Search: Posts Made By: q0987
Showing results 1 to 25 of 200
Search took 0.03 seconds.
Replies: 2
Views: 84
Posted By q0987

what is the type of the brick mortar?

Hello all,

Can someone tell me the type of mortar used in my house wall?

Thank you
09-08-19, 07:48 PM
Replies: 2
Views: 153
Posted By q0987

Does the gas regulator provide gas shutoff?

Hello all,

I have the maxitrol gas regulator model 1307 88/801097-B.

Question> Dos the gas regular have a switch to turn off gas to the stove or I have to turn off the whole house gas valve in...
09-08-19, 07:44 PM
Replies: 6
Views: 232
Posted By q0987

Little update on my issues. Today, I remove...

Little update on my issues.

Today, I remove the stove gas distributor and found that the fastener holding down the igniter is stuck although the igniter is loose. I fail to tighten or remove the...
09-03-19, 12:22 PM
Replies: 6
Views: 232
Posted By q0987

Hello Pjmax, What you said is that the...

Hello Pjmax,

What you said is that the igniter keeps sparking until the flame is covering the ignitor. If that is the case, then my guess is that the gas flow initially is not strong enough to...
09-03-19, 05:26 AM
Replies: 6
Views: 232
Posted By q0987

My burner doesn't click if I turn it off. ...

My burner doesn't click if I turn it off.

The issue is that if I turn it on, the ignitor keeps beep for a few minutes even if the flame goes on perfectly.

Thx
09-02-19, 08:11 PM
Replies: 6
Views: 232
Posted By q0987

Sorry, the stove is Wolf Gas Stove and the model...

Sorry, the stove is Wolf Gas Stove and the model number is # CT30G/S.

The issues we have are on left side of the stove.

I didn't spray the cleaner on the plate. The cleaning work had been done...
09-02-19, 07:04 PM
Replies: 6
Views: 232
Posted By q0987

Wolf stove beeps for a few minute after each start

Hello all,

My stove starts to develop the following issues after I completely clean the stove with Easy-Off Professional Fume Free Max Oven Cleaner.

The igniter and plate cover are very clean....
Replies: 2
Views: 729
Posted By q0987

Thank you very much for the provided information.

Thank you very much for the provided information.
Replies: 2
Views: 729
Posted By q0987

what is the name of this cabinet fastener?

Hello all,

Can someone tell me the name of these cabinet fastener for melamine?

Thank you
Replies: 1
Views: 302
Posted By q0987

Does car battery tester work on deep cycle marine sump pump battery?

Hello,

I would like to know whether I can use auto battery tester on deep cycle marine sump pump battery load test?

Thank you

DEKA DP31DT BATTERY 31 875CA [email protected] 100AH...
03-04-19, 04:50 PM
Replies: 3
Views: 433
Posted By q0987

Unfortunately, the installer doesn't leave too...

Unfortunately, the installer doesn't leave too much space to slide the pvc pipe so I have to cut in the case where I have to replace the igniter and reconnect the pipes with a 2 in. x 2 in. DWV...
03-03-19, 04:51 PM
Replies: 3
Views: 433
Posted By q0987

Gaining access to Carrier furnace hot surface ignitor

Hello all,

My carrier furnace model is 58MCA060-12.

I was cleaning the furnace while looking for the igniter and found that it was behind the pvc pipe.

Can someone tell me what is the proper...
Replies: 1
Views: 286
Posted By q0987

kohler toilet tank foam crack

Hello all,

I tried to fix the toilet ghost flushing by replacing the flapper. But it turns out that the toilet foam lining cracked and the flapper cannot sit tight again the bottom of the tank.
...
Replies: 4
Views: 569
Posted By q0987

Just found a leak on the old machine. The leak...

Just found a leak on the old machine. The leak has been there a while at least previous house owner doesn't know about it.

Thank you
Replies: 4
Views: 569
Posted By q0987

Can I repair a cracked dishwasher drain hose?

Hello all,

The installer pinched the dishwasher drain hose while installing the machine. I just found the leak source on the hose. The machine is 14-year old and runs good.

Question >
Is it...
Replies: 3
Views: 724
Posted By q0987

Why new philips fluorescent light tubes turn pink?

Hello all,

I just installed philips fluorescent light tubes(32W, 48 inch T8) and found that both tube turn pink. Also, I change the tube installation location and it still shows pink.

What may...
Replies: 10
Views: 386
Posted By q0987

I think the bottom of the shower door should have...

I think the bottom of the shower door should have something similar to this one. So that the water will be blocked from escaping to outside.

Best
Replies: 2
Views: 229
Posted By q0987

Rigid nail gun R213BNE loads magazine with pressurized air

Hello all,

I bought a Rigid pancake compressor with two Rigid nail gun.

Here is what the manual has to say:
<<<<<<<<<<<<<<<<<<<<
The tool’s driving mechanism may cycle when the tool is...
12-17-18, 07:44 AM
Replies: 12
Views: 624
Posted By q0987

Hello all, I made my first cut and ripped...

Hello all,

I made my first cut and ripped 2x4 into 2x2 and it turns out great.
Now, a few new questions pop up.

Q1> What is the main usage of the feather board?
I placed a lot of force on the...
12-12-18, 11:37 AM
Replies: 12
Views: 624
Posted By q0987

Hello aka, Yes, I am new to a table saw and...

Hello aka,

Yes, I am new to a table saw and thank you for your kindness. I will respect the tool and be very careful while I am operating the machine.
...
12-12-18, 10:56 AM
Replies: 12
Views: 624
Posted By q0987

Yes, I bought a Ridgid R4513 table saw a few...

Yes, I bought a Ridgid R4513 table saw a few weeks ago. It comes with a riving knife and anti kick-back claws.

Thank you
12-12-18, 05:38 AM
Replies: 12
Views: 624
Posted By q0987

Table saw feather board location

Hello all,

I have seen this video from a professional woodworker and he used two feather board. One is in front of the saw and the other is in the back of the saw. Based on my understanding, you...
Replies: 5
Views: 766
Posted By q0987

I am using this setup for karaoke. The mixer...

I am using this setup for karaoke.

The mixer is controlled through my PC and all settings are digital. Yes, the mixer can take multiple mic inputs.

If we use the headset output of the mixer and...
Replies: 5
Views: 766
Posted By q0987

Why XR12 has low microphone volume from output Main L&R Jacks?

Receiver: Sony STRDH590
Floor Speaker: Pok Audio T50
Mixer: Behringer X Air XR12
Mic: Behringer Ultravoice Xm8500 Vocal Microphone

In summary, the microphone volume from output Main L&R Jacks...
Replies: 4
Views: 646
Posted By q0987

Hello XSleeper, One of our bedrooms aligns...

Hello XSleeper,

One of our bedrooms aligns with an angle to the hallway. I though I could introduce an transition to separate the floor between room and hallway although both floor will have...
Showing results 1 to 25 of 200
 


 
Forum Jump