Search: Posts Made By: spott
Showing results 1 to 11 of 11
Search took 0.08 seconds.
Replies: 11
Views: 821
Posted By spott

gil, For me, it just always seemed to solve a...

gil,
For me, it just always seemed to solve a lot of air problems but not being an engineer couldn't explain why but I have been using that pressure for years. I started doing it when the wet rotor...
Replies: 11
Views: 821
Posted By spott

D, It is fine to leave your freshly filled...

D,
It is fine to leave your freshly filled system for the summer. I would recommend 20 psi as your operating pressure. That 15 psi on your feed valve is what they come factory set at but are...
Replies: 11
Views: 821
Posted By spott

D, You must bleed the air from the system to...

D,
You must bleed the air from the system to restore heat.

First, you do this with the boiler off. Then you close the yellow handle valve on the return and open the one on the cold water...
Replies: 11
Views: 1,715
Posted By spott

D, You should be able to get water out of your...

D,
You should be able to get water out of your boiler valve unless as gil said , it is blocked. What you can try is to shut your yellow handle ball valve off on the return line under your drain...
Replies: 11
Views: 1,715
Posted By spott

D, Only the vent cap, not the vent. If you...

D,
Only the vent cap, not the vent. If you remove the vent, system water will come out with no way to stop it until the water gets below that level.

On a side note if you are draining the...
Replies: 11
Views: 1,715
Posted By spott

D, You should be able to drain some from the...

D,
You should be able to drain some from the faucet on the boiler if you want to drain the whole system. You may be pulling a vacuum and need to let air in to release it. If you put a bucket under...
Replies: 14
Views: 2,067
Posted By spott

You do not need a ZC panel. Your pump will only...

You do not need a ZC panel. Your pump will only come on when either stat calls if wired properly with the stock I've listed. The end switches from your ZV's will go to TT on the boiler just as your...
Replies: 10
Views: 1,592
Posted By spott

C, As was mentioned you did pull a vacuum....

C,
As was mentioned you did pull a vacuum. What you can try shut off the yellow supply valve before the green flo control valve and open the one after and then open that spigot also to break the...
Replies: 10
Views: 1,592
Posted By spott

C, By closing the valves on the supply and...

C,
By closing the valves on the supply and return lines of the zone you are working on no water can enter that zone and you don't have to shut anything else off. You are fortunate to have valves in...
Replies: 10
Views: 1,592
Posted By spott

c, You do not have to close off those circled...

c,
You do not have to close off those circled valves. Close off the BLUE valve above the green pump on the return and one of the YELLOW valves after the SPIROVENT on the supply side, whichever one...
Replies: 12
Views: 397
Posted By spott

a, That tank should be charged to at least...

a,
That tank should be charged to at least 12spi. You can check the tanks pressure with an air pressure gauge. In order to check or charge the tank correctly it must be isolated from the system.
...
Showing results 1 to 11 of 11


 
Forum Jump