Search: Posts Made By: Skramy
Showing results 1 to 25 of 166
Search took 0.02 seconds.
Yesterday, 07:03 PM
Replies: 6
Views: 298
Posted By Skramy

Sorry to hijack this thread, but I have some what...

Sorry to hijack this thread, but I have some what the same question.

Just got a new boiler installed. About all I need is power to run the circulator and power to the thermostats aquastats to open...
Replies: 1
Views: 100
Posted By Skramy

Weird ceiling light question

The ceiling light in a bedroom has two bulbs. One is incandescent, the other is a compact fluorescent. The incandescent burned out. The fluorescent blinks, with the switch off !?!
I replaced the...
07-11-19, 07:26 PM
Replies: 9
Views: 874
Posted By Skramy

Here is what you need. Maybe. My Pellas were...

Here is what you need. Maybe.
My Pellas were still under warranty. Someone came out and replaced the "catch". (not sure if that is the proper name. could not find the Pella diagram)

But notice...
07-03-19, 03:24 PM
Replies: 7
Views: 970
Posted By Skramy

OP here again. (Finally found my post). Good...

OP here again. (Finally found my post).
Good idea, Pilot.
But reading the lifetime transferable warranty, am not to apply anything to the glass, inside or outside. Except factory applied. And can't...
06-28-19, 08:19 PM
Replies: 7
Views: 970
Posted By Skramy

New Window installed - Way too bright

Just had 2 double hung windows installed. Look gorgeous, eliminated alot of heat transfer.
But It is so bright! I had window tint on my old windows and really miss it. I have sensative eyes and it's...
Replies: 8
Views: 1,416
Posted By Skramy

UPDATE: Arrgh. Thought I had it fixed. I...

UPDATE:
Arrgh. Thought I had it fixed. I attached all wires where it enters the house - separately. Gr to Gr, Red-Red, Blk-Blk, Yell-Yell. All on a new terminal block. No more yellow to ground. Was...
Replies: 8
Views: 1,416
Posted By Skramy

UPDATE: Yeah, I was thinking ground. Or, might...

UPDATE:
Yeah, I was thinking ground. Or, might be a "whisker" between 2 wires (bare wire ends) in a wall. I've seen electronics fail because of an apparent strand of dust.

Anyway, I've got all 4...
Replies: 8
Views: 1,416
Posted By Skramy

Noisy phone land line (hissing) and line wiring question.

I get noise - hissing sound. Random. Ok for months, then every 2 or 3 days, then OK for weeks..There's a box on the outside of the house where I can plug in a phone. There is no noise there. So...
Replies: 5
Views: 300
Posted By Skramy

Clamps! Now there's an idea. Wonder if 2 or 3...

Clamps! Now there's an idea. Wonder if 2 or 3 hose clamps would hold. The motor shouldn't slide, since the 4 little 'bumps' on the bracket fit into the motor housing.

I was thinking of using 2...
Replies: 5
Views: 300
Posted By Skramy

Wire feed. I altered my photo. Bracket was...

Wire feed.
I altered my photo. Bracket was attached where the green dots are.
New replacement motors have the bracket welded where the redstripes are. Much better.

EDIT: After watching a couple...
Replies: 5
Views: 300
Posted By Skramy

Snow Blower with Tecumseh 37000 Starter Motor

I have a snow blower with a Tecumseh 37000 starter motor.
The motor mounting bracket broke off the motor. (see pic) Motor is good, gear is good. Haven't had it apart yet. Watched a couple YouTube...
Replies: 4
Views: 382
Posted By Skramy

Thanks. That was useful. What I learned today:...

Thanks. That was useful.
What I learned today: I have a leaky O-ring. Part #272756 is no longer available separately. Must get 272742 parts kit, or Powerhead Conversion Kit - which also means I...
Replies: 4
Views: 382
Posted By Skramy

V8043 Zone Valve Questions

I have a boiler with hot water baseboards. One of my two V8043 zone valves does not always turn on the main burner. I took the cover off the PowerHead, and the little lever that supposed to contact...
01-21-18, 08:38 AM
Replies: 3
Views: 385
Posted By Skramy

Yeah, I read that online somewhere. ".....has a...

Yeah, I read that online somewhere. ".....has a recessed depth of approximately 1"." Which means the elec prongs are recessed 1".
What I want to know is the exact depth of the entire unit. Or, how...
01-20-18, 07:15 PM
Replies: 3
Views: 385
Posted By Skramy

Midlite 4642 Power Inlet help

Hi,
I am looking for the EXACT measurements of this Midlite 4642W Power Inlet. Especially the DEPTH. Yeah I understand it fits in a standard 14ci box, so I assume it is slightly less than 2"W X ...
Replies: 1
Views: 520
Posted By Skramy

Air Compressor Motor Repair

Hi,
I'm trying to repair my CH air compressor. It's 13gal horizontal. About 20yr old, so not a big loss.
It got extremely noisy couple weeks ago. Removed the little belt so only the motor turned -...
10-05-17, 02:53 PM
Replies: 2
Views: 425
Posted By Skramy

Outdoor Service Receptacle for A/C

For my split unit air conditioner - I need a outdoor w/r tamper proof in-use GFCI service receptacle.
Can I tap off my dining room circuit? There are 3 receptacles on this circuit. That's it.
If I...
05-12-17, 07:39 PM
Replies: 9
Views: 644
Posted By Skramy

Hey PJ, How long of a run have you made with...

Hey PJ,
How long of a run have you made with the tubing? Is 40ft too far?

And, have you ever mounted the condenser on a roof?
My bilevel, the garage roof is about 5 feet below the house roof....
05-05-17, 06:32 PM
Replies: 9
Views: 644
Posted By Skramy

Same gauge wire, eh? Maybe I'll ask the elec...

Same gauge wire, eh? Maybe I'll ask the elec inspector when he stops by. Maybe I won't even mention it.
What surprised me was this:
I used 12-2 romex thru my attic, then UF down to the outdoor...
05-03-17, 07:10 PM
Replies: 9
Views: 644
Posted By Skramy

When I bundle everything together, I'll tape the...

When I bundle everything together, I'll tape the signal cable on the opposite side of the tubing/drain hose from the 12-2 power wire. Separate them the best that I can.
Better work OK.
04-29-17, 06:09 PM
Replies: 9
Views: 644
Posted By Skramy

It's a Senville model 12CD. My signal cable I...

It's a Senville model 12CD.
My signal cable I got from a elec supplier. A nice 4 wire hot cold water resistant thing.
04-29-17, 03:24 PM
Replies: 9
Views: 644
Posted By Skramy

Split A/C unit electrical question

Installing a mini split airconditioner. The power will run thru the attic. Then I planned to run my UF-B down thru the decorative channel along with the tubing and 4-wire 'signal cable' to the...
Replies: 5
Views: 651
Posted By Skramy

OP here again. I miss having that light. Altho...

OP here again.
I miss having that light. Altho disappointed in the price of those bulbs. Costs less for the entire switch.
I have LED's & diodes. Kinda dim tho. I also have a few neon bulbs...
Replies: 5
Views: 651
Posted By Skramy

Garage door button light.

Lighted garage door opener button - light quit working.

I've had this lighted button for years. Light quit working a couple months ago. Today I removed the button switch, and yup burned out bulb....
Replies: 1
Views: 570
Posted By Skramy

Push Mower w/ B&S engine. Primer bulb question.

Have a Poulan push mower with 158cc B&S engine model 10T502

The primer button does not pop back. (Doesn't pop back in my hand either)
Probably need primer button.
In my pic, there are 2 steel...
Showing results 1 to 25 of 166
 


 
Forum Jump