Search: Posts Made By: nixer
Showing results 1 to 18 of 18
Search took 0.01 seconds.
10-08-19, 07:40 PM
Replies: 1
Views: 104
Posted By nixer

murphy door

Hello,

I am thinking about putting in a murphy door and wondering if anyone has installed or has one with some general feedback?
Thanks
10-08-19, 07:33 PM
Replies: 3
Views: 210
Posted By nixer

hanging tapestry

Hello,

I am finishing my bar and have a tapestry I need to hang. Many may cringe at it, including my wife but its a original 70's dogs playing poker from a bar my dad owned. I had it hanging in...
Replies: 2
Views: 138
Posted By nixer

Correct that is what I meant and that's the...

Correct that is what I meant and that's the answer I was not hoping for.
I wanted to have that return right at the bottom of the stairs, but with wiring and switch boxes bewtween the studs I was...
Replies: 2
Views: 138
Posted By nixer

Wiring in return wall cavity

Hello,

I am finishing my basement and at the point of running supply and return vents. Am I okay to have wires in the same wall cavity as the return vent and does it matter if they run across or...
Replies: 3
Views: 144
Posted By nixer

and i can connect multiple lights with just the...

and i can connect multiple lights with just the 12/2 correct?
Thanks!
Replies: 2
Views: 158
Posted By nixer

smoke detector code question

not sure if this is the right spot for this...
I am finishing my basement and have split the room in 2, a laundry room and a bar. There is a hardwired smoke detector in the laundry room already. I...
09-11-19, 09:01 PM
Replies: 3
Views: 228
Posted By nixer

basement floor recommendations

Hello

Finishing off my basement and have been looking at flooring. Wondering what you all have done and any suggestions. I am not worried about flooding and its not a room that will be used...
Replies: 3
Views: 144
Posted By nixer

basement lighting questions

I am rewiring my basement and have a number of things I am trying to figure out.
The basement is all wired on the same circuit, I have split the basement into 2 rooms, a bar and a laundry room. It...
09-07-19, 06:58 AM
Replies: 5
Views: 247
Posted By nixer

Thanks for the advice. I do believe my best...

Thanks for the advice. I do believe my best option is to try to pull the top plate out. A much larger job than I want to deal with the walls are 12 ft and 20 ft. They also put up insulation and...
09-05-19, 09:17 PM
Replies: 5
Views: 247
Posted By nixer

framed basement walls not straight

Hello,

I am finishing a basement of a new to me house. When I moved in the exterior walls were framed and insulated. Now that I have started framing interior walls I have found that the...
08-27-19, 08:54 PM
Replies: 4
Views: 571
Posted By nixer

Thanks for the help. Just want to clarify...

Thanks for the help.

Just want to clarify something so I don't go to far before the rough in. I currently have all outlet wires ran and grounds pig tailed. I ran a new main line from the breaker...
Replies: 1
Views: 307
Posted By nixer

Cutting into existing return and supply

Hello,

I have a couple questions.
I have read that it is not a good idea to tap into an existing supply line as it will steal air from the original room, but is it okay or common to tap into a...
07-14-19, 08:09 PM
Replies: 4
Views: 571
Posted By nixer

Questions before electrical rough-in inspection

Hello,

i am getting ready for my rough in inspection and have a couple questions to make sure i pass the first time.
1. Do I need to have supply line ran and just not hooked up to breaker box or...
04-13-19, 08:31 PM
Replies: 5
Views: 339
Posted By nixer

Good call out thanks. I probably went over board...

Good call out thanks. I probably went over board on the outlets actually 11 total... Wont use them all but can never have enough.
Replies: 1
Views: 220
Posted By nixer

Basement ducting

Hello,

I am finishing a room in my basement about 20x14. I have to install supply and return in the room and hoping to install both in the ceiling about 15 ft apart. It is not a room that will...
04-11-19, 08:03 PM
Replies: 5
Views: 339
Posted By nixer

Thanks for the info! I was really hoping to not...

Thanks for the info! I was really hoping to not have the need to run a new line, but instead of risking it on the inspection should just get it done.
Thanks
04-10-19, 08:58 PM
Replies: 5
Views: 339
Posted By nixer

outlet in unfinished basement

Hello,
Starting running electrical in my basement. In the main room, opposite side of the utility room there is only 1 outlet which was installed during construction. It appears it isnt hooked up...
Replies: 0
Views: 245
Posted By nixer

thermo pan and new vent

Hello,

First time poster. I am finishing my basement and have a small section of thermo pan on the ceiling. I am wondering if anyone can give me direction on what supplies i need to install a...
Showing results 1 to 18 of 18


 
Forum Jump