Search: Posts Made By: CDROGER
Showing results 1 to 6 of 6
Search took 0.00 seconds.
Replies: 9
Views: 1,132
Posted By CDROGER

Found hte problem

I put the mag at .010 clearance the spark was still weak and inconsistent.
Next I disconnected this small metal box that was connected to the low oil
sensor and to the kill switch.Walla it...
Replies: 9
Views: 1,132
Posted By CDROGER

All new problem I bought a brand new mag and...

All new problem
I bought a brand new mag and installed it. I spaced it .028 from the flywheel.
Now I have no spark at all. I also installed a new plug. I also tried putting the old mag back on.I...
Replies: 9
Views: 1,132
Posted By CDROGER

10 hp briggs stalls

I think I haven't done a good job explaining the problem. The engine will start
it runs for a couple of minutes it stops. At this point you can prime the carb
with gas it won't start. you can...
Replies: 9
Views: 1,132
Posted By CDROGER

carberator rebuild

I cleaned and re built the carburetor absolutely no change.Anybody else
have an idea.
Replies: 9
Views: 1,132
Posted By CDROGER

10 hp briggs

I took a oil squirt gun poured out the oil and replaced it with gas.I started the engine let it run until it started to stall.I then squirted a little gas in the throat
of the carb and it still...
Replies: 9
Views: 1,132
Posted By CDROGER

10 HP briggs won't stay running

I have a 10 hp briggs on a genrac 5000 generator /Model#205412/0184e1.
It will start and run for about two minutes then stall. I replaced the spark
plug, changed the oil,cleaned the carb and air...
Showing results 1 to 6 of 6


 
Forum Jump