Search: Posts Made By: Eddie2578
Showing results 1 to 7 of 7
Search took 0.01 seconds.
10-15-14, 08:04 AM
Replies: 3
Views: 600
Posted By Eddie2578

CAFCI Breakers

The panel is Murray, the electric suppler has Siemens CAFCI 20A that is the same as Murray, Will I have an inspection issue with it not being Murray in a Murray panel?
Also I have read & read on...
10-13-14, 05:59 PM
Replies: 3
Views: 600
Posted By Eddie2578

basement remodel

Just finished wiring all my Halo's & wall outlets in the basement remodel , going to use 2,separate 20 amp circuits. I have read that I need a AFCI or an CAFCI breaker for the breaker in my Murray...
10-04-14, 08:27 AM
Replies: 3
Views: 734
Posted By Eddie2578

steel stud boxes

Now that I'm done putting up all steel studs in my basement I'm ready to install the outlets. I've read use plastic boxes, use metal boxes, put them on the studs, put them on a 2X4 across the studs....
10-02-14, 06:17 AM
Replies: 8
Views: 979
Posted By Eddie2578

Ok Thank you. New line it will be

Ok Thank you. New line it will be
10-01-14, 05:34 AM
Replies: 8
Views: 979
Posted By Eddie2578

This one K&T line dropping in the basement...

This one K&T line dropping in the basement rafters is on a top of the stairs switch. It was tied to three other lights, that have been removed. I wanted to keep one light on the switch for going down...
09-30-14, 11:59 AM
Replies: 8
Views: 979
Posted By Eddie2578

Here is a picture of the wire. I have only 10" of...

Here is a picture of the wire. I have only 10" of it coming out of rafter.
Ed
39166
09-30-14, 09:45 AM
Replies: 8
Views: 979
Posted By Eddie2578

Basement Wiring

I am remodeling my basement replacing old ceiling with drywall.
It had 3 light's run off of old type wiring, dropped in center of basement rafters, then it was wrapped & taped to the 3 lights. It...
Showing results 1 to 7 of 7


 
Forum Jump