Search: Posts Made By: Bud9051
Showing results 1 to 6 of 6
Search took 0.00 seconds.
Replies: 11
Views: 8,323
Posted By Bud9051

Suobs, the link above is basically the vent strip...

Suobs, the link above is basically the vent strip I used, although that picture shows a slight curl on the left and right flange. Mine were flat. I ran mine over the bottom of the soffit and used...
Replies: 11
Views: 8,323
Posted By Bud9051

Not sure what I have attached. 57059 ...

Not sure what I have attached.

57059

Yaa It made it. Now I have to write down how I did that.
Dinosaurs can't jump.

Bud

And here is the vent strip I covered the openings with:
Replies: 11
Views: 8,323
Posted By Bud9051

I have one section of truss tails where I covered...

I have one section of truss tails where I covered the bottom with 1/2" plywood and drilled 2-2" holes at each rafter bay. I cut between those holes to create an elongated slot. I then covered the...
Replies: 11
Views: 8,323
Posted By Bud9051

You will always have a pressurized attic when...

You will always have a pressurized attic when there is a temperature difference between inside and outside and so does your house. In winter there is a positive pressure at the top and a negative...
Replies: 11
Views: 8,323
Posted By Bud9051

The baffles provide space above them for air flow...

The baffles provide space above them for air flow (and critters) directly below the bottom of the roof. The tail portion of that baffle is a wind block to keep the incoming wind/air from going...
Replies: 11
Views: 8,323
Posted By Bud9051

On the front of my cape I installed continuous...

On the front of my cape I installed continuous vented vinyl soffits (12" wide) so had more than enough NFA. Before it went up into the vinyl channel I covered the entire bottom of the soffit area...
Showing results 1 to 6 of 6


 
Forum Jump