Search: Posts Made By: HomebrewMN
Showing results 1 to 17 of 17
Search took 0.01 seconds.
01-09-15, 06:54 AM
Replies: 9
Views: 5,101
Posted By HomebrewMN

Thank you to all that replied. Pilot Dane good...

Thank you to all that replied. Pilot Dane good call on the dialing down for the Better Bottle vs Glass Carboy. I never even thought about the pressure a 600 gph pump would have on a Better Bottle....
01-08-15, 11:51 AM
Replies: 9
Views: 5,101
Posted By HomebrewMN

How can I install a plug-in on a 12v Bilge Pump?

I bought a 600 gallon bilge pump to use for a carboy cleaner for home brewing. The bilge pump I purchased is a Shoreline Marine 12V pump with the following specifics: Volts DC 13.6 - Operating...
Replies: 33
Views: 3,354
Posted By HomebrewMN

Do you guys have any suggestions for sealing the...

Do you guys have any suggestions for sealing the exposed foam after drilling in the partition of the refrigerator? Some have suggested Foil Tape?
Replies: 33
Views: 3,354
Posted By HomebrewMN

The plan is to bring the Kegerator into the...

The plan is to bring the Kegerator into the kitchen and park it at the end of kitchen. We wanted the kids to be able to use it too. So we want to trim the doors with a mahogany trim and paint it a...
Replies: 33
Views: 3,354
Posted By HomebrewMN

So I've basically come to the conclusion that...

So I've basically come to the conclusion that this project is going to work. It's been done before. Kegerator Conversion - HopHeadSaid (http://www.hopheadsaid.com/geeky-stuff/kegerator-conversion)...
Replies: 33
Views: 3,354
Posted By HomebrewMN

Do you suggest I stick with original plan and...

Do you suggest I stick with original plan and drill four holes - one in each corner? Place a muffin fan in the front or back? What should I set the thermostat dial in the fridge and the freezer at?
...
Replies: 33
Views: 3,354
Posted By HomebrewMN

So if I'm understanding you correctly the fan...

So if I'm understanding you correctly the fan installed toward the front would blow toward the top of the freezer? This would pull the warm air from the fridge. Like a box fan in a window.

Do you...
Replies: 33
Views: 3,354
Posted By HomebrewMN

Should the fan blow air down into the fridge from...

Should the fan blow air down into the fridge from the freezer or up into freezer from the fridge?

Do you suggest something like the Attwood Quiet Blower (White, 4-Inch) (links below) to use as a...
Replies: 33
Views: 3,354
Posted By HomebrewMN

So here is what I've got. I believe the partition...

So here is what I've got. I believe the partition is hard Styrofoam. Pictures below. No problem with regards to drilling through the partition, right? (Just make sure not to drill where the fridge...
Replies: 33
Views: 3,354
Posted By HomebrewMN

How or what would you power the fan too? Any...

How or what would you power the fan too? Any suggestions on the size of the holes? Thanks for making this project possible you guys. Wish we were neighbors. The beer would be on me!
Replies: 33
Views: 3,354
Posted By HomebrewMN

So in your honest opinion if there isn't anything...

So in your honest opinion if there isn't anything relevant within the partition would you just cut the partition out? What about moisture problems will I have any moisture problems if I decide to...
Replies: 33
Views: 3,354
Posted By HomebrewMN

PJMax Do you suggest I buy a temperature control...

PJMax Do you suggest I buy a temperature control for the fridge?

PilotDane How do I drill holes in the partition without wrecking anything? Is there some kind of test you can do to see the lines...
Replies: 33
Views: 3,354
Posted By HomebrewMN

Red face PJmax Below are the pictures of the thermostat....

PJmax Below are the pictures of the thermostat. The little white wire runs along the inside of this compartment that attaches to the top of the refrigerator ceiling. It ends at the vent and does not...
Replies: 33
Views: 3,354
Posted By HomebrewMN

Pilot Dane do you have specs and a build for your...

Pilot Dane do you have specs and a build for your fermentation chamber? I've been also looking to do a fermentation chamber and would love to be able to lager and set temps for 67 degrees.
Replies: 33
Views: 3,354
Posted By HomebrewMN

PJMax the link did not post. Can you link it up...

PJMax the link did not post. Can you link it up again and I can take some pictures for you? Thank you for all your help. Good replies from all.
Replies: 33
Views: 3,354
Posted By HomebrewMN

The reason I want them higher so we can use it as...

The reason I want them higher so we can use it as a beer and influx fridge. I also have kids. Out of reach out of mind. Even though my kids are well behaved. But our thoughts were either way it would...
Replies: 33
Views: 3,354
Posted By HomebrewMN

How do I achieve fridge temperature in my freezer for a fridge/freezer?

I am revamping our garage Fridge which is a Fridgidaire Model No. FRT15B3AW9 and converting it into a two tap kegerator. Because the model is small I would like to mount the taps at chest height...
Showing results 1 to 17 of 17


 
Forum Jump