Search: Posts Made By: h45acpwt
Showing results 1 to 19 of 19
Search took 0.01 seconds.
Replies: 0
Views: 274
Posted By h45acpwt

intellicon heat manager showing very high run hours

I have a Weil-McLain wgo-4 boiler using a Honeywell R7184U controller. A bunch of years ago I had a Intellicon hw+ installed and it did not work properly. Via this forum I discovered two wires were...
Replies: 2
Views: 1,475
Posted By h45acpwt

Thanks, I'll take a look inside and see what I...

Thanks, I'll take a look inside and see what I can do.
Replies: 2
Views: 1,475
Posted By h45acpwt

kenmore dryer lint screen is stuck

Kenmore model 110.86562501

Today we could not remove the lint screen the normal way. We pulled the plastic vent panel inside the dryer that is in front of the lint screen and was able to remove...
Replies: 1
Views: 767
Posted By h45acpwt

Kenmore range element/switch problem

We have a kenmore 790.9661340a glass top range. The left front burner is a big one. The switch has a simmer select setting with associated light.

Tonight when turning on the burner with the switch...
Replies: 7
Views: 1,193
Posted By h45acpwt

Been a while since I started this topic. I...

Been a while since I started this topic. I ordered a new shaft for $5 and it arrived today. Does the same thing as the old shaft and looks just the same. I removed about 8 screws from the bottom of...
Replies: 7
Views: 1,193
Posted By h45acpwt

You have the correct number 72180413500.

You have the correct number 72180413500.
Replies: 7
Views: 1,193
Posted By h45acpwt

kenmore microwave shaft replacement

My Kenmore microwave/range hood 721.804135 turntable drive shaft is being pushed up during rotation and pushing the turntable up so it does not lay flat. I can't tell if the shaft is broken off too...
Replies: 19
Views: 2,001
Posted By h45acpwt

it works!

I installed a Reliance THP201 freeze alarm which has a 45F temp alarm, a power loss alarm and an accessory alarm which is normally used with a water sensor module. I soldered two more wires in...
Replies: 19
Views: 2,001
Posted By h45acpwt

NJ Trooper you are correct. The little buttons...

NJ Trooper you are correct. The little buttons are push in to release a captured wire. I did force a fault and there is continuity on the alarm circuit when the green led is flashing and no...
Replies: 19
Views: 2,001
Posted By h45acpwt

Thanks. My next test will be to force an alarm...

Thanks. My next test will be to force an alarm and see if the circuit goes closed.
Replies: 19
Views: 2,001
Posted By h45acpwt

Here is a closeup of the lower left corner. Does...

Here is a closeup of the lower left corner. Does this look like the alarm connector?
Replies: 19
Views: 2,001
Posted By h45acpwt

Here is the new pic of the r7184u1004. Ignore the...

Here is the new pic of the r7184u1004. Ignore the tin foil like stuff on the left side, it is a reflector so I can see the green led from the door to the house.

I know the top right is the three...
Replies: 19
Views: 2,001
Posted By h45acpwt

Well I guess I am a bit confused (not unusual). ...

Well I guess I am a bit confused (not unusual).

Here is a pic of my r7184.

In the upper right is the 3 pin connector for the envircom.

Screw terminals are below it.

On the left is the...
Replies: 19
Views: 2,001
Posted By h45acpwt

I looked at the alarm connection points on my...

I looked at the alarm connection points on my r7184u and I can't really see how they connect. There is a opening on the left side of the connector and on the right side is a raised nubbin. They are...
Replies: 19
Views: 2,001
Posted By h45acpwt

I'll have to check that circuit. It would be...

I'll have to check that circuit. It would be great and easy to implement if it is in fact just a open/closed circuit. The alarm circuit uses two solderless connectors so I guess stripped phone cord...
Replies: 19
Views: 2,001
Posted By h45acpwt

I am looking at the Reliance Controls THP201...

I am looking at the Reliance Controls THP201 Phone Call Alarm System Power Outage Freeze Flood Alert which would replace my current Control Products FA-B-CCA. I would consider other units if they...
Replies: 19
Views: 2,001
Posted By h45acpwt

use of alarm circuit on honeywell r7184u

I use a simple freeze alarm to call me by phone when my boiler fails to fire and the temps get too low. It does not have any other sensors. However I would be able to respond much quicker if I could...
Replies: 35
Views: 24,968
Posted By h45acpwt

NJ Trooper, Thanks for the reply. I do not...

NJ Trooper,

Thanks for the reply. I do not have a link to the HW+ instructions but when I typed "line" I forgot to finish it. I went ahead and switched the yellow and red it functions now. However...
Replies: 35
Views: 24,968
Posted By h45acpwt

help with HW+ wiring

I recently purchased the HW+ and had it installed while I had my annual service done. It is not working correctly and I had to disable it. My boiler uses a Honeywell L8148A aquastat.

My problem...
Showing results 1 to 19 of 19


 
Forum Jump