cover with a 1x10 pine to stain, I will have a seam in the middle any ideas how i can minimize the seam? (cut At 45 and...
Replies: 2
Views: 819
Posted By Digger140

No Spark

1999 Chevy Blazer. 4.3

No spark, has pulses at crank sensor, has spark at coil wire,but No spark at plug wires. Always had trouble in damp weather. Cap and rotor look good, but will change...
Replies: 1
Views: 763
Posted By Digger140

dirty windshield

I have a 87 buick Le Saber the plastic broke on the turn signal arm for the washer does that
arm pull out of the switch, or does it ha
ve a screw under steering wheel?


Thanks
Replies: 2
Views: 775
Posted By Digger140

Smile toilet flush

I got a kohler #85160 flapper kit works fine now

Thank you Herbie
Replies: 1
Views: 818
Posted By Digger140

Heater control

I have a 95 GMC jimmy and the heat and air blows from the defroster (at windshield) only checked heater control switch all vaccume lines are on and switch looks to be working any ideas ...
Replies: 2
Views: 775
Posted By Digger140

toilet flush

I have a kohler toilet I flush ,the flapper opens the bowl emptys the bowl fills the bowl emptys the bowl fills the bowl emptys for the third time and fills then the flapper closes I changed...
Showing results 1 to 25 of 25


 
Forum Jump