Search: Posts Made By: joed
Showing results 1 to 14 of 14
Search took 0.01 seconds.
08-27-19, 10:46 AM
Replies: 6
Views: 255
Posted By ibpooks

You need to pull 14-2/g cable from the existing...

You need to pull 14-2/g cable from the existing light to light 2, then 14-3/g cable from light 2 to light 1 and from light 1 to switch.

At the existing light match all the colors to each other.
...
08-26-19, 08:46 PM
Replies: 3
Views: 179
Posted By PJmax

I agree. Take those three screws completely out...

I agree.
Take those three screws completely out and see if the inner cast ring will turn out or just slide out.
08-19-19, 09:10 PM
Replies: 4
Views: 380
Posted By PJmax

That's not coax. That's an old piece of cloth...

That's not coax. That's an old piece of cloth covered romex cable.
Be careful.... it could still be live.
08-19-19, 07:36 PM
Replies: 4
Views: 380
Posted By XSleeper

Looks like an old fashioned door jamb switch. ...

Looks like an old fashioned door jamb switch. Pushing the switch closed probably used to make the closet light go out.
08-12-19, 03:59 PM
Replies: 1
Views: 289
Posted By PJmax

That is a floating neutral generator. The neutral...

That is a floating neutral generator. The neutral and ground are not bonded together.
07-30-19, 11:53 AM
Replies: 2
Views: 203
Posted By ibpooks

It will be sufficient for a charger up to 30A @...

It will be sufficient for a charger up to 30A @ 240V (7200W).
Replies: 13
Views: 678
Posted By PJmax

It sounds like a problem with the outside light....

It sounds like a problem with the outside light. Do you have a meter or voltage checker to test ?

Diagram of Joeds wiring.....
107104
Replies: 2
Views: 552
Posted By PJmax

Welcome to the forums. I'm a little...

Welcome to the forums.

I'm a little confused. The Canadian wiring codes are very similar to ours. Ours only allow white to be used for neutral unless it's used as a switch leg. In your case........
06-30-19, 06:44 PM
Replies: 4
Views: 494
Posted By PJmax

I see absolutely no reason not to plug a power...

I see absolutely no reason not to plug a power strip into a UPS.
You should use power strips with no additional surge suppression. Let the UPS supply the protection.
06-26-19, 06:03 AM
Replies: 3
Views: 299
Posted By ibpooks

It is not possible to power the dining room light...

It is not possible to power the dining room light from the kitchen three-way circuit travelers -- they are switched hots, not neutrals. You would either need to have an additional wire between the...
06-13-19, 04:35 AM
Replies: 2
Views: 434
Posted By Pilot Dane

Get a 12 VDC power supply.

Get a 12 VDC power supply.
06-02-19, 07:16 PM
Replies: 3
Views: 630
Posted By ray2047

No, a single 2-conductor cable. You can't. You...

No, a single 2-conductor cable. You can't. You have no neutral, just two hots.
06-01-19, 02:29 PM
Replies: 7
Views: 596
Posted By ray2047

You need 14-3. Power goes to the switch on the...

You need 14-3. Power goes to the switch on the black. Then back to the receptacles on the red.
05-25-19, 10:01 AM
Replies: 3
Views: 482
Posted By pattenp

Technically by code you are not to conceal it...

Technically by code you are not to conceal it because of the removable cover making it a pull point even though there are no splices. It may be possible to replace the box with a sweep 90 if there...
Showing results 1 to 14 of 14


 
Forum Jump