Search: Posts Made By: rosesig
Showing results 1 to 23 of 23
Search took 0.01 seconds.
Replies: 1
Views: 1,549
Posted By rosesig

grout flagstone patio

i just built a flagstone patio. it sits on 4 inches of crusher and 2 inches of stone dust. someone suggested i use a new type of sand in the joints that when water is added hardens like a grout. it...
Replies: 1
Views: 777
Posted By rosesig

blue stone

i am building a blue stone patio. i have 4 inches of crushed stone down and tamped. i just put 1 inch of stone dust down. do i need to tamp the stone dust down? if yes should i use a hand tammper or...
Replies: 3
Views: 1,045
Posted By rosesig

washing a sand painted ceiling is a back breaker....

washing a sand painted ceiling is a back breaker. i am skipping this step and am just going to bin the hole room
Replies: 3
Views: 1,045
Posted By rosesig

soot on walls and ceiling

i (about:blank#) have soot on the walls and ceiling in my family room due to a poorly vented gas fireplace. the soot appears on all of the screw holes on the walls and on the joist in the ceiling....
Replies: 5
Views: 4,092
Posted By rosesig

fixed

the vanity top was also glued on . the cheap lowes vanity probably would fall apart if i tried to take the top off. i found a composite door trim kit at the home depot. very thin. i glued it to wall...
Replies: 5
Views: 4,092
Posted By rosesig

the back splash is granite and applied with a PL...

the back splash is granite and applied with a PL adhesive directly to the sheet rock. any thoughts on the best and least painful way to remove it?

thanks
Replies: 5
Views: 4,092
Posted By rosesig

draw hits door trim

I put a new vanity in my bathroom. I glued the backsplash against the wall so moving the vanity is not a pleasant option. The problem is the vanity draw hits the door trim. I need to shave a inch...
Replies: 1
Views: 824
Posted By rosesig

painting a bathroom

i need some painting advice for a full bathroom. this bathroom was gutted down to the studs with only the shower left installed.
i am getting ready to install Sheetrock (greenboard) and tape.
what...
Replies: 1
Views: 1,224
Posted By rosesig

spider cracks

my bathroom walls are pealing and developing spider cracks. it was painted 6 months ago. is it easier to replace the sheetrock or scrape and sand. any info would be greatly appreciated. i have posted...
Replies: 3
Views: 995
Posted By rosesig

patio ideas and planning

I am looking for free software to help me design a patio. Looking to do something with pavers. Any help would be appreciated. Thanks for your time.
Replies: 1
Views: 4,317
Posted By rosesig

how to cascading stairs

i want to build cascading stairs off a straigt side of my deck. want them to be 4 feet at deck level and 6 to 7 feet at ground level. can someone point me to plans for this or let me know how to...
Replies: 12
Views: 2,156
Posted By rosesig

Fasten Master Cortex

i decided to use these screws which work fairly well. i stripped about 20 of them. any thoughts on how to get those out? it is a square head.

thanks
Replies: 6
Views: 31,846
Posted By rosesig

trex spacing

i am installing trex decking and was wondering about the spacing in between the deck board. i would like to butt each trex board against each other (no gap) using tiger claw with no gap between the...
Replies: 2
Views: 768
Posted By rosesig

thanks there is a slider exiting the back of the...

thanks there is a slider exiting the back of the house 8 feet from door
Replies: 2
Views: 768
Posted By rosesig

removing door

i am removing a 30 inch door unit from the back of my house.(door is only 3 years old). I want to frame it in, do not need the exit anymore. do i have to remove the header or can i just put studs in...
05-12-09, 01:40 PM
Replies: 4
Views: 980
Posted By rosesig

hot tub

it has 20 on the side of the box. the top two on the right are empty.

thanks
05-11-09, 04:52 AM
Replies: 4
Views: 980
Posted By rosesig

wiring a hot tub

My house was built in 1972. I want to install a hot tub that runs on 220. The problem is my breaker panel is full and there is now space for a new circuit. I have two furnaces and two air conditions...
04-10-08, 04:28 AM
Replies: 4
Views: 1,123
Posted By rosesig

sorry all new to me. this link should work ...

sorry all new to me. this link should work

http://s283.photobucket.com/albums/kk293/rosesig65/?mediafilter=images
04-09-08, 04:45 PM
Replies: 4
Views: 1,123
Posted By rosesig

crack ceiling paint

i had water damage to me ceiling which caused the paint to crack. is there anyway to glue it and repaint? i dont want to use joint compond because of the swirl design in the ceiling. i dont know how...
04-02-08, 12:51 PM
Replies: 8
Views: 3,069
Posted By rosesig

will not let me attach photos

will not let me attach photos
04-02-08, 09:03 AM
Replies: 8
Views: 3,069
Posted By rosesig

thanks that seems like the correct thing to do....

thanks that seems like the correct thing to do. like i said the ceiling has some sort of rough swirl on it. it looks like it has sand in it. any idea on how to creat this swirl look so i can match...
04-01-08, 04:23 AM
Replies: 8
Views: 3,069
Posted By rosesig

i misspoke. it is painted sheet rock that is...

i misspoke. it is painted sheet rock that is peeling. i believe it is just paint. i will try the glue and 2x4 trick. thanks
03-31-08, 08:11 AM
Replies: 8
Views: 3,069
Posted By rosesig

ceiling plaster peeling

My ceiling received minor water damage and the plaster cracked. I was wondering if I could just somehow glue it back in place. It is about a 3 inch crack. The ceiling is hard to plaster because it...
Showing results 1 to 23 of 23


 
Forum Jump