Search: Posts Made By: jsouth
Showing results 1 to 25 of 200
Search took 0.02 seconds.
Replies: 8
Views: 952
Posted By jsouth

Check your old blade adapter,to see if there is a...

Check your old blade adapter,to see if there is a spacer stuck in the bottom. The spacer does not come with the new blade adapter.If you have one.Hope this helps.

Jerry
Replies: 2
Views: 486
Posted By jsouth

Thanks,Cheese I will give it a try Jerry

Thanks,Cheese I will give it a try

Jerry
Replies: 2
Views: 486
Posted By jsouth

Echo PB500H Backpack Blower

I'm working on this blower,I cannot get it to run off choke.I have clean the carb. 4 times in my ultrasonic cleaner.I have put a new carb. kit,replaced the fuel lines and filter.I have good...
Replies: 16
Views: 17,329
Posted By jsouth

You have 3 fuel lines. the line with the filter...

You have 3 fuel lines. the line with the filter in the tank,goes to the pump side of the carb.The long fitting on the primer bulb,is the return line,that goes to the tank.The other line fits on the...
Replies: 3
Views: 1,014
Posted By jsouth

Sounds like you may have the fuel lines cross.The...

Sounds like you may have the fuel lines cross.The line in the tank with the filter,goes to the pump side of the carb.The primer bulb with the short fitting the line goes to the metering side of the...
Replies: 9
Views: 2,293
Posted By jsouth

Pull the float bowl back off,and shake the float...

Pull the float bowl back off,and shake the float to see if the float has gas in it.If so replace.Hope this helps.

Jerry
Replies: 2
Views: 864
Posted By jsouth

Thanks,marbobj I am going to order that part ...

Thanks,marbobj I am going to order that part

Jerry
Replies: 3
Views: 1,058
Posted By jsouth

Double check the diaphrams to see if they are...

Double check the diaphrams to see if they are installed right.Did you install the metering lever back,did you happen to bend the lever.If it is to high,it will flood the engine.Hope this helps.
...
Replies: 2
Views: 864
Posted By jsouth

Craftsman 4 cycle trimmer

Customer wanted me to repair the starter housing on this trimmer I took it apart ,the rope will retract back in the housing.The spring is not broken.The starter dogs seem loose, the starter...
Replies: 10
Views: 10,220
Posted By jsouth

Sounds like you might have the starter rope round...

Sounds like you might have the starter rope round up on the spool the wrong way.Hope this helps.

Jerry
Replies: 2
Views: 692
Posted By jsouth

Thanks Rough Rooster.I could not find the model...

Thanks Rough Rooster.I could not find the model number under [email protected] went to outdoor distributors and click on [email protected],to find the parts list.Thanks again.

Jerry
Replies: 2
Views: 692
Posted By jsouth

Briggs stratton Tiller

I'm working on this tiller,it needs a new coil.The spark plug wire broke off at the base of the coil.This tiller has points,I want to replace this coil with a electronic ignition coil.The model #...
Replies: 3
Views: 1,778
Posted By jsouth

marbobj,I adjusted the high and low needles...

marbobj,I adjusted the high and low needles again.Finally got the saw to run.It still sprays gas back through the throat of the carb. It has 120# of compression.The muffler and exhaust ports are...
Replies: 3
Views: 1,778
Posted By jsouth

Poulan 2000 chainsaw

I'm working on this chainsaw,I have rebuilt the carb..When I throttle the saw up ,it sprays gas back through the throat of the carb...really bad.I have taken the muffler apart,the sparkarrester...
Replies: 4
Views: 1,138
Posted By jsouth

You may have a air leak,check the cylinder head...

You may have a air leak,check the cylinder head bolts,they may have come loose,causing a air leak.Also check the plastic carb. adapter,to see if it came loose.You may also have a clogged spark...
Replies: 15
Views: 10,239
Posted By jsouth

After checking all the above,they fail to mention...

After checking all the above,they fail to mention that the seat only goes one way.There is a smooth side and the other side has a ridge or groove in it.The smooth side goes up where the needle sits...
Replies: 6
Views: 1,910
Posted By jsouth

I disconnected the throttle,cable from the engine...

I disconnected the throttle,cable from the engine and turn the throttle up all the way with my finger no change.I agree with you cheese,I believe it is in the engine too.Thanks cheese and...
Replies: 6
Views: 1,910
Posted By jsouth

Cheese I remove the shaft no change.I also put...

Cheese I remove the shaft no change.I also put the carb. on another echo trimmer,thinking it might be the carb.that trimmer ran fine.I also change the fuel lines and filter,did not change,the trimmer...
Replies: 6
Views: 1,910
Posted By jsouth

Thanks, Cheese for the info.The weather has been...

Thanks, Cheese for the info.The weather has been to cold to work on it.I will report back later.

Jerry
Replies: 6
Views: 1,910
Posted By jsouth

Echo SRM 230 Trimmer

This trimmer lacks power.I have overhaul the carb,took the muffler off and clean the spark arrester and the exhaust port.The trimmer runs fine at idle and medium speed.At top in the power head...
Replies: 9
Views: 1,132
Posted By jsouth

Try setting the coil to 0.10,0.28 the gap is to...

Try setting the coil to 0.10,0.28 the gap is to wide.Hope this helps.Also make sure the coil is not installed upside down.

Jerry
Replies: 8
Views: 1,301
Posted By jsouth

First take the spark plug wire off the plug.Tilt...

First take the spark plug wire off the plug.Tilt the mower on it,s side with the carb up.Check for loose blade,if the blade is tight,check to see if the belt has come off the pulley on the blade...
Replies: 4
Views: 845
Posted By jsouth

Sounds like a clog muffler,take the muffler off...

Sounds like a clog muffler,take the muffler off and check the spark arrester screen, in the muffler.Hope this helps

Jerry
Replies: 4
Views: 953
Posted By jsouth

Put 2 gaskets on the air cleaner,in front of the...

Put 2 gaskets on the air cleaner,in front of the carb. where the air cleaner bolts to the carb.The air cleaner can warp causing the primer bulb not to work.Part #795629.Hope this helps.

Jerry
Replies: 7
Views: 9,331
Posted By jsouth

That is what by carb. looks like.Now take the...

That is what by carb. looks like.Now take the carb. off and cut horizonally across both screws until you make slots for a flat screw driver in the adjustment screws,.Like I said in the above post,it...
Showing results 1 to 25 of 200
 


 
Forum Jump