Search: Posts Made By: ms0517
Showing results 1 to 11 of 11
Search took 0.01 seconds.
12-12-11, 08:27 PM
Replies: 13
Views: 2,301
Posted By ms0517

I was afraid of that. Just don't have the money...

I was afraid of that. Just don't have the money for a new one now. Any suggestions when I do? This is a rental home with 3 people. Thanks.
12-12-11, 06:47 PM
Replies: 13
Views: 2,301
Posted By ms0517

Nah, did it right. Thanks.

Nah, did it right. Thanks.
12-12-11, 03:56 PM
Replies: 13
Views: 2,301
Posted By ms0517

The water is bad quality, high iron and hardness....

The water is bad quality, high iron and hardness. But the rotor/seals lasted for 5 years before first replacement, then less than a year this time.
12-12-11, 02:03 PM
Replies: 13
Views: 2,301
Posted By ms0517

Well it lasted until yesterday. Now the motor is...

Well it lasted until yesterday. Now the motor is binding up again. It still doesn't seem right that I would have to replace the rotor/seals again already. Anyone know if something else could be...
07-27-11, 09:45 AM
Replies: 13
Views: 2,301
Posted By ms0517

What if I put a thinner washer under the wave...

What if I put a thinner washer under the wave washer? Am I right though that I shouldn't be replacing the rotor/seals again in less than a year? Could there be something else happening that is...
07-25-11, 07:39 PM
Replies: 13
Views: 2,301
Posted By ms0517

Rotor and seal kit less than a year, removed wave washer bearing

I have a Whirlpool WHES40 softener. Replaced the rotor/seals about this time last year after motor started binding. All was well before it just started doing it again. Should this happen in less than...
Replies: 4
Views: 2,653
Posted By ms0517

Without sounding like an ass, I'm not really...

Without sounding like an ass, I'm not really trying to get technical here. My home has been without the return vents since I bought it about 5 years ago so it isn't anything critical. Just want to...
Replies: 4
Views: 2,653
Posted By ms0517

Return air pathway sizing?

My home is about 1500 sq ft with 3 bedrooms. The doors are undercut only about a 1/2". I am going to install some return air pathways above the doors to improve the circulation. I am looking at the...
04-23-10, 11:09 AM
Replies: 4
Views: 3,670
Posted By ms0517

I will try to get an image when I am home later....

I will try to get an image when I am home later. Thanks.
04-23-10, 10:13 AM
Replies: 4
Views: 3,670
Posted By ms0517

Sorry if I didn't explain it very well. It is a...

Sorry if I didn't explain it very well. It is a wall that ends in the middle of a room - it divides my kitchen and living room. It is 18" tile. Once I am finished, there will be a column left, a...
04-23-10, 12:23 AM
Replies: 4
Views: 3,670
Posted By ms0517

Tiling Around Column in the Middle of a Tile

I am knocking out about an 18" space in a partition wall and leaving about a 6"x6" column where the wall currently terminates in the middle of the room. The floor is already tiled. I will be able to...
Showing results 1 to 11 of 11


 
Forum Jump