Search: Posts Made By: TCStuckey3
Showing results 1 to 7 of 7
Search took 0.01 seconds.
Replies: 5
Views: 3,484
Posted By TCStuckey3

Thanks for the reply. There are no...

Thanks for the reply.

There are no receptacles on the circuit. There is a second master bedroom receptacle circuit on an arc fault breaker. The previous owner built the house himself (I mean he...
Replies: 5
Views: 3,484
Posted By TCStuckey3

Thanks for the reply, pcboss. The circuit is...

Thanks for the reply, pcboss.

The circuit is a 15 amp circuit (the breaker is a half-size breaker - an "A" or "B" breaker, if you will. Don't know if that matters). It has the following loads on...
06-17-08, 10:19 AM
Replies: 8
Views: 5,891
Posted By TCStuckey3

Thanks for the help. That website is very...

Thanks for the help. That website is very good... just what I needed. In answer to twelvepole, 99% of the thinset is still on the slab. The tile bottoms are pretty clean.

I appreciate...
Replies: 5
Views: 3,484
Posted By TCStuckey3

Adding recessed lighting to bedroom circuit

Hey, Guys! I am planning to add some recessed lighting to my bedroom and I want to run the plan by y'all to make sure I don't blow anything up.

The bedroom light circuit goes to a 3 gang wall box...
06-16-08, 04:36 PM
Replies: 8
Views: 5,891
Posted By TCStuckey3

Thanks for the responses, guys! I don't know...

Thanks for the responses, guys!

I don't know if there are movement joints. How would I know this? Would it be very obvious? Where would I look?

No direct sunlight. No idea about the slab...
06-15-08, 10:03 PM
Replies: 8
Views: 5,891
Posted By TCStuckey3

Question Tile raising up off floor

Hello,

Thanks for your time. Last week a loud cracking noise started ringing through our kitchen and a few minutes later the ceramic tile starting cracking and raising up off the floor. The tile...
10-24-07, 01:40 PM
Replies: 1
Views: 885
Posted By TCStuckey3

Question Installing gas cooktop

Hello. I am attempting to replace an electric cooktop with a gas model. There is a gas pipe stubbed out in the proper place beneath the cutout, but it only comes out of the wall a few inches and is...
Showing results 1 to 7 of 7


 
Forum Jump