Search: Posts Made By: Amach325
Showing results 1 to 6 of 6
Search took 0.01 seconds.
03-05-11, 06:30 AM
Replies: 4
Views: 20,988
Posted By Amach325

Treadmill fix

I know its a pain, but have you tried moving the treadmill to a another location in the house where you can plug it into a different circuit? Dont use an extension cord during this test.

If...
03-03-11, 05:23 PM
Replies: 3
Views: 2,301
Posted By Amach325

EMT Kick Bends

I have installed a couple of surface mount four square handy boxes in the garage to house duplex receptacles. Since it was in the garage, I ran exposed EMT conduit to feed the handy boxes. The...
Replies: 4
Views: 1,126
Posted By Amach325

Carbonized Bamboo

Many thanks for the quick response. Yes it is carbonized bamboo. I do not have a wear problem with the finish. Again I simply am seeking a method to seal the cracks and joints between planks in an...
Replies: 4
Views: 1,126
Posted By Amach325

Clear overcoat

Question regarding solid bamboo flooring overcoat: My floor is 5/8 thick by 3 & tongue and groove plank purchased from a major national lumber outlet. It has a urethane finish that has been...
03-02-11, 06:13 PM
Replies: 3
Views: 3,867
Posted By Amach325

230V receptacle neutral & ground

As a new member, I was reading back through posts. Great information source!!!! Thanks to all.

I hope it is OK here to diverge slightly from a relatively recent post titled 220 line for an...
02-28-11, 10:59 PM
Replies: 13
Views: 5,840
Posted By Amach325

Grounding and ground loops

When member ElectricJoe stated in the thread below: "All grounds must originate at the first source of OCP." My understanding is this requirement basically ensures that all grounding is a star...
Showing results 1 to 6 of 6


 
Forum Jump