Search: Posts Made By: iceman681
Showing results 1 to 25 of 200
Search took 0.03 seconds.
Replies: 3
Views: 515
Posted By iceman681

the tipm is not the pcm. it is the main fuse box...

the tipm is not the pcm. it is the main fuse box under the hood. total integrated power module. and they have a vast amount of issues with them.
Replies: 10
Views: 1,036
Posted By iceman681

best bet is loose connector at switch. use your...

best bet is loose connector at switch. use your tilt if they work with wheel up but not down, need to take covers off. but a blown fuse makes me think trailer issue?
Replies: 4
Views: 1,159
Posted By iceman681

i would look at the crank pulley its self they...

i would look at the crank pulley its self they are known to come apart.
Replies: 12
Views: 1,519
Posted By iceman681

just for giggles try turning the distributor as...

just for giggles try turning the distributor as some one cranks, just to be sure its not a timing thing. also have the fuel gauge on to see if fuel pressure drops. these need 50-55 to open the popit...
Replies: 4
Views: 1,304
Posted By iceman681

best bet is that it is not from the car but...

best bet is that it is not from the car but carried in from critters.
Replies: 10
Views: 428
Posted By iceman681

https://www.youtube.com/watch?v=Zw4yGDf44RM ...

https://www.youtube.com/watch?v=Zw4yGDf44RM
hate to bust your bubble. but the elbow hose that is directly below that is 80% always at fault. feel with you hand while running.
Replies: 9
Views: 352
Posted By iceman681

seals leaking internally, low on fluid, sticking...

seals leaking internally, low on fluid, sticking valve body.
Replies: 5
Views: 1,535
Posted By iceman681

i 100% believe its the mass air flow. but it...

i 100% believe its the mass air flow. but it could just be dirty. try cleaning it first with approved cleaner.
Replies: 7
Views: 435
Posted By iceman681

many people use atf as an engine cleaner. wont...

many people use atf as an engine cleaner. wont hurt if changed soon.
Replies: 15
Views: 635
Posted By iceman681

if that did not fix it then the O2's did not...

if that did not fix it then the O2's did not cause the light. what was/is the codes?
Replies: 12
Views: 401
Posted By iceman681

it depends on the car. best route is if it has...

it depends on the car. best route is if it has an instant mpg try to keep it the highest at all times. if not, do your own math. use the same gas(something you should do anyways) fill up and drive...
Replies: 5
Views: 335
Posted By iceman681

i would check MAF for dirt and make sure the air...

i would check MAF for dirt and make sure the air boot is on right.
Replies: 7
Views: 565
Posted By iceman681

crv's are not to play around with. if the...

crv's are not to play around with. if the compressor fails it will cost you majorly. a full system replacement. and most places will not even put a warranty on it. not a DIY
Replies: 13
Views: 601
Posted By iceman681

why dont you have 14 volts while running?

why dont you have 14 volts while running?
Replies: 13
Views: 601
Posted By iceman681

next time have a second person bang on the tank...

next time have a second person bang on the tank with a mallet. yes they do fail that way. i personaly had a 92 crown vic. when my pump was going out. i just added a subwoofer in the trunk. when ever...
Replies: 10
Views: 540
Posted By iceman681

there is what is called a TSB on this. the...

there is what is called a TSB on this. the bushing in the trans has gone bad tearing up the seal and the axle. all three will need to be replaced. Not a recall. not free. just a very common issue.
Replies: 19
Views: 807
Posted By iceman681

the only preventable way to stop this from...

the only preventable way to stop this from happening is to wear them out before the rust takes hold. rotors are being made to be "softer" for noise control, but makes them rust quicker. too hard on...
Replies: 6
Views: 526
Posted By iceman681

the p1110 could be caused by bad oil. it uses...

the p1110 could be caused by bad oil. it uses oil pressure to operate. so if it gets low or too old it will not perform properly. for the p0420. try driving it harder and useing one type of gas...
Replies: 16
Views: 777
Posted By iceman681

at my work we say 4 years. newer cars demand so...

at my work we say 4 years. newer cars demand so much and these newer batteries are made with thinner plates that break with strong shocks(pot holes). Also older cars had weaker compression so you...
Replies: 3
Views: 1,482
Posted By iceman681

not being a dual sytem makes the problem not with...

not being a dual sytem makes the problem not with air flow. but with proper even heat across the heater core. think of it as a double door. each door leading to left/right. if the left is plugged...
Replies: 2
Views: 322
Posted By iceman681

your pump is going out because you let it get low...

your pump is going out because you let it get low too many times
Replies: 30
Views: 1,248
Posted By iceman681

new radiators come with those have your parts...

new radiators come with those have your parts people. open a box and then they can match it.
Replies: 14
Views: 536
Posted By iceman681

a location would help to answer you. but yes...

a location would help to answer you. but yes buying cheep metal and not getting it hot to remove condensation will do the trick.
Replies: 4
Views: 491
Posted By iceman681

i will say it sounds just like a bad wheel...

i will say it sounds just like a bad wheel bearing. check for play.
Replies: 12
Views: 647
Posted By iceman681

ford still cancels OD with brake application

ford still cancels OD with brake application
Showing results 1 to 25 of 200
 


 
Forum Jump