Search: Posts Made By: wrench191
Showing results 1 to 14 of 14
Search took 0.01 seconds.
Replies: 1
Views: 662
Posted By wrench191

Frigidaire compressor getting hot and shutting off

I have a Frigidaire side by side refrigirator.
Model no. FRS23LH5DSP. The compressor has been shuting off and not restarting unless I unplug for at least an hour. When it restarts it takes right...
Replies: 2
Views: 700
Posted By wrench191

At one time there was a recall for that. Just...

At one time there was a recall for that. Just lube the rubber boot at floorboard.
Replies: 6
Views: 15,947
Posted By wrench191

Sounds like they just said its all leaking to...

Sounds like they just said its all leaking to cover themselves. I would get someone to test the leak with dye light to see how bad leak is and where it first leaks from. That would be your main leak.
Replies: 1
Views: 1,092
Posted By wrench191

You leave a lot of things out. What motor? 4.0...

You leave a lot of things out. What motor? 4.0 inline 6 ? When you changed pcm, imoblizer.Did you program pcm to that vin? Did you program chip key?
Did you transfer secret key data?
Replies: 5
Views: 1,017
Posted By wrench191

I don't know if slime would work but the leak is...

I don't know if slime would work but the leak is in the bottom most of the time. Where it folds over.
Replies: 3
Views: 1,026
Posted By wrench191

F-150 are very sensitive to brake dust mostly...

F-150 are very sensitive to brake dust mostly when its humid or damp out they grab.Since you cleaned it is it better? Maybe the drums are out of round. Make sure the park brake is releasing ....
Replies: 18
Views: 5,507
Posted By wrench191

I would do what these guys have told you. But...

I would do what these guys have told you. But when I used to work on cars If you had a bad head gasket the complaint was heater don't work, gets hot sometimes and I cant seem to get the air bled out.
Replies: 3
Views: 1,057
Posted By wrench191

I found this to be easier than removing the belt...

I found this to be easier than removing the belt to prove the noise is coming from belt or pulleys. Shoot some baby powder on belt when running. This will stop noise for a while.
Replies: 10
Views: 2,281
Posted By wrench191

The egr is hard to change and they fail a lot. I...

The egr is hard to change and they fail a lot. I don't know what the dinging has to do with that. If a door is not closed properly the dinging will go away with speed.
Replies: 6
Views: 658
Posted By wrench191

Those oil senders fail a lot. If you don't hear...

Those oil senders fail a lot. If you don't hear the lifters at zero oil press. It is probably ok. Just to be on the safe side as you have been told check with manual gauge.
Replies: 5
Views: 779
Posted By wrench191

Try this

The ignition is controlled by the PCM. If you have a fuel tester check for proper press 40lbs engine not running, about 30lbs engine running. Also check for excessive leak down. The pump could be...
Replies: 7
Views: 4,290
Posted By wrench191

Stall on decell

There is an idle stepper motor that fails a lot on those cars and wont leave a code. When I replace it I also clean throttle body but you say you have. If you have a vacuum leak that can also do what...
Showing results 1 to 14 of 14


 
Forum Jump