Search: Posts Made By: edge10
Showing results 1 to 25 of 196
Search took 0.03 seconds.
08-15-19, 07:07 AM
Replies: 10
Views: 398
Posted By edge10

Do you brand of new capacitors you usually go...

Do you brand of new capacitors you usually go with - M, J, G (which is OEM) or other? Since they don't make them like they used to, I'll test and only replace capacitors as needed. I get/keep...
08-14-19, 06:48 AM
Replies: 10
Views: 398
Posted By edge10

Is there anything else I should do for preventive...

Is there anything else I should do for preventive maintenance on this unit? Should I replace the start and run capacitors for the fan and compressor ? They look like the originals and the terminals...
08-12-19, 10:28 AM
Replies: 10
Views: 398
Posted By edge10

Yes, both compressor and condenser fan stay...

Yes, both compressor and condenser fan stay running with the raised setpoint or turning off the control at the t-stat.

Turns out the contactor is bad. I cleaned the contacts with cleaner for temp...
08-12-19, 08:58 AM
Replies: 10
Views: 398
Posted By edge10

No, they are both continuously running. I shut...

No, they are both continuously running. I shut off the stat and freeze up stopped initially with the condenser fan running. However, just checked and I got freeze up again with the stat in the same...
08-12-19, 08:38 AM
Replies: 10
Views: 398
Posted By edge10

Trane xl1200 Condenser Fan on Continuosly - Line Freeze up

I have a model TT036C100A0 that has a frozen line running to the evaporator. The air filter is not plugged and the vents flow freely. The condenser fan and compressor is running continuously and I...
12-12-18, 07:04 PM
Replies: 7
Views: 616
Posted By edge10

Thanks for the input. I took a couple additional...

Thanks for the input. I took a couple additional zoomed pics. Hopefully this will help make things a little clearer. Otherwise I'll have to get on the ladder for a closer look.
...
12-03-18, 12:00 PM
Replies: 7
Views: 616
Posted By edge10

It looks like the black insulation is peeling...

It looks like the black insulation is peeling away to me and gray layer is showing. It also looks like drip loop is after the splice and then goes into the weatherhead. Tree has since been pruned...
12-03-18, 08:37 AM
Replies: 7
Views: 616
Posted By edge10

Repair Insulation on Overhead Service Wire Drip Loop - New Jersey PSEG

The insulation is peeling off on the drip loop portion of the overhead service wire to the house (residential) and looks like it should be repaired. This this is wire located just before in enters...
Replies: 11
Views: 496
Posted By edge10

Which Size Compound Sliding Miter Saw ?

I am in the market for a miter saw and would like to get some input on a 7 1/4 vs 10 inch. The saw would be used for general DIY jobs around the house and would get light to moderate use. ...
Replies: 0
Views: 276
Posted By edge10

Facia Board Replacement

I need to have a facia board replaced due to rot from a leaking gutter. The facia is wood with covered aluminum trim. What should I look for on the quote from the contractor for materials and spec...
Replies: 3
Views: 309
Posted By edge10

Sounds like the carb pump diaphragm may be bad. ...

Sounds like the carb pump diaphragm may be bad. I have a BT150 , which is similar to the your BT350 . The carb on that blower is a Walbro WYA which uses 2 diaphragms , one for metering and one for...
Replies: 4
Views: 736
Posted By edge10

Reliability of Honda GX390 For a Portable Generator

I would like to input on the reliability on the Honda GX390. This would be for a genset in the 6 - 7000 W range. I know the generator head also has a lot do with the overall reliability, so I will...
11-05-18, 08:50 AM
Replies: 4
Views: 755
Posted By edge10

They could enter other ways, but I am not...

They could enter other ways, but I am not familiar with all of their habits. They could enter by the nearby tree that is 5 ft from to the eve, but previously even when I trimmed it back they still...
Replies: 3
Views: 293
Posted By edge10

Here's a couple of pics. Plan was to put one...

Here's a couple of pics. Plan was to put one hand rail on the left side.

https://www.flickr.com/photos/[email protected]/44977941134/in/dateposted/
...
Replies: 3
Views: 293
Posted By edge10

Handrail For Garage Entrance

I need some input on building a free standing hand rail for a three step stair to garage entry door to the house. The two lower steps are concrete with the third step into the floor of the house. I...
10-29-18, 09:02 AM
Replies: 4
Views: 755
Posted By edge10

How to prevent flying squirrels from entering attic

I had several flying squirrels enter the attic. I think they are climbing the conduit/whether head electrical drop that supplies power to the house and entering the eve or gutter at that corner of...
Replies: 2
Views: 212
Posted By edge10

Robin -Subaru EX21 Decompressor Not Working

I have a Robin-Subaru EX21 that is used on a pressure washer which I have since new. The recoil is hard to pull, so it feels like the decompressor is not working. The unloader valve is not the...
Replies: 0
Views: 496
Posted By edge10

Homelite HP3127S Pressure Washer Pump Leaking oil from Flange Seal

This PW was also sold under Ryobi 80030/80030A. The oil is leaking from the pump flange seal (pump input shaft), so I want to replace the seal. Problem is I can't confirm the OEM Flange Seal P/N...
Replies: 7
Views: 1,062
Posted By edge10

How is Briggs , Kohler availability of repair...

How is Briggs , Kohler availability of repair manuals for newer engines ? I have heard some reports that the repair manual info is lacking on newer engines. Parts availability looks good, but...
Replies: 3
Views: 527
Posted By edge10

I did not plan to add the stone to the bottom...

I did not plan to add the stone to the bottom landing, but did not realize that it would not meet code without it. I probably won't cap it if this is the case. I think the rise on the existing...
Replies: 3
Views: 527
Posted By edge10

Adding Bluestone or Granite to Stoop and Stair Treads

I have an existing 8 w x 4 d ft stoop that is about 50 years old am considering about capping the stoop and stair treads in Bluestone or Granite. The stoop is in decent shape, but given all the...
Replies: 7
Views: 1,062
Posted By edge10

Sounds like it could be the failed governor...

Sounds like it could be the failed governor problem on the MZ360 on that Ridgid genset, which is the brand I am considering. From what I read they over-speed and either throw the rod or seized at...
Replies: 7
Views: 1,062
Posted By edge10

Yamaha MZ360 Quality and Part Availability ?

I am looking at a generator that has a Yamaha MZ360 engine. I would like to get some input from those of you who service or own this engine. I think earlier model engines a few years ago had...
Replies: 0
Views: 304
Posted By edge10

Portico Addition and Roofing

I plan to have a portico added to the front of the house over an existing 8' w x 5 ' d stoop. This will involve cutting in to the house roof to frame and then weave the old with the new roofing...
Showing results 1 to 25 of 196
 


 
Forum Jump