Search: Posts Made By: coopns
Showing results 1 to 25 of 147
Search took 0.03 seconds.
05-19-14, 08:49 AM
Replies: 2
Views: 706
Posted By coopns

Timer Box Install

The old timer went (not sure if it is old). I ordered exact replacement Intermatic T101. I still have it hooked up, I think I can do it, only 3 wires but I'm a bit concerned with it being so close to...
12-12-12, 07:47 AM
Replies: 8
Views: 1,001
Posted By coopns

The unit I removed was just a overhead light. ...

The unit I removed was just a overhead light.

I was thinking about putting the timer inside the bath by the outlet. Snake it down through the wall and I don't know, is there a two outlet/timer...
12-11-12, 11:18 AM
Replies: 8
Views: 1,001
Posted By coopns

I was thinking about the existing wires to the...

I was thinking about the existing wires to the light. Then run another from a timer up to the fan. That work ok?

Just cap off the night light in fan junction box?
12-11-12, 10:28 AM
Replies: 8
Views: 1,001
Posted By coopns

Bath Fan Advice

I have a new Panasonic Fan for the bath. Vent up through roof. Outside the bath I have a switch to turn the light on. Inside the bath I have a GFI near the sink (switch is almost directly across from...
Replies: 2
Views: 2,641
Posted By coopns

Rock wall - shaping rocks

I am planning a rock wall about 3 feet and will transition slope up to 5 feet high and about 40 feet long.

I would like it something like the picture.

I see a lot of walls with rocks that have...
06-01-10, 02:08 PM
Replies: 3
Views: 1,101
Posted By coopns

Would you put some primer on the mastic as well....

Would you put some primer on the mastic as well. Pull off the loose stuff then...primer...then jt. compound?

Thanks.
06-01-10, 10:30 AM
Replies: 3
Views: 1,101
Posted By coopns

Jt. Compound over Mastic?

I pulled off a few tiles from the bathroom that had mastic. Couple pulled off down to drywall, others had mastic still on them. I would like to finish with some Jt. Compound but will it adhere to the...
05-21-10, 07:22 AM
Replies: 12
Views: 1,261
Posted By coopns

So it is a 15 amp circuit I found out. So I could...

So it is a 15 amp circuit I found out. So I could put six cans with 75 watt bulbs? Sound right?

Thanks.
05-20-10, 10:50 AM
Replies: 12
Views: 1,261
Posted By coopns

Recessed Lights - Load Amount

I have one light in the kitchen but want 6 recessed. Will that six recessed handle the load? (Is load the correct word?) Just didn't want to put six cans in they blow the circuit. Is there some...
03-03-10, 11:26 AM
Replies: 4
Views: 1,210
Posted By coopns

Cat Scratching Couch

The cat is starting to scratch our new couch. Any non toxic sprays? Other recommendations?

Thanks.
Replies: 2
Views: 711
Posted By coopns

Scraped down shingles - Type of primmer?

I have cedar shingles that were painted over twice - really old. So I scraped off all peeling paint and then some. Just finished sanding it with 60 grit palm sander. I didn't want to sand off to bare...
03-25-09, 07:36 AM
Replies: 7
Views: 2,134
Posted By coopns

Bamboo tree transfer?

I see some bamboo trees down the road and I would like to get them in my yard. Can you transfer them or their seeds or would it be easier to just buy some seeds?

Thanks.
Replies: 1
Views: 676
Posted By coopns

Measuring Help

I am installing some boards and I have 137 inches under a chair rail. I am going to use 2 '1/4 inch boards and I want probably five or six in that span. How do I space them out? 137/6 is 22.8333333....
Replies: 1
Views: 898
Posted By coopns

Baseboard Heating - Paint?

My baseboard heating is older and currently painted the same color as the wall. The baseboard heating runs the length of one wall then there is the regular wood baseboard which is painted white.
...
07-30-08, 06:17 PM
Replies: 3
Views: 1,159
Posted By coopns

Simmonds or Mowen valve?

I have to replace the mowen valve. Is simmons valve better then the Mowen or does it matter? Is one harder to install then the other?
Replies: 1
Views: 2,019
Posted By coopns

Bonding Paint

I am painting the kitchen cabinets and someone mentioned some bonding type paint to apply prior to painting with final coats. I can't think of the name of it. They are oak with a bit clear coat. Was...
06-22-08, 09:28 AM
Replies: 3
Views: 1,106
Posted By coopns

But where can I buy those products for the...

But where can I buy those products for the chlorine level and algaecide. Is there a brand name?

Thanks.
06-20-08, 09:18 AM
Replies: 3
Views: 1,106
Posted By coopns

Products to clean a 15 x 4 pool?

I have a cheap Walmart special 15 x 4 pool. What are some safe chemicals or other products that I can clean it with? I would prefer non toxic - green type products.

Thanks.
06-16-08, 07:04 AM
Replies: 2
Views: 7,818
Posted By coopns

Can you cut blinds that are too long?

I have a blinds that look like this (http://www.awardblinds.com/products/plantation-faux-wood.html)..that I got from Target
but the blinds are much too long. Is there any way to make adjustments or...
Replies: 1
Views: 780
Posted By coopns

Vermi...something type paint

Just moved in, the bathroom ceiling is peeling and someone mentioned the type of paint or the ceiling is verm...sounds like vermiculite but not. They said we could prime it with oil base then skim is...
06-13-08, 06:13 AM
Replies: 1
Views: 1,904
Posted By coopns

Garage Door...opens a bit then closes

Just moved in...

Looks like an older unit but works. Intermitently, I push a button to close the garage door and it begins to close, goes for about 3-4 seconds then opens back up. I sometimes have...
Replies: 3
Views: 831
Posted By coopns

So I could technically hide the junction box...

So I could technically hide the junction box behind the med. cabinet? Or, is there any way to make the connection dead?

Thanks for the help.
Replies: 3
Views: 831
Posted By coopns

Sconces to one light?

Just moved in...bathroom has to very old sconces. I would like to remove the sconces and put one light over mirror. I have the medicine cabinet out, so I can see/reach wires.

Can I re-route one...
Replies: 3
Views: 925
Posted By coopns

Could I just load up the tar around that area for...

Could I just load up the tar around that area for now? How long would that last? I will check the boot.

Thanks.
Replies: 3
Views: 925
Posted By coopns

Tar to cover leak?

Moving in to a new house, I see the shingles will need to be replaced very soon. On one wall, I see some water damage by a vent pipe in the roof, looks worn around it. Without replacing the shingles,...
Showing results 1 to 25 of 147
 


 
Forum Jump