Search: Posts Made By: JPearson1
Showing results 1 to 9 of 9
Search took 0.01 seconds.
Replies: 49
Views: 7,754
Posted By JPearson1

If you had an unsecured WiFi network, someone...

If you had an unsecured WiFi network, someone would easily be able to see the shared folder contents with the everyone permission selected. The everyone permission allows any user to access the...
Replies: 49
Views: 7,754
Posted By JPearson1

Using the right click menu and clicking sharing...

Using the right click menu and clicking sharing permissions took you to the same place as going to computer mgmt then shared folders. The only way all the shared folders would become visible is if...
Replies: 4
Views: 3,024
Posted By JPearson1

Some parts you can reuse from the old strut would...

Some parts you can reuse from the old strut would be: the bump stop, dust boot (if equipped), the factory spring perch, and any clips holding brake lines or ABS lines.
With that many miles it...
Replies: 24
Views: 23,100
Posted By JPearson1

While it comes down to personal preference, I...

While it comes down to personal preference, I would not recommend starting the engine while changing oil. All it takes is one main bearing to go dry and spin itself. Then you are looking at some...
Replies: 1
Views: 7,325
Posted By JPearson1

If you have changed your front pads, the rear...

If you have changed your front pads, the rear should be no problem for you. However there are a few minor differences. As you noted, there will be an ebrake cable connected to the caliper. They have...
Replies: 49
Views: 7,754
Posted By JPearson1

It could be a permission issue with the shared...

It could be a permission issue with the shared folders. Make sure you have "everyone" checked in the shared folder properties.
Replies: 35
Views: 20,406
Posted By JPearson1

Since you can hear the fuel pump priming and have...

Since you can hear the fuel pump priming and have pressure at the filter, that's a good sign as its getting power from the main relay. What I would recommend is testing for spark at the plugs. You...
07-02-11, 10:20 AM
Replies: 3
Views: 3,959
Posted By JPearson1

Our dryer has a 4 wire hook up. Our old one quit...

Our dryer has a 4 wire hook up. Our old one quit working so we bought a new (used) one that wasn't turning on either. After some looking at it, the dryer neutral was not hooked in the panel, and the...
07-01-11, 07:02 PM
Replies: 3
Views: 3,959
Posted By JPearson1

240v 20a 3-prong outlet wiring with a metal outlet box

We recently had a residential house rewired with a new drop and panel. I just found out the dryer was not hooked up correctly and so went to check the other 240v 3-prong outlet powering a large...
Showing results 1 to 9 of 9


 
Forum Jump