Search: Posts Made By: whatisnew
Showing results 1 to 7 of 7
Search took 0.01 seconds.
Replies: 10
Views: 1,235
Posted By whatisnew

NVM...I answered my own question. =) Thanks and...

NVM...I answered my own question. =) Thanks and have a great evening.
Replies: 10
Views: 1,235
Posted By whatisnew

Thank you for your help with the definition. ...

Thank you for your help with the definition. After plugging resistor on all zones (1-8) and the Bell -+, the Ready light popped up. The board is find and it lead me to your initial comments...
Replies: 10
Views: 1,235
Posted By whatisnew

From your response, fault = open? I don't...

From your response, fault = open? I don't understand "orange-orange-red for the first 3 stripes". Basically, I took a resistor and made a U shape to connect one end to zone 1 and the other to COM. ...
Replies: 10
Views: 1,235
Posted By whatisnew

I now remove the last sensor wire from the panel...

I now remove the last sensor wire from the panel and just use a resister for zone1/com to see if anything changes. Unfortunately, zone 1 is still show fault. Any help you can assist is much...
Replies: 10
Views: 1,235
Posted By whatisnew

no should i put a resistor on the remaining...

no

should i put a resistor on the remaining zones (2-8) that don't have anything plug in them?
Replies: 10
Views: 1,235
Posted By whatisnew

I was trying to enable quick ARM. Fumbling...

I was trying to enable quick ARM. Fumbling through the configuration, I suppose to screw up and got the alarm to scream its heart out and scare the kids. At no time did I physically touch the...
Replies: 10
Views: 1,235
Posted By whatisnew

NX-8v2 all zones are faulted

I have a NX-8V2 with an extension board (NX-216) and two display panels (NX-1192E). The whole system was working fine until i press something wrong recently and the Ready light is no longer light up....
Showing results 1 to 7 of 7


 
Forum Jump