Search: Posts Made By: joe384
Showing results 1 to 8 of 8
Search took 0.00 seconds.
Replies: 25
Views: 6,351
Posted By joe384

Thanks, Grady. Would you use pipe dope, or teflon...

Thanks, Grady. Would you use pipe dope, or teflon tape?
Replies: 25
Views: 6,351
Posted By joe384

I installed the new tankless coil a few weeks...

I installed the new tankless coil a few weeks ago. The new tankless coil came with steel studs and brass nuts. I torqued the nuts gradually to 20 ft-lb over a period of about two weeks.

Now it's...
Replies: 25
Views: 6,351
Posted By joe384

Thanks, Grady. Is it Permatex 81878? Permatex...

Thanks, Grady. Is it Permatex 81878?
Permatex 81878 | Liquid Gasketing & Silicone Sealants (http://www.all-spec.com/products/81878.html)
Replies: 25
Views: 6,351
Posted By joe384

I'm ready to install the new tankless coil. It...

I'm ready to install the new tankless coil. It came with a rubber gasket. No instructions were included. Should I put any kind of sealant on the gasket? I thought a saw a forum posting somewhere that...
Replies: 25
Views: 6,351
Posted By joe384

Great information! Thanks to everyone!

Great information! Thanks to everyone!
Replies: 25
Views: 6,351
Posted By joe384

Would Permatex 80078 Anti-Seize Lubricant be...

Would Permatex 80078 Anti-Seize Lubricant be okay?

I'm nervous about using the existing 3/8-16 holes because I'm afraid the bolts might not hold well. Is it hard to drill and and tap bolt holes in...
Replies: 25
Views: 6,351
Posted By joe384

Thanks. Advice (spelled correctly this time)...

Thanks. Advice (spelled correctly this time) appreciated!

How much torque should be applied when tightening the bolts?
Replies: 25
Views: 6,351
Posted By joe384

Tankless Coil - Broken Bolts

While removing the tankless coil from my Weil-McLain B-68 boiler, five of the six bolts broke off. The boiler was installed in 1988. The bolts are 3/8-16 3/4". I will need to drill out the bolts and...
Showing results 1 to 8 of 8


 
Forum Jump