Search: Posts Made By: trotter
Showing results 1 to 25 of 200
Search took 0.37 seconds.
Replies: 7
Views: 307
Posted By trotter

Yes I was wondering the same since some videos...

Yes I was wondering the same since some videos show direct nailing into it an others dont.
-I did see on one GAF link --Fastener must NOT cover self seal -
On instructions-
Apply fasteners within...
Replies: 4
Views: 335
Posted By trotter

I've done my research an will make a mix with...

I've done my research an will make a mix with this .
-same ingrediants an anti fungal /anti algie/mold properties as wet n forget an I can make it as weak or stronger.Its 3 times stronger...
Replies: 4
Views: 335
Posted By trotter

Solution mix to help with mold

I've looked at that wet an forget stuff to use on vinyl fence an wondered if it really works.
I saw a clip online about using copper sulfate an water in a specific mix as being the same ingredient ...
Replies: 1
Views: 345
Posted By trotter

Nailers/pack

Had a few questions on roofing.
How many nails ,on average,
come in the round coil packs that go in the roofing nail guns ?
An which size galv/ roof nail is recommended for asphalt...
07-22-19, 10:46 AM
Replies: 3
Views: 355
Posted By trotter

Thanks! that's good to know.. Do they still...

Thanks! that's good to know..
Do they still make the double 15 tandem that arent atop each other, like new ones, but are side by side [old ones are]..Was that a upgrade to the design?
An can I...
07-21-19, 09:52 AM
Replies: 3
Views: 355
Posted By trotter

Breaker type /square d

I'm updating my Square d panel iit is from 1980s. .Its a Qoc 20mw 225 L7 series [not homelite] an saw a mix of the older style hook type on some of the breakers while other breakers had the clip...
Forum: Water Heaters
04-16-19, 12:57 PM
Replies: 10
Views: 324
Posted By trotter

Heating elements..not the crud An psi coming...

Heating elements..not the crud

An psi coming to the heater!!

50 ?
Forum: Water Heaters
04-16-19, 09:08 AM
Replies: 10
Views: 324
Posted By trotter

Would it be a good idea if leak is in drain an i...

Would it be a good idea if leak is in drain an i put brass one in,,to look at the elements an flush out tank too?
an what psi should i be getting to it?
Forum: Water Heaters
04-15-19, 10:08 PM
Replies: 10
Views: 324
Posted By trotter

Water heater was off for days ,along with water...

Water heater was off for days ,along with water pressure to it ..when pressure was back on ,it popped something down there at drain causing spray an gravity took over till I emptied it.
An yes I...
Forum: Water Heaters
04-15-19, 07:24 PM
Replies: 10
Views: 324
Posted By trotter

Drain on water heater

I had a leak at the plastic bottom drain area.It was spraying out from inside the heater Is this removable an is therr a gasket behind it..
its plastic spicket type...
Thanks
10-05-18, 04:08 PM
Replies: 3
Views: 346
Posted By trotter

were these like old style back up fuses ?

were these like old style back up fuses ?
Replies: 21
Views: 544
Posted By trotter

I

I'll replace it.
is this a factor to temp in fridge being too warm? Even in regular cooling mode?
Replies: 21
Views: 544
Posted By trotter

Nothing but heat is on ..for the time

Nothing but heat is on

..for the time
Replies: 21
Views: 544
Posted By trotter

I'm in middle of the 30 min wait...although cover...

I'm in middle of the 30 min wait...although cover is off ..
Replies: 21
Views: 544
Posted By trotter

Turned timer dial an yes. ..its heating i felt...

Turned timer dial an yes. ..its heating i felt it....looks as it timer is moving ok
07-07-18, 04:41 PM
Replies: 15
Views: 562
Posted By trotter

Thanks . Yes i meant a double lug ..side by...

Thanks .
Yes i meant a double lug ..side by side at neutral bar not together .
I wonder in 70s 80s where those #4 neutrals were terminated to off the top ..hmmm ?


I guess its not anything...
07-07-18, 08:32 AM
Replies: 15
Views: 562
Posted By trotter

Are they allowed to rehook the wires ,at pole,an...

Are they allowed to rehook the wires ,at pole,an turn power back on without it passing or does there have to be someones signiture,or a inspectors ok, that it is safe to re connect,reinstall meter ,...
07-07-18, 08:18 AM
Replies: 15
Views: 562
Posted By trotter

THE POCOS incoming neutral on their end before...

THE POCOS incoming neutral on their end before weatherhead has 2nd wire ,#4 copper,attatched an that one runs along side of outside of pole ,the primary neutral is in pole to same meter box.Of...
07-06-18, 12:39 PM
Replies: 15
Views: 562
Posted By trotter

Info via neutral

I just wanted to better understand the concept of what the term "parrelel neutral"l is talking about and what the dangers can be from them,if there are.


I may have one but not sure .
Im aways...
07-05-18, 08:40 AM
Replies: 11
Views: 588
Posted By trotter

It got APPROVED. Or must have been inspected in...

It got APPROVED.
Or must have been inspected in order to reconnect!

Power back on .
From what the man reconnecting service wires spoke on ,back then they used to connect a wire to incoming...
07-01-18, 07:53 PM
Replies: 11
Views: 588
Posted By trotter

So if that one from weatherhead terminates in...

So if that one from weatherhead terminates in meter box not attached to neutral bar an new ground coming from rod is attatched at neutral bar is this considered parallel.
Yes i plan to talk...
07-01-18, 06:19 PM
Replies: 11
Views: 588
Posted By trotter

I found out where that wire along side goes. ...

I found out where that wire along side goes.
Its actually #4 copper an goes up to the weatherhead on the outside of pole an connect atop to neutral.
Even did ohms test .
It had a splitbolt ,copper...
06-27-18, 07:52 PM
Replies: 7
Views: 411
Posted By trotter

2011.file Tried to upload it 2011 changes ...

2011.file
Tried to upload it
2011 changes

It didnt go in till 2011 but Aug 7th 2010 was when it was added ...

Cant send link
06-27-18, 01:45 PM
Replies: 7
Views: 411
Posted By trotter

It uses solid or braided Cant load pic.. ...

It uses solid or braided

Cant load pic..

Its brass an used at entry of meterbox for ground .

Added to NEC 2010 250.8
06-27-18, 01:41 PM
Replies: 7
Views: 411
Posted By trotter

Kenny clamp

What is the main purpose of this an is it not required in some areas?
No one local here in the supply houses including techs has even heard of it ,nor do they carry it though its been added to the...
Showing results 1 to 25 of 200
 


 
Forum Jump