Search: Posts Made By: md2002
Showing results 1 to 6 of 6
Search took 0.00 seconds.
10-21-19, 07:19 AM
Replies: 11
Views: 367
Posted By md2002

The deck is done, and this is off the original...

The deck is done, and this is off the original topic but.... I used composite decking and the temps were about 60 degrees when I installed the boards. I used a 1/8 gap for all the boards as suggested...
09-25-19, 08:04 AM
Replies: 11
Views: 367
Posted By md2002

I will be cutting the door but the ledger will...

I will be cutting the door but the ledger will still have 2 ends. The ledger will go across (blue lines) when the door is cut but I'll still have the 2 ends of the ledger (red arrows) that I need to...
09-25-19, 06:29 AM
Replies: 11
Views: 367
Posted By md2002

I'm going with the starter strip as you suggested...

I'm going with the starter strip as you suggested but what do I put on the end? I assume J channel? Also, because the J channel I was going to install takes up some space, the gap from the decking to...
09-23-19, 06:46 PM
Replies: 11
Views: 367
Posted By md2002

I have a tool like that. Are you saying to use a...

I have a tool like that. Are you saying to use a starter strip above the drip edge instead of the J channel strip?
09-23-19, 05:59 PM
Replies: 11
Views: 367
Posted By md2002

Ya sorry, I wasn't sure what the best approach...

Ya sorry, I wasn't sure what the best approach was. Usually you get a talking to if you post in the wrong forum so I figured this one belonged in the vinyl forum.

Will try the starter strip. I'd...
09-23-19, 05:12 PM
Replies: 11
Views: 367
Posted By md2002

Install J Channel when the butt together

I'm installing a small deck in from of my house. There is J channel around the door and I'll have J channel above the ledger which will come to the door and meet at 90 degrees. I've looked long and...
Showing results 1 to 6 of 6


 
Forum Jump