Search: Posts Made By: Keijo
Showing results 1 to 8 of 8
Search took 0.01 seconds.
Replies: 1
Views: 140
Posted By Keijo

Question Light fixture rotates but doesn't come off!

I've got an overhead light fixture in my bathroom and the light bulb needs to be replaced. The glass fixture rotates freely but won't come off. It's clearly not threaded, as I rotated it freely a...
Replies: 11
Views: 625
Posted By Keijo

In a situation where the sun or a cobweb...

In a situation where the sun or a cobweb interferes with the sensor, would the LED be shutting off? Or are you talking about a situation in which the sun or a cobweb interferes with the sensor...
Replies: 11
Views: 625
Posted By Keijo

After two weeks of not working, it abruptly...

After two weeks of not working, it abruptly started working. Does anyone have any clues what may be going on? Thanks!
Replies: 11
Views: 625
Posted By Keijo

Just to be sure I understand correctly, when you...

Just to be sure I understand correctly, when you say light is flashing, you mean the light I described in my OP - the lamp on the motor unit, which flashes 3-4 times after I get a failed attempt at...
Replies: 11
Views: 625
Posted By Keijo

Thanks for the response. The system is at least...

Thanks for the response. The system is at least 18 years old.

I'm having a difficult time understanding how it could be a sensor problem if the green LEDs are both on when unobstructed and turn...
Replies: 11
Views: 625
Posted By Keijo

Arrow Garage door goes up but won't go down - sensors are in alignment!

Garage door goes up but won't go down; Sensors are illuminated and both extremes of down force dial have been tried.

Model: Craftsman 139.53663SRT2

With the door in the up position or with the...
Replies: 3
Views: 3,201
Posted By Keijo

Where are the springs? On the rails? At the...

Where are the springs? On the rails? At the control unit?
Replies: 3
Views: 3,201
Posted By Keijo

Question Garage door won't open more than a couple inches

I've got a Sears Craftsmen garage door. It was working fine and then all of a sudden it would only open about two inches. I adjusted the tension to the highest setting hoping this would pull the...
Showing results 1 to 8 of 8


 
Forum Jump