Search: Posts Made By: danprtr
Showing results 1 to 5 of 5
Search took 0.01 seconds.
Replies: 7
Views: 1,661
Posted By danprtr

Fixed it finally

You were right Cheese, not a lot of possibilities. Took off the carb and could easily see the valve was not closing all of the way. Had to bend the tab but on close inspectiion, it looked like it...
Replies: 7
Views: 7,895
Posted By danprtr

There is a sprocket at the end of bar which is...

There is a sprocket at the end of bar which is held in place by the same screw and nut that fasten the "Safety T Tip" on my 14" Homelite. Might check to see if you need one of those as well.
Dan
Replies: 7
Views: 1,661
Posted By danprtr

Throttle tab is hitting the casting, not the idle...

Throttle tab is hitting the casting, not the idle screw. Like you said, seems that too much air is making it's way past the throttle valve, especially since covering the air intake with my hand...
Replies: 7
Views: 1,661
Posted By danprtr

Idle adjustment screw was backed out to bare...

Idle adjustment screw was backed out to bare minimum. Could try bending the tab that bumps against the adjustment screw. Should I take off and inspect the carb? Hate to open another can of worms. ...
Replies: 7
Views: 1,661
Posted By danprtr

over revving Briggs 14.5hp IC 280H07

Hello,

Replaced control plate containing throttle cable and governor spring (has a linear gear thingy on the back of it). Got her all hooked up but engine severely over revved on start so shut...
Showing results 1 to 5 of 5


 
Forum Jump