Search: Posts Made By: MARILYN69
Showing results 1 to 5 of 5
Search took 0.01 seconds.
Replies: 1
Views: 2,161
Posted By MARILYN69

Homelite z3850b chainsaw..

I have a homelite 3850b chainsaw and need to know where the hose to the gas tank attaches... Both the hose to the gas tank and the hose to the primer pump are not attached to the carb... The upper...
Replies: 5
Views: 816
Posted By MARILYN69

Separate drives..

You may find out that your 40gb drive is going bad.. Did you run a chkdsk on it to see if it found any problems? I would try running that to see if there are issues with the drive. I would hate to...
Replies: 3
Views: 5,297
Posted By MARILYN69

Homelite Chainsaw..

The only thing on the tag was that carb was adjusted.... The engine does start and runs good, but it will not Idle at ALL. As soon as you let off the trigger, it dies right now.... I read on...
Replies: 2
Views: 571
Posted By MARILYN69

Install..

Formatting the hard drive and then installing 98 from the CD will give you a clean install. If the PC will not boot from a CD, I believe 98 also comes with a floppy disk that can be used to start...
Replies: 3
Views: 5,297
Posted By MARILYN69

Smile Homelite 3850 Chainsaw carb adjustment

Can anyone tell me what the initial settings are for the L&H carb screws?

Also, Can you provide instructions on how to tune the carb once you set the L&H screws to the initial settings?

My...
Showing results 1 to 5 of 5


 
Forum Jump