Search: Posts Made By: j400
Showing results 1 to 25 of 93
Search took 0.02 seconds.
Replies: 3
Views: 1,038
Posted By j400

No the plug isnt wet, it will not turn over...

No the plug isnt wet, it will not turn over enough to get gas to the plug, the oil level is correct, and yes it will spin over with the plug removed
thanks
Replies: 3
Views: 2,634
Posted By j400

03 silverado front end noise

I have a 03 silverado z71 5.3 100k mi, auto, I have a sort of rattle in the front end sounds to be on the driver side, I have checked and rechecked everything under the front end but have found...
Replies: 3
Views: 1,038
Posted By j400

13 hp Kohler

I have a mower with a 13hp kohler engine, the engine will not turn over completely, like its compression locking, I removed the valve cover and if I put the right amount of tension on the exhaust...
Replies: 6
Views: 1,281
Posted By j400

Upon further inspection I have noticed it is in...

Upon further inspection I have noticed it is in fact loosing about two cups of water, and the exhaust is heavy steam, I hooked up a code reader and its saying misfire on cylinder two, so its probably...
Replies: 6
Views: 1,281
Posted By j400

Its a new radiator (old cap), and yes I removed...

Its a new radiator (old cap), and yes I removed the thermostat thinking it may have been the cause, and also it bubbles air into the coolant resivoir as soon as it is started.
Replies: 5
Views: 687
Posted By j400

Have you tried to turn the bolts from the...

Have you tried to turn the bolts from the backside, this may free them up, I have changed some before that have splines on the bolts that lock into the strut when you tighten it and they were...
Replies: 6
Views: 829
Posted By j400

If its a standard may be the clutch safty switch.

If its a standard may be the clutch safty switch.
Replies: 6
Views: 1,281
Posted By j400

98 nissan altima getting hot

I am working on my 98 Nissan Altima 4cyl auto the raidator had to be changed because the tank busted, now it runs hot about 40 minutes after its started, it has no thermostat, the low speed fans are...
07-13-08, 07:44 PM
Replies: 3
Views: 1,879
Posted By j400

Replace support wall with beam

I am considering removing a 20' supporting wall in my home to have a larger living room. The house is a two story and this wall supports the up stairs support wall to the roof, my question is what...
Replies: 2
Views: 2,645
Posted By j400

Ok got the noid light hooked it to the injector...

Ok got the noid light hooked it to the injector harness, light stayed on continously while engine running indicating injector staying open, so I changed the ecm had some issues with programming it to...
Replies: 2
Views: 2,645
Posted By j400

99 s10 P0200

99 chevy s10 2.2 cly 5spd, engine running rough, number 2 plug soaked with gas only , changed injector still same thing, scaned codes got back p0200 (injector circuit) so now we have hit a dead end,...
Replies: 6
Views: 1,834
Posted By j400

99 s10 to rich on #2

99 chevy s10 2.2 245,000 mi,
I have a 99 s10 the other day for no aparent reason it started running rough an started smoking,I pulled the plugs and the #2 plug was drenched with gas I check the...
01-18-08, 03:29 PM
Replies: 11
Views: 3,203
Posted By j400

Ok big mistake on my part, I must have had the...

Ok big mistake on my part, I must have had the meter on DC and it read 24.6v which was really 246vAC, which tstat wires should I hook to, its a four wire, cause I can only find 240vac at the blower,...
01-18-08, 02:56 PM
Replies: 11
Views: 3,203
Posted By j400

That is how I had it hooked up, I checked it with...

That is how I had it hooked up, I checked it with a meter an it has 24v but when I turned it on it started buzzing and then smoking, is it possible to hook them up backwards there was only 24v there...
01-18-08, 02:07 PM
Replies: 11
Views: 3,203
Posted By j400

I didnt have the 115v hooked up at all only the...

I didnt have the 115v hooked up at all only the 24v, and the setup Im using doesnt have a coil, just a relay,thanks
01-17-08, 04:12 PM
Replies: 11
Views: 3,203
Posted By j400

Ok tell me where I messed up, I picked up at the...

Ok tell me where I messed up, I picked up at the fan relay at 24v one on hot and one on common ran it to a 24v/115 relay by the booster fan and when I turned the tstat on (fan only) it burned up the...
Replies: 2
Views: 1,028
Posted By j400

Not sure where it should plug to but Im pretty...

Not sure where it should plug to but Im pretty sure that is the kill wire
01-14-08, 08:10 PM
Replies: 11
Views: 3,203
Posted By j400

Sounds like a good plan I will give it a shot,...

Sounds like a good plan I will give it a shot, thanks
01-14-08, 03:40 PM
Replies: 11
Views: 3,203
Posted By j400

My blower is 220 but the relay is built in it,...

My blower is 220 but the relay is built in it, the only wires going to it are a yellow common and a black where you choose the fan speed, and they are only 16ga wires
01-14-08, 02:18 PM
Replies: 11
Views: 3,203
Posted By j400

a/c booster fan

I installed a booster fan in my a/c - heat duct, I was wanting to know how to wire it where it would come on when the unit does? its a 115v fan, thanks
Replies: 6
Views: 1,617
Posted By j400

I had the same problem on my 19 hp b&s, the...

I had the same problem on my 19 hp b&s, the valves were out of adjustment not allowing the motor to turn over but a few times then compression locking, I have to adjust them about twice a year.
Replies: 2
Views: 3,242
Posted By j400

Got it fixed the inside a/c coils were comepletly...

Got it fixed the inside a/c coils were comepletly covered with what looks like dog hair, and the clicking was the flap for the fresh/rec air is broken.
Replies: 8
Views: 12,138
Posted By j400

In doing a head gasket replacement, when you put...

In doing a head gasket replacement, when you put new intake gaskets they have block off plates on the gaskets that need to be removed or left in place depending on where the heater hose is connected,...
Replies: 2
Views: 3,242
Posted By j400

94 chevy truck no air out vents

I have just bought a 1994 chevrolet 1500 5.7 auto. The problem is that the air or heat doesnt blow out anywhere, the fan blows but the air doesnt come out like it should, it looks like the previous...
Replies: 2
Views: 1,741
Posted By j400

get some radiator flush from the parts store,...

get some radiator flush from the parts store, first drain the radiator (with the engine cool) pour flush chem. in then top off with water, let run for about ten min. then let cool, drain again refill...
Showing results 1 to 25 of 93
 


 
Forum Jump